参数资料
型号: SPD6729QCE
厂商: INTEL CORP
元件分类: 总线控制器
英文描述: PCMCIA BUS CONTROLLER, PQFP208
封装: MQFP-208
文件页数: 34/116页
文件大小: 1442K
代理商: SPD6729QCE
PD6729 — PCI-to-PC Card (PCMCIA) Controller
24
Datasheet
Having five memory windows per socket allows a memory-type card to be accessed through four
memory windows programmed for common memory access, (allowing PC-type expanded-
memory-style management), leaving the fifth memory window available to be programmed to
access the card’s attribute memory without disrupting the common memory in use.
Each memory window has several programming options, including:
Each I/O window also has several programming options, including:
Memory Window Option
Description
Enable
Each of the five memory windows can be individually enabled. Disabled windows are not
responded to.
Start Address
This is the start address of the memory window within the selected 16-Mbyte page of PCI
memory. The start address can be programmed to reside on any 4-Kbyte boundary within the
programmed page of PCI memory.
End Address
This is the end address of the memory window within the selected 16-Mbyte page of PCI
memory. The end address can be programmed to reside on any 4-Kbyte boundary within the
programmed page of PCI memory. Only memory accesses between the start and end address
are responded to.
Offset Address
The offset address is added to the PCI address to determine the address for accessing the
PCMCIA card. This allows the addresses in the PCMCIA address space to be different from the
PCI address space.
Upper Address
The upper memory address specifies a 16-Mbyte page of PCI memory.
Timing
The timing of accesses (Setup/Command/Recovery) can be set by either of two timing register
sets: Timer Set 0 or Timer Set 1.
Register Access Setting
The -REG pin can be enabled on a per-window basis so that any of the windows can be used for
accessing attribute memory.
Write Protect
If the window is programmed to be write-protected, then writes to the memory window are
ignored (reads are still performed normally).
I/O Window Option
Description
Enable
Each of the two I/O windows can be individually enabled.
Start Address
The start address of the window is programmable on single-byte boundaries from 0 to 64
Kbytes.
End Address
The end address of the window is also programmable on single-byte boundaries from 0 to 64
Kbytes.
Offset Address
The offset address is added to the PCI address to determine the address for accessing the
PCMCIA card.
Auto Size
The size of accesses can be set automatically, based on the PCMCIA -IOIS16 signal.
Data Size
The size of accesses can be set manually to either 8 or 16 bits, overriding the Auto Size option.
Timing
The timing of accesses (Setup/Command/Recovery) can be set by either of two timing register
sets: Timer Set 0 or Timer Set 1.
相关PDF资料
PDF描述
SPEAR-09-B042 1 CHANNEL(S), 100M bps, I2C BUS CONTROLLER, PBGA289
SPEAR300-2 32-BIT, FLASH, 333 MHz, RISC MICROCONTROLLER, PBGA289
SPL505YC264ATT PROC SPECIFIC CLOCK GENERATOR, PDSO64
SPL505YC264BT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64
SPL505YC264BT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64
相关代理商/技术参数
参数描述
SPD6730QCB 制造商:Rochester Electronics LLC 功能描述:- Bulk
SPD6832QCB 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述:
SPD73 制造商:未知厂家 制造商全称:未知厂家 功能描述:Shielded Surface Mount Inductors
SPD73-103M 功能描述:固定电感器 10uH 20% .067ohm Shield Choke SMT Pwr RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm
SPD73-103MTR 功能描述:固定电感器 10 UH 20% RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm