- 您现在的位置：买卖IC网 > PDF目录16296 > LTC4110EUHF#PBF (Linear Technology)IC BATTERY BACKUP MANAGER 38-QFN PDF资料下载
参数资料
| 型号： | LTC4110EUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 34/52页 |
| 文件大小： | 0K |
| 描述： | IC BATTERY BACKUP MANAGER 38-QFN |
| 标准包装： | 52 |
| 功能： | 备份管理 |
| 电池化学： | 铅酸，锂离子，锂聚合物，镍镉，镍氢，超级电容器 |
| 电源电压： | 4.5 V ~ 19 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 管件 |
| 产品目录页面： | 1341 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页当前第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
LTC4110
APPLICATIONS INFORMATION
SOFT-START
The LTC4110 is soft-started with the 0.1μF capacitor on
the I TH pin. On start-up, the I TH pin voltage will rise quickly
to 0.1V, then ramp up at a rate set by the internal 24μA
pull-up current and the external capacitor. Battery charging
current starts ramping up when I TH voltage reaches 0.7V
and full current is achieved with I TH at about 2V. With a
CALIBRATION MODE BACK-DRIVE CURRENT
PROTECTION
A resistor between CLP and CLN programs the minimum
supply forward current, this feature prevent the LTC4110
from back-driving the supply in calibration mode and
pulling the voltage higher when the system load is low.
The resistor value is given by
0.1μF capacitor, time to reach full charge current is about
8ms and it is assumed that input voltage to the charger
will reach full value in less than 8ms. The capacitor can
R CL =
I BDT
I FR ( MIN )
be increased up to 1μF if longer input start-up times are
needed.
In any switching regulator, conventional timer-based soft-
starting can be defeated if the input voltage rises much
slower than the timeout period. This happens because
the switching regulators in the battery charger and the
computer power supply are typically supplying a ?xed
amount of power to the load. If input voltage comes up
slowly compared to the soft-start time, the regulators will
try to deliver full power to the load when the input voltage
is still well below its ?nal value. If the adapter is current
limited, it cannot deliver full power at reduced output
voltages and the possibility exists for a quasi “latch” state
where the adapter output stays in a current limited state at
reduced output voltage. For instance, if maximum charger
plus computer load power is 30W, a 15V adapter might
be current limited at 2.5A. If adapter voltage is less than
(30W/2.5A = 12V) when full power is drawn, the adapter
voltage will be pulled down by the constant 30W load
until it reaches a lower stable state where the switching
regulators can no longer supply full load. This situation
can be prevented by utilizing the DCDIV resistor divider,
set higher than the minimum adapter voltage where full
power can be achieved.
LTC4110
where
I BDT = back-drive current limit threshold, 10mV typical
I FR(MIN) = minimum forward current in calibration mode
An RC ?lter may be required to ?lter out system load noise
as shown in Figure 11.
BATTERY AND CHARGER CURRENT SENSE
The LTC4110 uses two sense resistors to monitor and
control all charge and calibration currents: R SNS(BAT) and
R SNS(FET) .
R SNS(BAT)
R SNS(BAT) is used to monitor the DC current going into
the battery for charge, and the current going out of the
battery for calibration. Before any current programming
can be done, the value of R SNS(BAT) must be determined
?rst. Highest accuracy is achieved when full-scale current,
I MAX is set to develop a 100mV drop across the resistor.
Although values greater than 100mV can be used to improve
accuracy, this requires larger sense resistors to handle
the extra heat and lower ef?ciency. I MAX must be set to
V IN
BACK
DRIVE
CL1
–
+
10mV
CLP
CLN
10mV
100nF
5k
+
C IN
TO
SYSTEM
LOAD
4110 F11
Figure 11. Back-Drive Protection
4110fb
34
相关PDF资料 |
PDF描述 |
|---|---|
| 3-6754412-6 | CA,XG,MTRJ-SC |
| ECO-S2DB102EA | CAP ALUM 1000UF 200V 20% SNAP |
| 3-6754411-6 | CA,XG,MTRJ-SC |
| RCM10DRYI-S13 | CONN EDGECARD 20POS .156 EXTEND |
| ECO-S2WB181DA | CAP ALUM 180UF 450V 20% SNAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4110EUHF-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:Battery Backup System Manager |
| LTC4110EUHF-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Battery Backup System Manager |
| LTC4120IUD#PBF | 制造商:Linear Technology 功能描述:BATTERY CHARGER, 400MA, QFN-16, Battery Type:Li-Ion, Li-Polymer, Input Voltage:4 |
| LTC4150 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, High-Side Current Sense |
| LTC4150_1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Coulomb Counter/ Battery Gas Gauge |
发布紧急采购，3分钟左右您将得到回复。