参数资料
型号: TLV320AIC3111IRHBT
厂商: TEXAS INSTRUMENTS INC
元件分类: 音频/视频放大
英文描述: AUDIO AMPLIFIER, PQCC32
封装: 5 X 5 MM, GREEN, PLASTIC, QFN-32
文件页数: 112/156页
文件大小: 1701K
代理商: TLV320AIC3111IRHBT
www.ti.com
SLAS644B – JULY 2009 – REVISED OCTOBER 2009
dec2hex = Decimal to hexadecimal conversion function
NOTES:
1. fin should be less than fS/4.
2. For the sine and cosine values, if the number of bits is less than the full 16-bit value, then the unused
MSBs must be written as 0s.
3. For the beep-length values, if number of bits is less than the full 24-bit value, then the unused MSBs
must be written as 0s.
Following the beep-volume control is a digital mixer that mixes in a playback data stream whose level has
already been set by the DAC volume control. Therefore, once the key-click volume level is set, the
key-click volume is not affected by the DAC volume control, which is the main control available to the end
user. This functionality is shown in Figure 1-1.
Following the DAC, the signal can be further scaled by the analog output volume control and
power-amplifier level control.
The beep generator is used for the key-click function. A single beep is generated by writing to page 0 /
register 71, bit D7. After the programmed beep length has finished, register 71, bit D7 is reset back to
zero.
5.6.8
Programming DAC Digital Filter Coefficients
The digital filter coefficients must be programmed through the I2C interface. All digital filtering for the DAC
signal path must be loaded into the RAM before the DAC is powered on. (Note that default ALLPASS filter
coefficients for programmable biquads are located in boot ROM. The boot ROM automatically loads the
default values into the RAM following a hardware reset (toggling the RESET pin) or after a software reset.
After resetting the device, loading boot ROM coefficients into the digital filters requires 100
μs of
programming time. During this time, reading or writing to page 8 through page 15 for updating DAC filter
coefficient values is not permitted. (The DAC should not be powered up until after all of the DAC
configurations have been done by the system microprocessor.)
5.6.9
Updating DAC Digital Filter Coefficients During PLAY
When it is required to update the DAC digital filter coefficients or beep generator during play, care must be
taken to avoid click and pop noise or even a possible oscillation noise. These artifacts can occur if the
DAC coefficients are updated without following the proper update sequence. The correct sequence is
shown in Figure 5-35. The values for times listed in Figure 5-35 are conservative and should be used for
software purposes.
There is also an adaptive mode, in which DAC coefficients can be updated while the DAC is on. For
details, see Section 5.6.1.3.
Copyright 2009, Texas Instruments Incorporated
APPLICATION INFORMATION
59
Product Folder Link(s): TLV320AIC3111
相关PDF资料
PDF描述
TLV320AIC3111IRHBR AUDIO AMPLIFIER, PQCC32
TLV320AIC3120IRHBR AUDIO AMPLIFIER, PQCC32
TLV320AIC3120IRHBT AUDIO AMPLIFIER, PQCC32
TLV320AIC31IRHBRG4 SPECIALTY CONSUMER CIRCUIT, PQCC32
TLV320AIC31IRHBR SPECIALTY CONSUMER CIRCUIT, PQCC32
相关代理商/技术参数
参数描述
TLV320AIC3120 制造商:TI 制造商全称:Texas Instruments 功能描述:Low-Power Mono Audio Codec With Embedded miniDSP and Mono Class-D Speaker Amplifier
TLV320AIC3120EVM-U 功能描述:音频 IC 开发工具 TLV320AIC3120EVM-U Eval Mod RoHS:否 制造商:Texas Instruments 产品:Evaluation Kits 类型:Audio Amplifiers 工具用于评估:TAS5614L 工作电源电压:12 V to 38 V
TLV320AIC3120IRHBR 功能描述:接口—CODEC Low-Pwr Audio CODEC RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel
TLV320AIC3120IRHBT 功能描述:接口—CODEC Low-Pwr Audio CODEC RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel
TLV320AIC31EVM 功能描述:音频 IC 开发工具 TLV320AIC31 Eval Mod RoHS:否 制造商:Texas Instruments 产品:Evaluation Kits 类型:Audio Amplifiers 工具用于评估:TAS5614L 工作电源电压:12 V to 38 V