- 您现在的位置：买卖IC网 > PDF目录16833 > KSZ8842-PMQL-EVAL (Micrel Inc)BOARD EVALUATION KSZ8842-PMQL PDF资料下载
参数资料
| 型号： | KSZ8842-PMQL-EVAL |
| 厂商： | Micrel Inc |
| 文件页数： | 34/119页 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION KSZ8842-PMQL |
| 标准包装： | 1 |
| 主要目的： | 接口，以太网控制器（PHY 和 MAC） |
| 嵌入式： | 否 |
| 已用 IC / 零件： | KSZ8842-PMQL |
| 主要属性： | 2 个端口，100BASE-TX/10BASE-T |
| 次要属性： | 8/16 位接口，LinkMD 线缆诊断 |
| 已供物品： | 板 |
| 产品目录页面： | 1114 (CN2011-ZH PDF) |
| 相关产品： | 576-3348-ND - IC ETHERNET SW 2PORT 100-LFBGA 576-3089-ND - IC ETHERNT SW 2PORT PCI 100LFBGA 576-2121-ND - IC ETHERNET SW 2PORT PCI 128PQFP 576-1513-5-ND - IC SWITCH 10/100 32BIT 128-PQFP |
| 其它名称： | 576-1636 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页当前第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页
Micrel, Inc.
KSZ8842-PMQL/PMBL
October 2007
21
M9999-100207-1.5
optimization. This is an ongoing process and self-adjusts against environmental changes such as temperature
variations.
Next, the equalized signal goes through a DC restoration and data conversion block. The DC restoration circuit is used
to compensate for the effect of baseline wander and to improve the dynamic range. The differential data conversion
circuit converts the MLT3 format back to NRZI. The slicing threshold is also adaptive.
The clock recovery circuit extracts the 125MHz clock from the edges of the NRZI signal. This recovered clock is then
used to convert the NRZI signal into the NRZ format. This signal is sent through the de-scrambler followed by the 4B/5B
decoder. Finally, the NRZ serial data is converted to the MII format and provided as the input data to the MAC.
PLL Clock Synthesizer (Recovery)
The internal PLL clock synthesizer generates 125MHz, 62.5MHz, 41.66MHz, and 25MHz clocks by setting the on-chip
bus speed control register OBCR for KSZ8842-PMQL/PMBL system timing. These internal clocks are generated from
an external 25MHz crystal or oscillator.
Note: Default setting is 25MHz in OBCR register, recommends the software driver to set it to 125MHz for best
performance.
Scrambler/De-scrambler (100BASE-TX Only)
The purpose of the scrambler is to spread the power spectrum of the signal to reduce electromagnetic interference
(EMI) and baseline wander. Transmitted data is scrambled through the use of an 11-bit wide linear feedback shift
register (LFSR). The scrambler generates a 2047-bit non-repetitive sequence, and the receiver then de-scrambles the
incoming data stream using the same sequence as at the transmitter.
10BASE-T Transmit
The 10BASE-T driver is incorporated with the 100BASE-TX driver to allow for transmission using the same magnetic.
They are internally wave-shaped and pre-emphasized into outputs with typical 2.3V amplitude. The harmonic contents
are at least 27dB below the fundamental frequency when driven by an all-ones Manchester-encoded signal.
10BASE-T Receive
On the receive side, input buffers and level detecting squelch circuits are employed. A differential input receiver circuit
and a phase-locked loop (PLL) perform the decoding function. The Manchester-encoded data stream is separated into
clock signal and NRZ data. A squelch circuit rejects signals with levels less than 400mV or with short pulse widths to
prevent noise at the RXP-or-RXM input from falsely triggering the decoder. When the input exceeds the squelch limit,
the PLL locks onto the incoming signal and the KSZ8842-PMQL/PMBL decodes a data frame. The receiver clock is
maintained active during idle periods in between data reception.
Power Management
The KSZ8842-PMQL/PMBL features a per port power-down mode. To save power, the user can power-down a port
that is not in use by setting bit 11 in either P1CR4 or P1MBCR register for port 1, and set bit 11 in either P2CR4 or
P2MBCR register for port 2. To bring the port back up, reset bit 11 in these registers.
In addition, there is a full switch power-down mode by PWRDN pin/ball 36. When this pin/ball is pulled-down, the entire
chip powers down. Transitioning this pin/ball from pull-down to pull-up results in a power up and chip reset.
MDI/MDI-X Auto Crossover
To eliminate the need for crossover cables between similar devices, the KSZ8842-PMQL/PMBL supports HP-Auto
MDI/MDI-X and IEEE 802.3u standard MDI/MDI-X auto crossover. HP-Auto MDI/MDI-X is the default.
The auto-sense function detects remote transmit and receive pairs and correctly assigns the transmit and receive pairs
for the KSZ8842-PMQL/PMBL device. This feature is extremely useful when end users are unaware of cable types in
addition to saving on an additional uplink configuration connection. The auto-crossover feature can be disabled through
the port control registers.
相关PDF资料 |
PDF描述 |
|---|---|
| V24C8C100B | CONVERTER MOD DC/DC 8V 100W |
| 202K185-25/225-0 | BOOT MOLDED |
| HMM06DRKH | CONN EDGECARD 12POS DIP .156 SLD |
| 202D274-4-61/42-0 | BOOT MOLDED |
| SFSD-30-28-H-10.00-SR | CABLE ASSY SOCKET 60POS 28AWG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8842-PMQLI | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + 32-bit/33MHz PCI bus interface, Ind Temp (Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8851-16MLL | 功能描述:以太网 IC Single Ethernet Port + Generic (16-bit) Bus Interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8851-16MLL TR | 功能描述:以太网 IC Single Ethernet Port + Generic (16-bit) Bus Interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8851-16MLL-EVAL | 功能描述:以太网开发工具 Single Ethernet Port + Generic (16-bit) Bus Interface(Lead Free) Eval Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8851-16MLL-EVAL | 制造商:Micrel Inc 功能描述:BOARD EVALUATION FOR KSZ8851-16MLL |
发布紧急采购，3分钟左右您将得到回复。