- 您现在的位置：买卖IC网 > PDF目录224123 > M25P40-VMN6TG/X (NUMONYX) 512K X 8 SPI BUS SERIAL EEPROM, PDSO8 PDF资料下载
参数资料
| 型号： | M25P40-VMN6TG/X |
| 厂商： | NUMONYX |
| 元件分类： | PROM |
| 英文描述： | 512K X 8 SPI BUS SERIAL EEPROM, PDSO8 |
| 封装： | 0.150 INCH, ROHS COMPLIANT, PLASTIC, SOP-8 |
| 文件页数： | 4/57页 |
| 文件大小： | 1160K |
| 代理商： | M25P40-VMN6TG/X |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页
Operating features
M25P40
12/57
4
Operating features
4.1
Page Programming
To program one data byte, two instructions are required: Write Enable (WREN), which is
one byte, and a Page Program (PP) sequence, which consists of four bytes plus data. This
is followed by the internal Program cycle (of duration tPP).
To spread this overhead, the Page Program (PP) instruction allows up to 256 bytes to be
programmed at a time (changing bits from 1 to 0), provided that they lie in consecutive
addresses on the same page of memory.
For optimized timings, it is recommended to use the Page Program (PP) instruction to
program all consecutive targeted bytes in a single sequence versus using several Page
Program (PP) sequences with each containing only a few bytes (see Page Program (PP),
4.2
Sector Erase and Bulk Erase
The Page Program (PP) instruction allows bits to be reset from 1 to 0. Before this can be
applied, the bytes of memory need to have been erased to all 1s (FFh). This can be
achieved either a sector at a time, using the Sector Erase (SE) instruction, or throughout the
entire memory, using the Bulk Erase (BE) instruction. This starts an internal Erase cycle (of
duration tSE or tBE).
The Erase instruction must be preceded by a Write Enable (WREN) instruction.
4.3
Polling during a Write, Program or Erase cycle
A further improvement in the time to Write Status Register (WRSR), Program (PP) or Erase
(SE or BE) can be achieved by not waiting for the worst case delay (tW, tPP, tSE, or tBE). The
Write In Progress (WIP) bit is provided in the Status Register so that the application program
can monitor its value, polling it to establish when the previous Write cycle, Program cycle or
Erase cycle is complete.
4.4
Active Power, Standby Power and Deep Power-down modes
When Chip Select (S) is Low, the device is selected, and in the Active Power mode.
When Chip Select (S) is High, the device is deselected, but could remain in the Active
Power mode until all internal cycles have completed (Program, Erase, Write Status
Register). The device then goes in to the Standby Power mode. The device consumption
drops to ICC1.
The Deep Power-down mode is entered when the specific instruction (the Deep Power-
down (DP) instruction) is executed. The device consumption drops further to ICC2. The
device remains in this mode until another specific instruction (the Release from Deep
Power-down and Read Electronic Signature (RES) instruction) is executed.
相关PDF资料 |
PDF描述 |
|---|---|
| M25P40VMF6 | 4 Mbit Uniform Sector, Serial Flash Memory |
| M25P40VMF6G | 4 Mbit Uniform Sector, Serial Flash Memory |
| M25P40VMF6P | 4 Mbit Uniform Sector, Serial Flash Memory |
| M25P40VMF6T | 4 Mbit Uniform Sector, Serial Flash Memory |
| M25P40VMF6TG | 4 Mbit Uniform Sector, Serial Flash Memory |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M25P40VMN6TP | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:512 Kbit to 32 Mbit, Low Voltage, Serial Flash Memory With 40 MHz or 50 MHz SPI Bus Interface |
| M25P40-VMN6TP | 功能描述:闪存 SERIAL SECTOR ERASE FLASH 4MEG RoHS:否 制造商:ON Semiconductor 数据总线宽度:1 bit 存储类型:Flash 存储容量:2 MB 结构:256 K x 8 定时类型: 接口类型:SPI 访问时间: 电源电压-最大:3.6 V 电源电压-最小:2.3 V 最大工作电流:15 mA 工作温度:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体: 封装:Reel |
| M25P40-VMN6TP/X | 制造商:NUMONYX 制造商全称:Numonyx B.V 功能描述:4 Mbit, low voltage, serial Flash memory with 50 MHz SPI bus interface |
| M25P40-VMN6TP_NUD | 制造商:Micron Technology Inc 功能描述: |
| M25P40-VMN6TPB | 功能描述:IC FLASH 4MBIT 75MHZ 8SOIC RoHS:是 类别:集成电路 (IC) >> 存储器 系列:Forté™ 标准包装:2,000 系列:- 格式 - 存储器:RAM 存储器类型:SRAM - 异步 存储容量:256K (32K x 8) 速度:15ns 接口:并联 电源电压:3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 封装/外壳:28-TSSOP（0.465"，11.8mm 宽） 供应商设备封装:28-TSOP 包装:带卷 (TR) 其它名称:71V256SA15PZGI8 |
发布紧急采购，3分钟左右您将得到回复。