参数资料
| 型号： | ISL6322IRZ |
| 厂商： | Intersil |
| 文件页数： | 36/41页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM 4PHASE BUCK 48-QFN |
| 标准包装： | 43 |
| 应用： | 控制器，Intel VR10、VR11、AMD CPU |
| 输入电压： | 5 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.38 V ~ 1.99 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页
ISL6322
C 2
In Equation 42, L is the per-channel filter inductance divided
by the number of active channels; C is the sum total of all
output capacitors; ESR is the equivalent-series resistance of
R C
C C
COMP
the bulk output-filter capacitance; and V PP is the
peak-to-peak sawtooth signal amplitude as described in
FB
C 1
ISL6322
Output Filter Design
R 1
R FB
IDROOP
VDIFF
The output inductors and the output capacitor bank together
to form a low-pass filter responsible for smoothing the
pulsating voltage at the phase nodes. The output filter also
must provide the transient energy until the regulator can
respond. Because it has a low bandwidth compared to the
switching frequency, the output filter limits the system
FIGURE 24. COMPENSATION CIRCUIT WITHOUT LOAD-LINE
REGULATION
COMPENSATION WITHOUT LOAD-LINE REGULATION
The non load-line regulated converter is accurately modeled
as a voltage-mode regulator with two poles at the L-C
resonant frequency and a zero at the ESR frequency. A
type III controller, as shown in Figure 24, provides the
necessary compensation.
The first step is to choose the desired bandwidth, f 0 , of the
compensated system. Choose a frequency high enough to
assure adequate transient performance but not higher than
1/3 of the switching frequency. The type-III compensator has
an extra high-frequency pole, f HF . This pole can be used for
added noise rejection or to assure adequate attenuation at
the error-amplifier high-order pole and zero frequencies. A
good general rule is to choose f HF = 10f 0 , but it can be
higher if desired. Choosing f HF to be lower than 10f 0 can
cause problems with too much phase shift below the system
bandwidth.
In the solutions to the compensation equations, there is a
single degree of freedom. For the solutions presented in
Equation 42, R FB is selected arbitrarily. The remaining
compensation components are then selected according to
transient response. The output capacitors must supply or
sink load current while the current in the output inductors
increases or decreases to meet the demand.
In high-speed converters, the output capacitor bank is usually
the most costly (and often the largest) part of the circuit.
Output filter design begins with minimizing the cost of this part
of the circuit. The critical load parameters in choosing the
output capacitors are the maximum size of the load step, Δ I,
the load-current slew rate, di/dt, and the maximum allowable
output-voltage deviation under transient loading, Δ V MAX .
Capacitors are characterized according to their capacitance,
ESR, and ESL (equivalent series inductance).
At the beginning of the load transient, the output capacitors
supply all of the transient current. The output voltage will
initially deviate by an amount approximated by the voltage
drop across the ESL. As the load current increases, the
voltage drop across the ESR increases linearly until the load
current reaches its final value. The capacitors selected must
have sufficiently low ESL and ESR so that the total
output-voltage deviation is less than the allowable maximum.
Neglecting the contribution of inductor current and regulator
response, the output voltage initially deviates by the amount
specified in Equation 43.
R 1 = R FB ? --------------------------------------------
Δ V ≈ ESL ? ----- + ESR ? Δ I
Equation 42.
C ? ESR
L ? C – C ? ESR
di
dt
(EQ. 43)
C 1 = --------------------------------------------
C 2 = ----------------------------------------------------------------------------------------------------
HF ? ( L ? C ) ? R FB ? V PP
( 2 ? π ) 2 ? f ? f
V PP ? ? 2 π ? ? f 0 ? f HF ? L ? C ? R FB
R C = -----------------------------------------------------------------------------------------
0.75 ? V ? ( 2 ? π ? f HF ? L ? C – 1 )
( 2 ? π ) 2 ? f 0 ? f HF ? ( L ? C ) ? R FB ? V PP
L ? C – C ? ESR
R FB
0.75 ? V IN
0
2
? ?
IN
0.75 ? V IN ? ( 2 ? π ? f HF ? L ? C – 1 )
C C = ----------------------------------------------------------------------------------------------------
36
(EQ. 42)
The filter capacitor must have sufficiently low ESL and ESR
so that Δ V < Δ V MAX .
Most capacitor solutions rely on a mixture of high-frequency
capacitors with relatively low capacitance in combination
with bulk capacitors having high capacitance but limited
high-frequency performance. Minimizing the ESL of the
high-frequency capacitors allows them to support the output
voltage as the current increases. Minimizing the ESR of the
bulk capacitors allows them to supply the increased current
with less output voltage deviation.
FN6328.2
August 2, 2007
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6323AIRZ | IC PWM CTRLR SYNC BUCK DL 48QFN |
| ISL6323BIRZ | IC PWM CTRLR SYNC BUCK DL 48QFN |
| ISL6323IRZ | IC HYBRID CTRLR PWM MONO 48-QFN |
| ISL6324AIRZ | IC HYBRID CTRLR PWM DUAL 48QFN |
| ISL6324IRZ | IC HYBRID CTRLR PWM DUAL 48-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6322IRZ-T | 功能描述:IC CTRLR PWM 4PHASE BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| ISL6323ACRZ | 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6323ACRZR5381 | 制造商:Intersil Corporation 功能描述:4+1 PHASE CONT. FOR CORE+NORTHBRIDGE,1 PHASE PSI, 3.4MHZ SVI - Rail/Tube 制造商:Intersil Corporation 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN |
| ISL6323ACRZ-T | 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6323ACRZ-TR5381 | 制造商:Intersil Corporation 功能描述:4+1 PHASE CONTROLLER, CORE+NORTHBRIDGE,1 PHASE PSI,3.4MHZ SV - Tape and Reel 制造商:Intersil Corporation 功能描述:IC PWM CTRLR SYNC BUCK DL 48QFN |
发布紧急采购，3分钟左右您将得到回复。