- 您现在的位置：买卖IC网 > Datasheet目录470 > MAX11008EVC16 (Maxim Integrated)EVAL KIT MAX11008 Datasheet资料下载
参数资料
| 型号： | MAX11008EVC16 |
| 厂商： | Maxim Integrated |
| 文件页数： | 48/67页 |
| 文件大小： | 0K |
| 描述： | EVAL KIT MAX11008 |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页当前第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页
Dual RF LDMOS Bias Controller with
Nonvolatile Memory
Table 11. Hardware Configuration Register
DATA BITS
D15*
D[14:12]*
BIT NAME
T1AVGCTL
T1LIMIT[2:0]
RESET STATE
0
000
FUNCTION
Channel 1 averaging-equation bit. This bit controls the averaging equation
for channel 1 while the device is in tracking mode. See Table 11a.
Channel 1 difference-limiter bits. Set T1LIMIT[2:0] to enable the difference
limiter for channel 1 temperature averaging. See Table 11b.
If the FIFOSTAT bit is set to 1, the ALARM output is used to monitor data
D11
FIFOSTAT
0
flow into/out of the FIFO and EEPROM while in the message and LUT
streaming modes.
ADC monitor enable bit. If ADCMON is set to 1, the result from the ADC
D10
ADCMON
0
conversion is copied into the FIFO, from where it can be read over the
serial interface. If ADCMON = 0, the result is not copied into the FIFO.
ADCMON and AVGMON cannot be active at the same time.
D[9:8]
D[7:6]
D[5:4]
D[3:2]
D[1:0]
PG2SET[1:0]
PG1SET[1:0]
CKSEL[1:0]
ADCREF[1:0]
DACREF[1:0]
00
00
00
00
00
PGA2 gain-setting bits. See Table 11c.
PGA1 gain-setting bits. See Table 11c.
Clock mode and CNVST bits. See Table 11d.
ADC reference select bits. See Table 11e.
DAC reference select bits. See Table 11f.
X = Don’t care.
*Write only.
Table 11a. Channel 1 Averaging Equation
(T1AVGCTL)
D15
0
1
CHANNEL 1 AVERAGING EQUATION
Average = average + 1/16 difference.
Average = average + 1/4 difference.
Table 11b. Channel 1 Difference-Limiter Bits (T1LIMIT[2:0])
D14
0
0
0
0
1
1
1
1
D13
0
0
1
1
0
0
1
1
D12
0
1
0
1
0
1
0
1
CHANNEL 2 DIFFERENCE-LIMITER BITS (T2LIMIT[2:0])
No limiting is applied.
Difference is limited to 1 LSB (1/8 of a degree).
Difference is limited to 3 LSBs (3/8 of a degree).
Difference is limited to 7 LSBs (7/8 of a degree).
Difference is limited to 15 LSBs (1 7/8 degrees).
Difference is limited to 31 LSBs (3 7/8 degrees).
Difference is limited to 63 LSBs (7 7/8 degrees).
Difference is limited to 127 LSBs (15 7/8 degrees).
48
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX11014BGTM+T | IC RF MESFET AMP 48-TQFN-EP |
| MAX12000ETB+T | IC AMP GPS FRONT 1575MHZ 10TDFN |
| MAX12005ETM+T | IC SATELLITE IF SWITCH 48-TQFN |
| MAX1385BUTM+ | IC RF LDMOS BIAS CNTRLR 48-TQFN |
| MAX1470EUI+T | IC RECEIVER 315MHZ 28-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX11008EVKIT+ | 功能描述:放大器 IC 开发工具 MAX11008 Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| MAX1100CWG | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX1101 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA |
| MAX11014 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers |
| MAX11014_08 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers |
发布紧急采购，3分钟左右您将得到回复。