参数资料
型号: ST72774S9T1/XXX
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP44
封装: TQFP-44
文件页数: 18/144页
文件大小: 1280K
代理商: ST72774S9T1/XXX
ST72774/ST727754/ST72734
114/144
DDC INTERFACE (Cont’d)
DDC1/2B CONTROL REGISTER (DCR)
Read / Write
Reset Value: 0000 0000 (00h)
Bit 7 = Reserved.
Forced by hardware to 0.
Bit 5 = EDF
End of Download interrupt Flag.
This bit is set by hardware and cleared by
software.
0: Download not started or not completed yet.
1: Download completed. Last byte of data struc-
ture (relative address 7Fh or FFh) has been
stored in RAM.
Bit 4 = EDE
End of Download interrupt Enable.
This bit is set and cleared by software.
0: Interrupt disabled.
1: A DDC1/2B interrupt is generated if EDF bit is
set.
Bits 6, 3:2 = CF[2:0]
Configuration bits.
These bits are set and cleared by software only
when the peripheral is disabled (HWPE = 0). They
define which EDID structure version is used and
which Device Addresses are recognized as shown
in the following table:
Bit 1 = WP
Write Protect.
This bit is set and cleared by software.
0: Enable writes to the RAM.
1: Disable DMA write transfers and protect the
RAM content. CPU writes to the RAM are not
affected.
Bit 0= HWPE
Peripheral Enable.
This bit is set and cleared by software.
0: Release the SDA port pin and ignore Vsync
and SCL port pins. The other bits of the DCR
and the content of the AHR are left un-
changed.
1: Enable the DDC Interface and respond to the
DDC1/DDC2B protocol.
ADDRESS POINTER HIGH REGISTER (AHR)
Read / Write
Reset Value: see Register Map
AHR contains the 8 MSB’s of the 16-bit address
pointer. It therefore defines the location of the 256-
byte block containing the data structure within the
CPU address space.
Note: AHR0 is ignored when CF[1:0] = 10 (P&D+ v2
mode) to allow non-overlapping 128-byte and 256-
byte data structures.
70
0
CF2
EDF
EDE
CF1
CF0
WP
HWPE
70
MSB
LSB
CF[2:0] Bit
Values
EDID version used
DDC1 Mode support / Transition Mode support
DDC2B Addresses Recognized
000
DDC v2
Yes (128b EDID) / Yes
128b-EDID
@A0h/A1h
001
P&D
No
256b-EDID
@ A2h/A3h
010
v2 + P&D
Yes (128b EDID) / Yes
128b-EDID
@A0h/A1h
256b-EDID
@ A2h/A3h
011
FPDI-2
No
256b-EDID
@ A6h/A7h
100
DDC v2
No
128b-EDID
@A0h/A1h
101
Reserved
d sd
110
v2 + P&D
No
128b-EDID
@A0h/A1h
256b-EDID
@ A2h/A3h
111
Reserved
d sd
相关PDF资料
PDF描述
ST72E734J6D0 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CDIP42
ST72T774S9T1 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP44
ST7294C6B6 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP28
ST72T94C6M6 8-BIT, OTPROM, MICROCONTROLLER, PDSO28
ST72C171K2B6 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDIP32
相关代理商/技术参数
参数描述
ST727X4-EMU2B 制造商:STMicroelectronics 功能描述:REALTIME EMULATOR BOARD - Bulk
ST727X4-EPB/US 制造商:STMicroelectronics 功能描述:PROGRAMMER - Bulk
ST-7-28 功能描述:XFRMR PWR 115V 14VAC 2.6A RoHS:是 类别:变压器 >> 功率 系列:ST 标准包装:1 系列:260 类型:标准 最大功率:65 VA 主线圈:双 副线圈:三路,中心抽头 在某电流时的串联输出电压:500 VAC @ 85mA,5 VAC @ 2A,6.3 VAC @ 2A 在某电流时的并联输出电压:- 安装类型:底座安装 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高(最大):66.80mm 端接类型:导线引线
ST7-28 制造商:SUPERWORLD 制造商全称:Superworld Electronics 功能描述:POWER TRANSFORMER
ST7-28B56 功能描述:电源变压器 SPLIT BOBBIN HORZ MOUNT XFMR RoHS:否 制造商:Triad Magnetics 功率额定值:12 VA 初级电压额定值:115 V / 230 V 次级电压额定值:12 V / 24 V 安装风格:SMD/SMT 一次绕组:Dual Primary Winding 二次绕组:Dual Secondary Winding 长度:2.5 in 宽度:2 in 高度:1.062 in