参数资料
型号: LMK04010BISQ/NOPB
厂商: National Semiconductor
文件页数: 18/65页
文件大小: 0K
描述: IC CLOCK CONDITIONER W/PLL 48LLP
标准包装: 1,000
系列: PowerWise®
类型: 时钟调节器
PLL:
输入: LVCMOS
输出: 2VPECL,LVPECL
电路数: 1
比率 - 输入:输出: 2:5
差分 - 输入:输出: 是/是
频率 - 最大: 1.296GHz
除法器/乘法器: 是/是
电源电压: 3.15 V ~ 3.45 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 48-WFQFN 裸露焊盘
供应商设备封装: 48-LLP(7x7)
包装: 带卷 (TR)
其它名称: LMK04010BISQ
Distribution
Path
SYNC*
CLKout0
CLKout1
CLKout2
SNOSAZ8J – SEPTEMBER 2008 – REVISED SEPTEMBER 2011
Global Clock Output Synchronization (Sync*)
The SYNC* input is used to synchronize the active clock outputs. When SYNC* is held in a logic low state, the
outputs are also held in a logic low state. When SYNC* goes high, the clock outputs are activated and will
transition to a high state simultaneously with one another.
SYNC* must be held low for greater than one clock cycle of the Clock Distribution Path. After this low event has
been registered, the outputs will not reflect the low state for four more cycles. Similarly after SYNC* becomes
high, the outputs will simultaneously transition high after four Clock Distribution Path cycles have passed. See
Figure 11 for further detail.
Figure 11. Clock Output synchronization using the SYNC* pin
Global Output Enable and Lock Detect
Each Clock Output Channel may be either enabled or put into a high impedance state via the Clock Output
Enable control bit (one for each channel). Each output enable control bit is gated with the Global Output Enable
input pin (GOE). The GOE pin provides an internal pull-up so that if it is un-terminated externally, then the clock
output states are determined by the Clock Channel Output Enable Register bits. All clock outputs can be
disabled simultaneously if the GOE pin is pulled low by an external signal.
Table 2. Clock Output Control
CLKoutX
EN_CLKout
CLKoutX Output State
GOE pin
_EN bit
_Global bit
1
Low
Don't care
0
Don't care
Off
0
Don't care
Off
1
High / No Connect
Enabled
The Lock Detect (LD) signal can be connected to the GOE pin in which case all outputs are disabled
automatically if the synthesizer is not locked. See EN_CLKoutX: Clock Channel Output Enable and also System
Level Diagram for actual implementation details.
The Lock Detect (LD) pin can be programmed to output a ‘High’ when both PLL1 and PLL2 are locked, or only
when PLL1 is locked or only when PLL2 is locked.
FUNCTIONAL DESCRIPTION
Architectural Overview
The LMK040xx chip consists of two high performance synthesizer blocks (Phase Locked Loop, internal
VCO/VCO Divider, and loop filter), source selection, distribution system, and independent clock output channels.
The Phase Frequency Detector in PLL1 compares the divided (R Divider 1) system clock signal from the
selected CLKinX and CLKinX* input with the divided (N Divider 1) output of the external VCXO attached to the
PLL2 OSCin port. The external loop filter for PLL1 should be narrow to provide an ultra clean reference clock
from the external VCXO to the OSCin/OSCin* pins for PLL2.
Copyright 2008–2011, Texas Instruments Incorporated
25
相关PDF资料
PDF描述
LMV393MUTAG IC OP AMP DUAL GP LV LV 8-UDFN
LMX339HASD+T IC COMPARATOR GP QUAD 14-SOIC
LT1011AIS8#TRPBF IC VOLTAGE COMPARATOR 5V 8-SOIC
LT1016IS8#TRPBF IC COMPARATOR 10NS HI-SPD 8-SOIC
LT1017IS8#TRPBF IC COMPARATOR MICRPWR DUAL 8SOIC
相关代理商/技术参数
参数描述
LMK04010BISQX 制造商:NSC 制造商全称:National Semiconductor 功能描述:Low-Noise Clock Jitter Cleaner with Cascaded PLLs
LMK04010BISQX/NOPB 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel
LMK04011BISQ 制造商:Texas Instruments 功能描述:Clock Conditioner 48-Pin LLP EP T/R
LMK04011BISQ/NOPB 功能描述:时钟合成器/抖动清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 输出端数量: 输出电平: 最大输出频率: 输入电平: 最大输入频率:6.1 GHz 电源电压-最大:3.3 V 电源电压-最小:2.7 V 封装 / 箱体:TSSOP-28 封装:Reel
LMK04011BISQE 制造商:Texas Instruments 功能描述:Clock Conditioner 48-Pin LLP EP T/R 制造商:Texas Instruments 功能描述:PRECISION CLOCK CONDITIONER, 48LLP