- 您现在的位置：买卖IC网 > PDF目录69400 > SYM53C180I2 (LSI CORP) SCSI BUS CONTROLLER, PBGA192 PDF资料下载
参数资料
| 型号： | SYM53C180I2 |
| 厂商： | LSI CORP |
| 元件分类： | 总线控制器 |
| 英文描述： | SCSI BUS CONTROLLER, PBGA192 |
| 封装： | 23 X 23 MM, 1.27 MM PITCH, PLASTIC, BGA-192 |
| 文件页数： | 16/78页 |
| 文件大小： | 1073K |
| 代理商： | SYM53C180I2 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页
Interface Signal Descriptions
2-5
2.1.4 State Machine Control
The State Machine Control tracks the SCSI bus phase protocol and other
internal operating conditions. This block provides signals to the Retiming
Logic that identify how to properly handle SCSI bus signal retiming based
on SCSI protocol.
2.1.5 DIFFSENS Receiver
The SYM53C180 contains LVD DIFFSENS receivers that detect the
voltage level on the A Side or B Side DIFFSENS lines to inform the
SYM53C180 of the transmission mode being used by the SCSI buses.
A device does not change its present signal driver or receiver mode
based on the DIFFSENS voltage levels unless a new mode is sensed
continuously for at least 100 ms.
Transmission mode detection for SE or LVD is accomplished through the
use of the DIFFSENS lines. Table 2.1 shows the voltages on the
DIFFSENS lines and modes they will cause.
2.1.6 Dynamic Transmission Mode Changes
Any dynamic mode change (SE/LVD) on a bus segment is considered to
be a signicant event that requires the initiator to determine whether the
mode change meets the requirements for that bus segment.
The SYM53C180 supports dynamic transmission mode changes by
notifying the initiator(s) of changes in transmission mode (SE/LVD) on A
or B side segments by using the SCSI bus RESET. The DIFFSENS line
detects a valid mode switch on the bus segments. After the DIFFSENS
state is present for 100 ms, the SYM53C180 generates a SCSI reset on
the opposite bus from the one that the transmission mode change
occurred on. This reset informs any initiators residing on the opposite
segment about the change in the transmission mode. The initiator(s) then
renegotiates synchronous transfer rates with each device on that segment.
Table 2.1
DIFFSENS Voltage Levels
Voltage
Mode
-0.35 to +0.5
SE
+0.7 to +1.9
LVD
相关PDF资料 |
PDF描述 |
|---|---|
| SYM53C895V5 | SCSI BUS CONTROLLER, PBGA272 |
| SZ20360 | SINGLE COLOR LED, NATURAL WHITE, 10.3 mm |
| SZW05A0A | T-1 SINGLE COLOR LED, PURE WHITE, 2.9 mm |
| SZWW5A0A | T-1 SINGLE COLOR LED, WARM WHITE, 2.9 mm |
| T6B70BFG | SPECIALTY ANALOG CIRCUIT, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SYM53C400A | 制造商:SYMBIOS 功能描述: |
| SYM53C770 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:SCSI Bus Interface/Controller |
| SYM53C876E(PBGA) | 制造商:未知厂家 制造商全称:未知厂家 功能描述:SCSI Bus Interface/Controller |
| SYM53C876E(PQFP) | 制造商:未知厂家 制造商全称:未知厂家 功能描述:SCSI Bus Interface/Controller |
| SYM53C885 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Telecommunication IC |
发布紧急采购，3分钟左右您将得到回复。