参数资料
型号: CP2201-GM
厂商: Silicon Laboratories Inc
文件页数: 56/108页
文件大小: 0K
描述: IC ETH CTRLR SNGL-CHIP 28QFN
标准包装: 73
控制器类型: 以太网控制器,MAC/10Base-T
接口: 并行/串行
电源电压: 3.1 V ~ 3.6 V
电流 - 电源: 75mA
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 28-VFQFN 裸露焊盘
供应商设备封装: 28-QFN(5x5)
包装: 管件
产品目录页面: 627 (CN2011-ZH PDF)
配用: 336-1326-ND - KIT REF DESIGN PWR OVER ETHERNET
336-1316-ND - KIT EVAL FOR CP2201 ETH CTRLR
其它名称: 336-1313
CP2200/1
Rev. 1.0
51
Register 18. TXCN: Transmit Control Register
Register 19. TXBUSY: Transmit Busy Indicator
Bit 7:
OVRRIDE: Default Override
0: Settings for bits 5, 4, 3, 2, and 1 in TXCN will be ignored. MAC settings will take effect.
1: Settings for bits 5, 4, 3, 2, and 1 in TXCN will be applied. MAC settings will be overridden.
Bit 6:
UNUSED. Read = 0b, Write = don’t care.
Bit 5:
CRCENOV: CRC Enable
0: Disable CRC append on transmission.
1: Enable CRC append on transmission.
Bit 4:
PADENOV: Pad Enable
0: Disable padding of short frames.
1: Enable padding of short frames.
Bit 3:
TXPPKT: Transmit a PAUSE control packet
0: Normal packet transmission. Packet data will be obtained from the transmit buffer.
1: A PAUSE control packet with the value of TXPAUSEH:TXPAUSEL will be transmitted. Data in the
transmit buffer will not be accessed. PAUSE control packets are only valid in full-duplex mode.
Bit 2:
BCKPRES: Apply Back Pressure
0: Normal packet transmission. Back pressure will not be applied.
1: Back pressure will be applied on transmission (only valid in half duplex mode).
Bit 1:
FDPLXOV: Full Duplex Operation
Note: The transmit interface, MAC, and physical layer must be configured to the same duplex mode.
0: Transmit interface operates in half duplex mode.
1: Transmit interface operates in full duplex mode.
Bit 0:
TXGO: Transmit Packet
Set this bit to ‘1’ to begin transmission of a packet.
Note: TXGO should not be set to one if both TXSTART and TXEND are zero (i.e., no data has been
added to the buffer).
R/W
W
Reset Value
OVRRIDE
CRCENOV PADENOV
TXPPKT BCKPRES FDPLXOV
TXGO
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Address:
0x53
Bits 7–1: UNUSED. Read = 0000000b, Write = don’t care.
Bit 0:
TXBUSY: Packet Transmit Status
0: Packet Transmit is not in progress.
1: Packet Transmit is in progress.
R
RR
RRR
RR
Reset Value
TXBUSY 00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Address:
0x54
相关PDF资料
PDF描述
PIC12C509A-04I/MF IC MCU OTP 1KX12 8DFN
VNC2-64L1B-REEL IC USB HOST/DEVICE CTRL 64-LQFP
PIC12CE518T-04/SN IC MCU OTP 512X12 W/EE 8SOIC
GRM219R71E563KA01D CAP CER 0.056UF 25V 10% X7R 0805
PIC16LF723T-I/SO IC PIC MCU FLASH 7KB 28-SOIC
相关代理商/技术参数
参数描述
CP2201-GMR 功能描述:以太网 IC Ethernet Controller RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray
CP-220-K 制造商:PREMO 制造商全称:PREMO CORPORATION S.L 功能描述:Coils and Chokes for general use
CP221 制造商:CENTRAL 制造商全称:Central Semiconductor Corp 功能描述:Small Signal Transistor
CP-221 1 1/2"BL 100' 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3m 系列:CP-221 零件状态:过期 类型:套管,弹性 收缩率:2 至 1 长度:100'(30.48m) 内径(出厂):1.500"(38.1mm) 内径 - 恢复后:0.752"(19.1mm) 恢复后的壁厚:0.040"(1.02mm) 材料:聚烯烃(PO) 特性:自熄灭 颜色:黑 工作温度:-55°C ~ 135°C 收缩温度:121°C 标准包装:1
CP-221 1 1/2"BL 100' 制造商:3M Electronic Products Division 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3M Electronic Products Division 功能描述:HEATSHRNK CP221 1-1/2" X 25' BLK