参数资料
型号: IR3500VMTRPBF
厂商: International Rectifier
文件页数: 9/34页
文件大小: 0K
描述: IC XPHASE3 CTLR VR11.1 32-MLPQ
标准包装: 1
系列: XPhase3™
应用: 处理器
电流 - 电源: 6.5mA
电源电压: 4.75 V ~ 7.5 V
工作温度: 0°C ~ 100°C
安装类型: 表面贴装
封装/外壳: 32-VFQFN 裸露焊盘
供应商设备封装: 32-MLPQ(5x5)
包装: 标准包装
其它名称: IR3500VMTRPBFDKR
IR3500V
Frequency and Phase Timing Control
The oscillator and system clock frequency is programmable from 250kHz to 9MHZ by an external resistor (ROSC).
The control IC system clock signal (CLKOUT) is connected to CLKIN of all the phase ICs. The phase timing of the
phase ICs is controlled by the daisy chain loop, where control IC phase clock output (PHSOUT) is connected to the
phase clock input (PHSIN) of the first phase IC, and PHSOUT of the first phase IC is connected to PHSIN of the
second phase IC, etc. and PHSOUT of the last phase IC is connected back to PHSIN of the control IC. During
power up, the control IC sends out clock signals from both CLKOUT and PHSOUT pins and detects the feedback at
PHSIN pin to determine the phase number and monitor any fault in the daisy chain loop. Figure 4 shows the phase
timing for a four phase converter. The switching frequency is programmed by the ROSC resistor as shown in Figure
5. The clock frequency equals the number of phase times the switching frequency.
Control IC CLKOUT
(Phase IC CLKIN)
Control IC PHSOUT
(Phase IC1 PHSIN)
Phase IC1
PWM Latch SET
Phase IC 1 PHSOUT
(Phase IC2 PHSIN)
Phase IC 2 PHSOUT
(Phase IC3 PHSIN)
Phase IC 3 PHSOUT
(Phase IC4 PHSIN)
Phase IC4 PHSOUT
(Control IC PHSIN)
Figure 4 - Four Phase Oscillator Waveforms
PWM Operation
The PWM comparator is located in the phase IC. Upon receiving the falling edge of a clock pulse, the PWM latch is
set; the PWM ramp voltage begins to increase; the low side driver is turned off, and the high side driver is then
turned on after the non-overlap time. When the PWM ramp voltage exceeds the error amplifier’s output voltage the
PWM latch is reset. This turns off the high side driver, then turns on the low side driver after the non-overlap time,
and activates the ramp discharge clamp. The ramp discharge clamp quickly discharges the PWM ramp capacitor to
the output voltage of the share adjust amplifier in the phase IC until the next clock pulse.
The PWM latch is reset dominant allowing all phases to go to zero duty cycle within a few tens of nanoseconds in
response to a load step decrease. Phases can overlap and go up to 100% duty cycle in response to a load step
increase with turn-on gated by the clock pulses. An error amplifier output voltage greater than the common mode
input range of the PWM comparator results in 100% duty cycle regardless of the voltage of the PWM ramp.
Page 9 of 34
July 28, 2008
相关PDF资料
PDF描述
IR3502AMTRPBF IC XPHASE CTRL VR11.0/1 32-MLPQ
IR3502BMTRPBF IC REG XPH INTEL VR11.1 32-MLPQ
IR3502MTRPBF IC XPHASE3 CONTROLLER 32-MLPQ
IR3503MTRPBF IC CTRL XPHASE VR11.0/1 32-MLPQ
IR3504MTRPBF IC CTRL XPHASE3 SVID 32-MLPQ
相关代理商/技术参数
参数描述
IR3502 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC
IR3502_09 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC
IR3502A 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC
IR3502AMPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM CONTROL IC
IR3502AMTRPBF 功能描述:IC XPHASE CTRL VR11.0/1 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像,声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP(8x8) 包装:管件