参数资料
型号: MAX11008EVC16
厂商: Maxim Integrated
文件页数: 54/67页
文件大小: 0K
描述: EVAL KIT MAX11008
标准包装: 1
系列: *
Dual RF LDMOS Bias Controller with
Nonvolatile Memory
Table 13a. Channel 2 Averaging Equation
(T2AVGCTL)
D15
0
1
CHANNEL 2 AVERAGING EQUATION
Average = average + 1/16 difference.
Average = average + 1/4 difference.
Table 13b. Channel 2 Difference Limiter Bits (T2LIMIT[2:0])
D14
0
0
0
0
1
1
1
1
D13
0
0
1
1
0
0
1
1
D12
0
1
0
1
0
1
0
1
CHANNEL 2 DIFFERENCE LIMITER
No limiting is applied.
Difference is limited to 1 LSB (1/8 of a degree).
Difference is limited to 3 LSBs (3/8 of a degree).
Difference is limited to 7 LSBs (7/8 of a degree).
Difference is limited to 15 LSBs (1 7/8 degrees).
Difference is limited to 31 LSBs (3 7/8 degrees).
Difference is limited to 63 LSBs (7 7/8 degrees).
Difference is limited to 127 LSBs (15 7/8 degrees).
Table 13c. APC Parameter Source Select Bits (APCSRC_1, APCSRC_0)
APCSRC_1
0
0
1
1
APCSRC_0
0
1
0
1
APC PARAMETER SOURCE SELECT
Value stored in APC parameter register.
Reserved. Do not use.
Drain current samples.
External input samples (AIN input).
The A_HIST register bits A_HIST[3:0] set the APC hys-
teresis limits for both channel 1 and channel 2 V GATE_
calculations. After a new APC sample, the device pro-
ceeds in performing a V GATE_ calculation if that sample
differs from the previous sample used for a V GATE_ cal-
culation by an amount greater than the hysteresis set-
ting (see Table 16e). Set APCCOMP_ and TCOMP_ to 0
before A_HIST is changed.
DAC Input Registers (IDAC1, IDAC2) (Write Only)
DAC_[11:0] set the value of the DAC Input registers
(see Table 17). Bits D[15:12] are don’t-care bits. The
GATE_ output is not updated with this value until it is
transferred to the DAC Output register. Write to the
Load DAC register to transfer the contents of the DAC
Input register to the DAC Output register. Write directly
to the DAC Input register to manipulate the DAC output
without triggering a V GATE_ calculation.
DAC Input and Output Registers (IODAC1, IODAC2)
(Write Only)
DAC_[11:0] set the values of the input and output regis-
ters of the respective DACs (see Table 18). Writing to
this register does not trigger a V GATE_ calculation, but
the GATE_ output is immediately updated with the
value that is written to this register. Bits D[15:12] are
don ’t-care bits. The contents of the DAC Input and
Output registers are not stored in the EEPROM.
PGA Calibration Control Register (PGACAL)
(Write Only)
The PGA Calibration Control register selects the PGA
calibration mode and controls when calibrations occur
(see Table 19). Bits D[15:3] are don’t-care bits. The
data contained in the PGA Calibration Control register
is stored in the EEPROM.
Set TRACK to 0 to perform the next PGA calibration in
acquisition mode, and set TRACK to 1 to perform the
next PGA calibration in tracking mode. Leave TRACK
set to 0 the first time a PGA calibration is performed
after power-up.
Set DOCAL to 1 to perform calibrations of PGA1 and
PGA2. DOCAL resets to 0 after the PGA calibration rou-
tine is complete. If either channel is powered down, the
PGA calibration for that channel is bypassed.
54
______________________________________________________________________________________
相关PDF资料
PDF描述
MAX11014BGTM+T IC RF MESFET AMP 48-TQFN-EP
MAX12000ETB+T IC AMP GPS FRONT 1575MHZ 10TDFN
MAX12005ETM+T IC SATELLITE IF SWITCH 48-TQFN
MAX1385BUTM+ IC RF LDMOS BIAS CNTRLR 48-TQFN
MAX1470EUI+T IC RECEIVER 315MHZ 28-TSSOP
相关代理商/技术参数
参数描述
MAX11008EVKIT+ 功能描述:放大器 IC 开发工具 MAX11008 Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V
MAX1100CWG 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX1101 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA
MAX11014 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers
MAX11014_08 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers