- 您现在的位置：买卖IC网 > PDF目录98141 > SPD6729QCE (INTEL CORP) PCMCIA BUS CONTROLLER, PQFP208 PDF资料下载
参数资料
| 型号： | SPD6729QCE |
| 厂商： | INTEL CORP |
| 元件分类： | 总线控制器 |
| 英文描述： | PCMCIA BUS CONTROLLER, PQFP208 |
| 封装： | MQFP-208 |
| 文件页数： | 39/116页 |
| 文件大小： | 1442K |
| 代理商： | SPD6729QCE |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页当前第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页
PCI-to-PC Card (PCMCIA) Controller — PD6729
Datasheet
29
PCMCIA cards with differing I/O functionalities to be connected to appropriate non-conflicting
IRQ locations, the PD6729 can steer the interrupt signal from a PCMCIA card to any one of the ten
different hardware interrupt lines.
For some I/O-type cards, software is written so that IRQ interrupts can be shared. The PD6729
contains unique logic that allows IRQ-type interrupts to be shared under software control. This is
accomplished by programming the PD6729 to alternately pulse and then three-state the desired
interrupt pin, which has been programmed as an IRQ-type output. This unique IRQ interrupt
sharing technique can be controlled through software so that systems incapable of IRQ sharing
have no loss of functionality.
3.1.4.4
Alternate Functions of Interrupt Pins
The PD6729 has two dual-function interrupt pins: IRQ14/EXT_CLK and IRQ15/RI_OUT*. In
their default modes, these pins indicate interrupt requests IRQ14 and IRQ15.
IRQ14/EXT_CLK can alternately be configured as an external clock input (EXT_CLK). When
configured in External Clock mode by programming Misc Control 2 register bit 0 to a ‘1’, IRQ14/
EXT_CLK acts as a clock input, bringing in an external clock that drives the PD6729 circuitry
whenever the PCI bus is inactive.
Similarly, IRQ15/RI_OUT* can alternately be configured to function as a ring indicator output
(RI_OUT*) to an 80360-type chip set’s -RI input. When configured in Ring Indicate mode by
programming Misc Control 2 register bit 7 to a ‘1’, outputs from a PCMCIA I/O card’s -STSCHG
pin are passed through to the IRQ15/RI_OUT* pin of the PD6729.
Note:
Interrupt and General Control register bits 5 and 7 must be set to ‘1’s for a socket interface to
accept an -RI input.
3.1.5
PD6729 Power Management
To provide the longest possible battery life, the PD6729 provides many power management
features, including Low-power Dynamic mode, Suspend mode, and control of PCMCIA socket
power.
Low-power Dynamic mode is transparent to the PCI bus. After reset, the PD6729 is configured for
Low-power Dynamic mode. This mode can be turned off by setting Misc Control 2 register, bit 1
to a ‘0’. When in Low-power Dynamic mode, periods of inactivity (no activity on the PCMCIA bus
and system accesses to chip registers or inserted cards are no longer being performed) cause the
PD6729 to enter a low-power state where the clock is turned off to most of the chip and the
PCMCIA address and data lines are set to a static value. VCC and VPP power to the card is left
unchanged. When there is activity present on the PCMCIA bus, or the system accesses PD6729
registers, or PCMCIA cards are inserted or removed from the socket, the PD6729 enters its active
state, services the transaction, and then returns to its low-power state.
A Suspend mode can also be programmed. The PD6729 Suspend mode is the chip’s lowest power
mode. The PD6729 is put into Suspend mode by setting the Misc Control 2 register, bit 2 to a ‘1’.
In Suspend mode, all the internal clocks are turned off, and only read/write access to the PCI-
Configuration registers, read/write access of the Index register, and write access to the Misc
Control 2 register is supported. All accesses to the PCMCIA cards are ignored when in Suspend
mode. VCC and VPP power to the card is left unchanged (the system power management software is
responsible for turning off power to the socket and entering Suspend mode). Interrupts are passed
through to the processor when in Suspend mode. To exit Suspend mode, the Misc Control 2
register bit 2 must be reset to a ‘0’.
相关PDF资料 |
PDF描述 |
|---|---|
| SPEAR-09-B042 | 1 CHANNEL(S), 100M bps, I2C BUS CONTROLLER, PBGA289 |
| SPEAR300-2 | 32-BIT, FLASH, 333 MHz, RISC MICROCONTROLLER, PBGA289 |
| SPL505YC264ATT | PROC SPECIFIC CLOCK GENERATOR, PDSO64 |
| SPL505YC264BT | 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64 |
| SPL505YC264BT | 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SPD6730QCB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SPD6832QCB | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述: |
| SPD73 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Shielded Surface Mount Inductors |
| SPD73-103M | 功能描述:固定电感器 10uH 20% .067ohm Shield Choke SMT Pwr RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| SPD73-103MTR | 功能描述:固定电感器 10 UH 20% RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
发布紧急采购，3分钟左右您将得到回复。