参数资料
型号: NCP5332ADWR2
厂商: ON Semiconductor
文件页数: 23/30页
文件大小: 0K
描述: IC CTRLR BUCK 2PH STEPDWN 28SOIC
产品变化通告: Product Obsolescence 11/Feb/2009
标准包装: 1
应用: 控制器,高性能处理器
输入电压: 4.5 V ~ 14 V
输出数: 2
输出电压: 可调
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 28-SOIC(0.295",7.50mm 宽)
供应商设备封装: 28-SOIC
包装: 剪切带 (CT)
其它名称: NCP5332ADWR2OSCT
NCP5332A
For resistive current sensing, choose the current sense
network (R CSn , C CSn , n = 1 or 2) to satisfy
RCSn @ CCSn + Lo (Rsense)
(33)
This will provide an adequate starting point for R CSn and
C CSn . After the converter is constructed, the value of R CSn
(and/or C CSn ) should be fine?tuned in the lab by observing
the V DRP signal during a step change in load current. The
R CSn ? C CSn network should be tuned to provide a
“square?wave” at the V DRP output pin with maximum rise
time and minimal overshoot as shown in Figure 22.
Equation 32 will be most accurate for better iron powder
core material (such as the ?8 from Micrometals). This
Figure 20. V DRP Tuning Waveforms. The RC Time
Constant of the Current Sense Network Is Too Long
(Slow): V DRP and V OUT Respond Too Slowly.
material is very consistent with DC current and frequency.
Less expensive core materials (such as the ?52 from
Micrometals) change their characteristics with DC current,
AC flux density, and frequency. This material will yield
acceptable converter performance if the current sense time
constant is set lower (longer) than anticipated. As a rule of
thumb, use approximately twice the resistance (R CSn ) or
twice the capacitance (C CSn ) when using the less expensive
core material.
8. Error Amplifier Tuning
After the steady?state (static) AVP has been set and the
current sense network has been optimized the Error
Amplifier must be tuned. Basically, the gain of the Error
Amplifier should be adjusted to provide an acceptable
transient response by increasing or decreasing the Error
Amplifier ’s feedback capacitor (C AMP in the Applications
Diagram). The bandwidth of the control loop will vary
directly with the gain of the error amplifier.
Figure 21. V DRP Tuning Waveforms. The RC Time
Constant of the Current Sense Network Is Too Short
(Fast): V DRP and V OUT Both Overshoot.
Figure 23. The Value of C AMP Is Too High and the
Loop Gain/Bandwidth Too Low. COMP Slews Too
Slowly Which Results in Overshoot in V OUT .
Figure 22. V DRP Tuning Waveforms. The RC Time
Constant of the Current Sense Network Is Optimal:
V DRP and V OUT Respond to the Load Current Quickly
Without Overshooting.
If C AMP is too large the loop gain/bandwidth will be low,
the COMP pin will slew too slowly, and the output voltage
will overshoot as shown in Figure 23. On the other hand, if
C AMP is too small the loop gain/bandwidth will be high, the
COMP pin will slew very quickly and overshoot. Integrator
http://onsemi.com
23
相关PDF资料
PDF描述
X4283PI-2.7A IC SUPERVISOR CPU 128K EE 8-DIP
GMC26DRYI-S13 CONN EDGECARD 52POS .100 EXTEND
X4323V8-2.7 IC SUPERVISOR CPU 32K EE 8-TSSOP
HMM24DRYH-S13 CONN EDGECARD 48POS .156 EXTEND
NCP5331FTR2 IC CTRLR BUCK 2PH PWM DRV 32LQFP
相关代理商/技术参数
参数描述
NCP5338MNR2G 制造商:ON Semiconductor 功能描述:INTEGRATED DRIVER AND MOS - Tape and Reel 制造商:ON Semiconductor 功能描述:INTEGRATED DRIVER AND MOS - Cut TR (SOS) 制造商:ON Semiconductor 功能描述:REEL / INTEGRATED DRIVER AND MOS 制造商:ON Semiconductor 功能描述:Integrated Driver and MOSFET
NCP5351 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:4 A Synchronous Buck Power MOSFET Driver
NCP5351/D 制造商:未知厂家 制造商全称:未知厂家 功能描述:4A Synchronous Buck Power Mosfet Driver
NCP5351D 功能描述:功率驱动器IC 5V 4A Dual MOSFET RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
NCP5351DG 功能描述:功率驱动器IC 5V 4A Dual MOSFET RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube