参数资料
型号: MC34708VM
厂商: Freescale Semiconductor
文件页数: 66/159页
文件大小: 0K
描述: IC POWER MANAGEMENT 206MAPBGA
标准包装: 160
应用: 通用
电源电压: 1.8 V ~ 4.5 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 206-LFBGA
供应商设备封装: 206-MAPBGA(13x13)
包装: 托盘
Functional Block Description
7.5.6.2
LDO Regulator Control
The regulators with embedded pass devices (VPLL, VGEN1, and VUSB) have an adaptive biasing scheme thus, there are no
distinct operating modes such as a Normal mode and a Low Power mode. Therefore, no specific control is required to put these
regulators in a Low Power mode.
The external pass regulator (VDAC) can also operate in a normal and low power mode. However, since a load current detection
cannot be performed for this regulator, the transition between both modes is not automatic and is controlled by setting the
corresponding mode bits for the operational behavior desired.
The regulators VUSB2, and VGEN2 can be configured for using the internal pass device or external pass device as explained in
Supplies. For both configurations, the transition between both modes is controlled by setting the VxMODE bit for the specific
regulator. Therefore, depending on the configuration selected, the automatic Low Power mode determines availability.
The regulators can be disabled and the general purpose outputs can be forced low when going into Standby (note that the
Standby response timing can be altered with the STBYDLY function, as described in the previous section). Each regulator has
an associated SPI bit for this. When the bit is not set, STANDBY is of no influence. The actual operating mode of the regulators
as a function of STANDBY is not reflected through SPI. In other words, the SPI will read back what is programmed, not the actual
state.
Table 54. LDO Regulator Control (external pass device LDOs)
VxEN
0
1
1
1
1
1
VxMODE
X
0
1
X
0
1
VxSTBY
X
0
0
1
1
1
STANDBY (59)
X
X
X
0
1
1
Regulator Vx
Off
On
Low Power
On
Off
Low Power
Notes
59. STANDBY refers to a Standby event as described earlier
For regulators with internal pass devices, the previous table can be simplified by elimination of the VxMODE column.
Table 55. LDO Regulator Control (internal pass device LDOs)
VxEN
0
1
1
1
VxSTBY
X
0
1
1
STANDBY (60)
X
X
0
1
Regulator Vx
Off
On
On
Off
Notes
60. STANDBY refers to a Standby event as described earlier
7.5.6.3
Transient Response Waveforms
The transient load and line response are specified with the waveforms as depicted in Figure 18 . Note that where the transient
load response refers to the overshoot only, so excluding the DC shift itself, the transient line response refers to the sum of both
overshoot and DC shift. This is also valid for the mode transition response.
MC34708
Analog Integrated Circuit Device Data ?
Freescale Semiconductor
66
相关PDF资料
PDF描述
MC34710EWR2 IC PWR SUPPLY ADJ DUAL SW 32SOIC
MC34712EPR2 IC CONVERTER DDR 24QFN
MC34713EPR2 IC CONVERTER DDR 24QFN
MC34716EPR2 IC CONVERTER DDR 26QFN
MC34717EPR2 IC CONVERTER DDR 26QFN
相关代理商/技术参数
参数描述
MC34708VMR2 功能描述:PMIC 解决方案 PMIC 5S 6LDO BST 10BTADC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
MC34709 制造商:SPC Multicomp 功能描述:HEADER R/ANGLE 12WAY 制造商:SPC Multicomp 功能描述:HEADER, R/ANGLE, 12WAY 制造商:SPC Multicomp 功能描述:WIRE-BOARD CONN, RECEPTACLE, 12POS, 3MM; Series:2261(5561); Pitch Spacing:3mm; Contact Termination:Through Hole Right Angle; No. of Contacts:12; No. of Rows:2; Connector Mounting:PCB; Gender:Receptacle; Contact Material:Copper Alloy ;RoHS Compliant: Yes
MC34709VK 功能描述:PMIC 解决方案 PMIC 5SW, 6 LDO BST, 10 Bit ADC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
MC34709VKR2 功能描述:PMIC 解决方案 PMIC 5SW, 6 LDO BST, 10 Bit ADC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
MC3470N 制造商:Texas Instruments 功能描述: