- 您现在的位置：买卖IC网 > PDF目录98144 > ST72141K2B3/XXX (STMICROELECTRONICS) 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP32 PDF资料下载
参数资料
| 型号： | ST72141K2B3/XXX |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP32 |
| 封装： | 0.400 INCH, PLASTIC, SDIP-32 |
| 文件页数： | 69/133页 |
| 文件大小： | 2615K |
| 代理商： | ST72141K2B3/XXX |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页当前第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页
Obsolete
Product(s)
- Obsolete
ST72141K2
40/133
8 ON-CHIP PERIPHERALS
8.1 MOTOR CONTROLLER (MTC)
8.1.1 Introduction
The ST7 Motor Controller (MTC) can be seen as a
Pulse Width Modulator multiplexed on six output
channels,
and
a
Back
Electromotive
Force
(BEMF) zero-crossing detector for sensorless con-
trol of Permanent Magnet Direct Current (PMDC)
brushless motors.
The MTC is particularly suited to driving synchro-
nous motors and supports operating modes like:
– Commutation step control with motor voltage
regulation and current limitation
– Commutation step control with motor current
regulation, i.e. direct torque control
– Sensor or sensorless motor phase commutation
control
– BEMF zero-crossing detection with high sensitiv-
ity. The integrated phase voltage comparator is
directly referred to the full BEMF voltage without
any attenuation. A BEMF voltage down to
200 mV can be detected, providing high noise
immunity and self-commutated operation in a
large speed range.
– Realtime motor winding demagnetization detec-
tion for fine-tuning the phase voltage masking
time to be applied before BEMF monitoring.
– Automatic and programmable delay between
BEMF zero-crossing detection and motor phase
commutation.
8.1.2 Main Features
■ Two on-chip analog comparators, one for BEMF
zero-crossing detection with 100 mV hysteresis,
the other for current regulation or limitation
■ Four selectable reference voltages for the
hysteresis comparator (0.2 V, 0.6 V, 1.2 V,
2.5 V)
■ 8-bit timer (MTIM) with two compare registers
and two capture features
■ Measurement
window generator for BEMF
zero-crossing detection
■ Auto-calibrated prescaler with 16 division steps
■ 8x8-bit multiplier
■ Phase input multiplexer
■ Sophisticated output management:
– The six output channels can be split into two
groups (odd & even).
– The PWM signal can be multiplexed on even,
odd or both groups, alternatively or simultane-
ously.
– The output polarity is programmable channel
by channel.
– An software enabled bit (active low) forces the
outputs in HiZ.
– An “emergency stop” input pin (active low)
asynchronously forces the outputs in HiZ.
Table 11. MTC Registers
8.1.3 Application Example
This example shows a six-step command se-
quence for a 3-phase permanent magnet DC
brushless motor (PMDC motor). Figure 27 shows
the phase steps and voltage, while Table 12
shows the relevant phase configurations.
To run this kind of motor efficiently, an autoswitch-
ing mode has to be used, i.e. the position of the ro-
tor must self-generate the powered winding com-
mutation. The BEMF zero crossing (Z event) on
the non-excited winding is used by the MTC as a
rotor position sensor. The delay between this
event and the commutation is computed by the
MTC and the commutation event Cn is automati-
cally generated after this delay.
After the commutation occurs, the MTC waits until
the winding is completely demagnetized by the
free-wheeling diode: during this phase the winding
is tied to 0V or to the HV high voltage rail and no
BEMF can be read. At the end of this phase a new
BEMF zero-crossing detection is enabled.
The end of demagnetization event (D), is also de-
tected by the MTC or simulated with a timer com-
pare feature when no detection is possible.
Register Description
Page
MTIM
Timer Counter Register
MZPRV
Capture Zn-1 Register
MZREG
Capture Zn Register
MCOMP Compare Cn+1 Register
MDREG
Demagnetization Register
MWGHT An Weight Register
MPRSR
Prescaler & Sampling Register
MIMR
Interrupt Mask Register
MISR
Interrupt Status Register
MCRA
Control Register A
MCRB
Control Register B
MPHST
Phase State Register
MPAR
Parity Register
MPOL
Polarity Register
相关PDF资料 |
PDF描述 |
|---|---|
| ST72311N4T6/XXX | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP64 |
| ST72311J2B6/XXX | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP42 |
| ST72311N2T3/XXX | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP64 |
| ST72321BAR7T6 | MICROCONTROLLER, QFP64 |
| ST72321BR7T3 | MICROCONTROLLER, QFP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ST72141K2B6 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT MCU WITH ELECTRIC-MOTOR CONTROL, ADC, 16-BIT TIMERS, SPI INTERFACE |
| ST72141K2M1 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT MCU WITH ELECTRIC-MOTOR CONTROL, ADC, 16-BIT TIMERS, SPI INTERFACE |
| ST72141K2M3 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT MCU WITH ELECTRIC-MOTOR CONTROL, ADC, 16-BIT TIMERS, SPI INTERFACE |
| ST72141K2M3/XXX | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Microcontroller |
| ST72141K2M6 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT MCU WITH ELECTRIC-MOTOR CONTROL, ADC, 16-BIT TIMERS, SPI INTERFACE |
发布紧急采购，3分钟左右您将得到回复。