- 您现在的位置：买卖IC网 > PDF目录45186 > MB89PV950CF 8-BIT, 5 MHz, MICROCONTROLLER, CQFP64 PDF资料下载
参数资料
| 型号： | MB89PV950CF |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 5 MHz, MICROCONTROLLER, CQFP64 |
| 封装： | 0.80 MM PITCH, PIGGY BACK, MQFP-64 |
| 文件页数： | 19/110页 |
| 文件大小： | 619K |
| 代理商： | MB89PV950CF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页
GENERAL
1– 12
1.6
Handling Devices
(1) Preventing latch-up
Latchup may occur on CMOS ICs if voltage higher than VCC or lower than VSS is applied to input and output
pins other than medium to high-voltage pins or if higher than the voltage which shows on Absolute Maximum
Ratings is applied between VCC and VSS.
When latch-up occurs, supply current increases rapidly and might thermally damage elements. When using,
take great care not to exceed the absolute maximum ratings.
(2) Treatment of Unused Input Pins
Leaving unused input pins open could cause malfunctions. They should be connected to pull-up or pull-
down resistor.
(3) Power Supply Voltage Fluctuations
Although VCC power supply voltage is assured to operate within the rated, a rapid change to the IC is therefore
cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied of the IC is therefore
important. As stabilization guidelines, it is recommended to control power so that VCC ripple fluctuations
(P-P. value) will be less that 10% of the standard VCC value at the commercial frequency (50 to 60 Hz) and
the transient fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when
power is switched.
(4) Precaution When Using an External Clock
Even when an external clock is used, oscillation stabilization time is required for power-on reset (option
selection) and release from stop mode.
(5) Recommended Screening Conditions
The OTPROM product should be screened by high-temperature aging before mounting.
The programming test cannot be performed for all bits of the preprogrammed OTPROM product due to its
characteristics. Consequently, 100% programming yielding cannot be ensured.
Verify program
High-temperature aging (150
°C, 48H)
Read
Mount
相关PDF资料 |
PDF描述 |
|---|---|
| MB89951PFM | 8-BIT, MROM, 5 MHz, MICROCONTROLLER, PQFP64 |
| MB89T623PFM | 8-BIT, 10 MHz, MICROCONTROLLER, PQFP64 |
| MB89623RP-SH | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89625RPFV | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP64 |
| MB89W627C-SH | 8-BIT, UVPROM, 10 MHz, MICROCONTROLLER, CDIP64 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MB89PV960 | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV980-101 | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PV980-201 | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89PW625 | 制造商:FUJITSU 制造商全称:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89R112B1QN-G-AMERE1 | 制造商:FUJITSU 功能描述: |
发布紧急采购，3分钟左右您将得到回复。