参数资料
型号: HMC703LP4E
厂商: Hittite Microwave Corporation
文件页数: 30/58页
文件大小: 0K
描述: IC FRACT-N PLL W/SWEEPR 24QFN
标准包装: 1
类型: 整数 N/小数 N 分频
PLL:
输入: CMOS
输出: CMOS
电路数: 1
比率 - 输入:输出: 1:1
差分 - 输入:输出: 是/无
频率 - 最大: 8GHz
除法器/乘法器: 是/无
电源电压: 3.3V,5V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 24-VQFN 裸露焊盘
供应商设备封装: 24-QFN 裸露焊盘(4x4)
包装: 标准包装
其它名称: 1127-1065-6
p
ll
s
-
s
M
T
6 - 36
HMC703LP4E
v02.0813
8 GHz fractional syntHesizer
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
978-250-3343 978-250-3373 fax Order On-line at www.hittite.com
Application Support: pll@hittite.com
Figure 39. Charge Pump Gain and Offset Control - Reg09h
seed register and autoseed Mode
The start phase of the fractional modulator digital phase accumulator (DPA) may be set to any values via the
seed register Reg 05h. If autoseed Reg 06h[8] is set, then the PLL will automatically reload the start phase from
Reg 05h[23:0] into the DPA every time a new fractional frequency is selected. If autoseed is not set, then the PLL will
start new fractional frequencies with the value left in the DPA from the last frequency. Hence the start phase will
effectively be random. Certain zero or binary seed values may cause spurious energy correlation at specific
frequencies. Correlated spurs are advantageous only in very special cases where the spurious are known to be far out
of band and are removed in the loop filter. For most cases a pseudo-random seed setting is recommended. Further,
since the autoseed always starts the accumulators at the same place, performance is repeatable if autoseed is used.
Reg 05h’s default value typically provides good performance.
Power on reset
The HMC703LP4E features a hardware Power on Reset (POR) on the digital supply DVDD. All chip registers will be
reset to default states approximately 250 s after power up of DVDD. Once the supply is fully up, if the power supply
then drops below 0.5 V the digital portion will reset. Note that the sPI control inputs must also be 0 at power-down,
otherwise they will inadvertently power the chip via the EsD protection network.
Power Down Mode
Hardware Power Down
Chip enable may be controlled from the hardware CEN pin 23, or it may be controlled from the serial port. Reg 01h[0] =1
assigns control to the CEN pin. Reg 01h[0] =0 assigns control to the serial port Reg 01h[1]. For hardware test reasons or
some special applications it is possible to force certain blocks to remain on inside the chip , even if the chip is disabled.
see the register Reg 01h description for more details.
chip identification
Version information may be read from the synthesizer by reading the content of chip_ID in Reg 00h.
相关PDF资料
PDF描述
HMC704LP4E IC FRACT-N PLL 16BIT 24QFN
HMC830LP6GE IC FRACT-N PLL W/VCO 40QFN
HMP8117CNZ IC VIDEO DECODER NTSC/PAL 80PQFP
HMP8156ACNZ IC VIDEO ENCODER NTSC/PAL 64MQFP
HSP45102SC-40Z IC OSC NCO 40MHZ 28-SOIC
相关代理商/技术参数
参数描述
HMC703LP4ETR 制造商:Hittite Microwave Corp 功能描述:IC FRACT-N PLL W/SWEEPR 24QFN 制造商:Hittite Microwave Corp 功能描述:8 GHz Fractional-N PLL with Sweeper
HMC7043LP7FE 功能描述:IC FRACT-N PLL W/SWEEPR 48LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:新产品 类型:* PLL:是 输入:时钟 输出:CML,LVDS,LVPECL 电路数:1 比率 - 输入:输出:1:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘,CSP 供应商器件封装:48-LFCSP(7x7) 标准包装:1
HMC7043LP7FETR 功能描述:IC FRACT-N PLL W/SWEEPR 48LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:在售 类型:时钟缓冲器 PLL:是 输入:时钟 输出:CMOS,LVDS,LVPECL 电路数:1 比率 - 输入:输出:1:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘,CSP 供应商器件封装:48-LFCSP(7x7) 标准包装:1
HMC7044LP10BETR 功能描述:IC JITTER ATTENUATOR 68LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:在售 类型:漂移衰减器 PLL:是 输入:CML,CMOS,LVDS,LVPECL 输出:CML,LVDS,LVPECL 电路数:1 比率 - 输入:输出:4:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:68-VFQFN 裸露焊盘,CSP 供应商器件封装:68-LFCSP-VQ(10x10) 标准包装:1
HMC704LP4E 功能描述:IC FRACT-N PLL 16BIT 24QFN RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:2,000 系列:- 类型:PLL 频率合成器 PLL:是 输入:晶体 输出:时钟 电路数:1 比率 - 输入:输出:1:1 差分 - 输入:输出:无/无 频率 - 最大:1GHz 除法器/乘法器:是/无 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-LSSOP(0.175",4.40mm 宽) 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:NJW1504V-TE1-NDNJW1504V-TE1TR