CP2201-GM (Silicon) PDF资料下载 Datasheet(97/108 页)

您现在的位置：买卖IC网 > PDF目录11590 > CP2201-GM (Silicon Laboratories Inc)IC ETH CTRLR SNGL-CHIP 28QFN PDF资料下载

参数资料

型号：	CP2201-GM
厂商：	Silicon Laboratories Inc
文件页数：	97/108页
文件大小：	0K
描述：	IC ETH CTRLR SNGL-CHIP 28QFN
标准包装：	73
控制器类型：	以太网控制器，MAC/10Base-T
接口：	并行/串行
电源电压：	3.1 V ~ 3.6 V
电流 - 电源：	75mA
工作温度：	-40°C ~ 85°C
安装类型：	表面贴装
封装/外壳：	28-VFQFN 裸露焊盘
供应商设备封装：	28-QFN（5x5）
包装：	管件
产品目录页面：	627 (CN2011-ZH PDF)
配用：	336-1326-ND - KIT REF DESIGN PWR OVER ETHERNET 336-1316-ND - KIT EVAL FOR CP2201 ETH CTRLR
其它名称：	336-1313

CP2200/1

Rev. 1.0

15.3. Loopback Mode

Loopback Mode provides the ability to transfer data from the physical layer’s output directly to it’s input to aid in

system debugging. When PHYCN.3 is set to ‘1’, transmit data is looped back to the receiver via an internal analog

path. The transmit drivers and receive input circuitry are bypassed, isolating the device from the network. This

prevents network traffic from affecting the result of any system self-tests and guarantees a collision-free

environment.

15.4. Link Integrity Function

The Link Integrity function provides the ability to detect and respond to a 10 BASE-T link failure. When such a

failure is detected, the transmitter and receiver are automatically disabled, and the state of the link is reported in

LINKSTA (PHYCN.0). The host can disable the link integrity function by clearing LINKINT (PHYCF.6) to ‘0’. When

the link integrity function is disabled, the physical layer will operate regardless of the presence of link pulses.

15.5. Receiver Smart Squelch and Automatic Polarity Correction

The physical layer receiver can detect and correct for noise or incorrect polarity of the received signal. If the

receiver Smart Squelch feature is enabled by setting SMSQ (PHYCF.7) to ‘1’, the receiver circuitry performs a

combination of amplitude and timing measurements (in accordance with IEEE 802.3) to determine the validity of

received data. This prevents noise from falsely triggering the receiver in the absence of valid data.

Automatic polarity correction can automatically detect and correct the polarity of the received data to compensate

for a wiring error at either end of the 10 BASE-T cable. When automatic polarity correction is enabled by setting

AUTOPOL (PHYCF.1) to ‘1’, the polarity of the receive data is indicated in POLREV (PHYCN.1). When automatic

polarity detection is disabled, the polarity of the receive data can be manually reversed by setting REVPOL

(PHYCF.0) to ‘1’.

15.6. Transmitter Jabber Function

Provides the ability to automatically disable the transmitter if software attempts to transmit a packet longer than the

maximum allowed packet length (per IEEE 802.3). The host processor will be notified via the Jabber Detected

Interrupt if a jabber condition is automatically handled by the hardware. Enabling the jabber function is

recommended to ensure that the embedded system using the CP2200/1 for Ethernet communication does not

generate a jabber condition on the wire.

相关代理商/技术参数	参数描述
CP2201-GMR	功能描述:以太网 IC Ethernet Controller RoHS:否制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray
CP-220-K	制造商:PREMO 制造商全称:PREMO CORPORATION S.L 功能描述:Coils and Chokes for general use
CP221	制造商:CENTRAL 制造商全称:Central Semiconductor Corp 功能描述:Small Signal Transistor
CP-221 1 1/2"BL 100'	功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3m 系列:CP-221 零件状态:过期类型:套管，弹性收缩率:2 至 1 长度:100'（30.48m）内径（出厂）:1.500"（38.1mm）内径 - 恢复后:0.752"（19.1mm）恢复后的壁厚:0.040"（1.02mm）材料:聚烯烃（PO）特性:自熄灭颜色:黑工作温度:-55°C ~ 135°C 收缩温度:121°C 标准包装:1
CP-221 1 1/2"BL 100'	制造商:3M Electronic Products Division 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3M Electronic Products Division 功能描述:HEATSHRNK CP221 1-1/2" X 25' BLK

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购