- 您现在的位置：买卖IC网 > PDF目录1809 > IR3500VMTRPBF (International Rectifier)IC XPHASE3 CTLR VR11.1 32-MLPQ PDF资料下载
参数资料
| 型号： | IR3500VMTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 12/34页 |
| 文件大小： | 0K |
| 描述： | IC XPHASE3 CTLR VR11.1 32-MLPQ |
| 标准包装： | 1 |
| 系列： | XPhase3™ |
| 应用： | 处理器 |
| 电流 - 电源： | 6.5mA |
| 电源电压： | 4.75 V ~ 7.5 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-MLPQ（5x5） |
| 包装： | 标准包装 |
| 其它名称： | IR3500VMTRPBFDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
IR3500V
The advantage of sensing the inductor current versus high side or low side sensing is that actual output current
being delivered to the load is obtained rather than peak or sampled information about the switch currents. The
output voltage can be positioned to meet a load line based on real time information. Except for a sense resistor in
series with the inductor, this is the only sense method that can support a single cycle transient response. Other
methods provide no information during either load increase (low side sensing) or load decrease (high side sensing).
An additional problem associated with peak or valley current mode control for voltage positioning is that they suffer
from peak-to-average errors. These errors will show in many ways but one example is the effect of frequency
variation. If the frequency of a particular unit is 10% low, the peak to peak inductor current will be 10% larger and
the output impedance of the converter will drop by about 10%. Variations in inductance, current sense amplifier
bandwidth, PWM prop delay, any added slope compensation, input voltage, and output voltage are all additional
sources of peak-to-average errors.
Current Sense Amplifier
A high speed differential current sense amplifier is located in the phase IC, as shown in Figure 7. Its gain is
nominally 32.5 and the 3850 ppm/oC increase in inductor DCR should be compensated in the voltage loop feedback
path.
The current sense amplifier can accept positive differential input up to 50mV and negative up to -10mV before
clipping. The output of the current sense amplifier is summed with the DAC voltage and sent to the control IC and
other phases through an on-chip 3K
resistor connected to the ISHARE pin. The ISHARE pins of all the phases are
tied together and the voltage on the share bus represents the average current through all the inductors and is used
by the control IC for voltage positioning and current limit protection. The input offset of this amplifier is calibrated to
+/- 1mV in order to reduce the current sense error.
The input offset voltage is the primary source of error for the current share loop. In order to achieve very small input
offset error and superior current sense accuracy, the current sense amplifier continuously calibrates itself. This
calibration algorithm creates ripple on the ISHARE bus with a frequency of fsw / 896 in a multiphase architecture.
Average Current Share Loop
Current sharing between phases of the converter is achieved by the average current share loop in each phase IC.
The output of the current sense amplifier is compared with average current at the share bus. If current in a phase is
smaller than the average current, the share adjust amplifier of the phase will pull down the starting point of the PWM
ramp thereby increasing its duty cycle and output current; if current in a phase is larger than the average current,
the share adjust amplifier of the phase will pull up the starting point of the PWM ramp thereby decreasing its duty
cycle and output current. The current share amplifier is internally compensated so that the crossover frequency of
the current share loop is much slower than that of the voltage loop and the two loops do not interact.
IR3500V THEORY OF OPERATION
Block Diagram
The Block diagram of the IR3500V is shown in Figure 8, and specific features are discussed in the following
sections.
Page 12 of 34
July 28, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| IR3502AMTRPBF | IC XPHASE CTRL VR11.0/1 32-MLPQ |
| IR3502BMTRPBF | IC REG XPH INTEL VR11.1 32-MLPQ |
| IR3502MTRPBF | IC XPHASE3 CONTROLLER 32-MLPQ |
| IR3503MTRPBF | IC CTRL XPHASE VR11.0/1 32-MLPQ |
| IR3504MTRPBF | IC CTRL XPHASE3 SVID 32-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3502 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC |
| IR3502_09 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC |
| IR3502A | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC |
| IR3502AMPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC |
| IR3502AMTRPBF | 功能描述:IC XPHASE CTRL VR11.0/1 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。