参数资料
型号: HMC703LP4E
厂商: Hittite Microwave Corporation
文件页数: 9/58页
文件大小: 0K
描述: IC FRACT-N PLL W/SWEEPR 24QFN
标准包装: 1
类型: 整数 N/小数 N 分频
PLL:
输入: CMOS
输出: CMOS
电路数: 1
比率 - 输入:输出: 1:1
差分 - 输入:输出: 是/无
频率 - 最大: 8GHz
除法器/乘法器: 是/无
电源电压: 3.3V,5V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 24-VQFN 裸露焊盘
供应商设备封装: 24-QFN 裸露焊盘(4x4)
包装: 标准包装
其它名称: 1127-1065-6
P
LL
s
-
s
M
T
6 - 17
HMC703LP4E
v02.0813
8 GHz fractional syntHesizer
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
978-250-3343 978-250-3373 fax Order On-line at www.hittite.com
Application Support: pll@hittite.com
Figure 28.
-180
-160
-140
-120
-100
-80
-60
-40
-20
100
1000
10
4
10
5
10
6
10
7
10
8
PH
ASE
N
O
ISE
(d
Bc
/H
z
)
FREQUENCY OFFSET (Hz)
PLL at 1 kHz
VCO at 1 kHz
PLL Floor
VCO at 1 MHz
Figure of Merit Example
It should be noted that actual phase noise near the corner frequency of the loop bandwidth is affected by loop parame-
ters and one should use a more complete design tool such as Hittite PLL Design for better estimates of the phase noise
performance. Noise models for each of the components in Hittite PLL Design can be derived from the FOM equations
or can be provided by Hittite applications engineering.
spurious Performance
integer operation
The VCO always operates at an integer multiple of the PD frequency in an integer synthesizer. In general, spurious
signals originating from an integer synthesizer can only occur at multiples of the PD frequency. These unwanted outputs
are often simply referred to as reference sidebands.
spurs unrelated to the reference frequency must originate from outside sources. External spurious sources can
modulate the VCO indirectly through power supplies, ground, or output ports, or bypass the loop filter due to poor
isolation of the filter. It can also simply add to the output of the synthesizer.
The HMC703LP4E has been designed and tested for ultra-low spurious performance. Reference spurious levels are
typically below -100 dBc with a well designed board layout. A regulator with low noise and high power supply rejection,
such as the HMC860LP3E, is recommended to minimize external spurious sources.
Reference spurious levels of below -100 dBc require superb board isolation of power supplies, isolation of the VCO
from the digital switching of the synthesizer and isolation of the VCO load from the synthesizer. Typical board layout,
regulator design, demo boards and application information are available for very low spurious operation. Operation
with lower levels of isolation in the application circuit board, from those recommended by Hittite, can result in higher
spurious levels.
Of course, if the application environment contains other interfering frequencies unrelated to the PD frequency, and if
the application isolation from the board layout and regulation are insufficient, then the unwanted interfering frequencies
will mix with the desired synthesizer output and cause additional spurs. The level of these spurs is dependant upon
isolation and supply regulation or rejection (PsRR).
相关PDF资料
PDF描述
HMC704LP4E IC FRACT-N PLL 16BIT 24QFN
HMC830LP6GE IC FRACT-N PLL W/VCO 40QFN
HMP8117CNZ IC VIDEO DECODER NTSC/PAL 80PQFP
HMP8156ACNZ IC VIDEO ENCODER NTSC/PAL 64MQFP
HSP45102SC-40Z IC OSC NCO 40MHZ 28-SOIC
相关代理商/技术参数
参数描述
HMC703LP4ETR 制造商:Hittite Microwave Corp 功能描述:IC FRACT-N PLL W/SWEEPR 24QFN 制造商:Hittite Microwave Corp 功能描述:8 GHz Fractional-N PLL with Sweeper
HMC7043LP7FE 功能描述:IC FRACT-N PLL W/SWEEPR 48LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:新产品 类型:* PLL:是 输入:时钟 输出:CML,LVDS,LVPECL 电路数:1 比率 - 输入:输出:1:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘,CSP 供应商器件封装:48-LFCSP(7x7) 标准包装:1
HMC7043LP7FETR 功能描述:IC FRACT-N PLL W/SWEEPR 48LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:在售 类型:时钟缓冲器 PLL:是 输入:时钟 输出:CMOS,LVDS,LVPECL 电路数:1 比率 - 输入:输出:1:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘,CSP 供应商器件封装:48-LFCSP(7x7) 标准包装:1
HMC7044LP10BETR 功能描述:IC JITTER ATTENUATOR 68LFCSP 制造商:analog devices inc. 系列:- 包装:剪切带(CT) 零件状态:在售 类型:漂移衰减器 PLL:是 输入:CML,CMOS,LVDS,LVPECL 输出:CML,LVDS,LVPECL 电路数:1 比率 - 输入:输出:4:14 差分 - 输入:输出:是/是 频率 - 最大值:3.2GHz 分频器/倍频器:是/无 电压 - 电源:3.135 V ~ 3.465 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:68-VFQFN 裸露焊盘,CSP 供应商器件封装:68-LFCSP-VQ(10x10) 标准包装:1
HMC704LP4E 功能描述:IC FRACT-N PLL 16BIT 24QFN RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:2,000 系列:- 类型:PLL 频率合成器 PLL:是 输入:晶体 输出:时钟 电路数:1 比率 - 输入:输出:1:1 差分 - 输入:输出:无/无 频率 - 最大:1GHz 除法器/乘法器:是/无 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-LSSOP(0.175",4.40mm 宽) 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:NJW1504V-TE1-NDNJW1504V-TE1TR