- 您现在的位置：买卖IC网 > PDF目录45388 > MSC7119VM1200 (FREESCALE SEMICONDUCTOR INC) 0-BIT, 300 MHz, OTHER DSP, PBGA400 PDF资料下载
参数资料
| 型号： | MSC7119VM1200 |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 数字信号处理 |
| 英文描述： | 0-BIT, 300 MHz, OTHER DSP, PBGA400 |
| 封装： | LEAD FREE, MAPBGA-400 |
| 文件页数： | 52/60页 |
| 文件大小： | 1138K |
| 代理商： | MSC7119VM1200 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页当前第52页第53页第54页第55页第56页第57页第58页第59页第60页
MSC7119 Data Sheet, Rev. 8
Hardware Design Considerations
Freescale Semiconductor
56
3.5.3
General Routing
The general routing considerations for the DDR are as follows:
All DDR signals must be routed next to a solid reference:
— For data, next to solid ground planes.
— For address/command, power planes if necessary.
All DDR signals must be impedance controlled. This is system dependent, but typical values are 50–60 ohm.
Minimize other cross-talk opportunities. As possible, maintain at least a four times the trace width spacing between all
DDR signals to non-DDR signals.
Keep the number of vias to a minimum to eliminate additional stubs and capacitance.
Signal group routing priorities are as follows:
— DDR clocks.
— Route MVTT/MVREF.
— Data group.
— Command/address.
Minimize data bit jitter by trace matching.
3.5.4
Routing Clock Distribution
The DDR clock distribution considerations are as follows:
DDR controller supports six clock pairs:
— 2 DIMM modules.
— Up to 36 discrete chips.
For route traces as for any other differential signals:
— Maintain proper difference pair spacing.
— Match pair traces within 25 mm.
Match all clock traces to within 100 mm.
Keep all clocks equally loaded in the system.
Route clocks on inner critical layers.
3.5.5
Data Routing
The DDR data routing considerations are as follows:
Route each data group (8-bits data + DQS + DM) on the same layer. Avoid switching layers within a byte group.
Take care to match trace lengths, which is extremely important.
To make trace matching easier, let adjacent groups be routed on alternate critical layers.
Pin swap bits within a byte group to facilitate routing (discrete case).
Tight trace matching is recommended within the DDR data group. Keep each 8-bit datum and its DM signal within ±
25 mm of its respective strobe.
Minimize lengths across the entire DDR channel:
— Between all groups maintain a delta of no more than 500 mm.
— Allows greater flexibility in the design for readjustments as needed.
DDR data group separation:
— If stack-up allows, keep DDR data groups away from the address and control nets.
— Route address and control on separate critical layers.
— If resistor networks (RNs) are used, attempt to keep data and command lines in separate packages.
相关PDF资料 |
PDF描述 |
|---|---|
| MSC8102M4000 | 32-BIT, 75 MHz, OTHER DSP, CBGA431 |
| MSC8122TVT6400 | 32-BIT, 400 MHz, OTHER DSP, PBGA431 |
| MSC8122TVT4800V | 32-BIT, 300 MHz, OTHER DSP, PBGA431 |
| MSC8122MP8000 | 32-BIT, 500 MHz, OTHER DSP, PBGA431 |
| MSC8144ETVT800B | 133 MHz, OTHER DSP, PBGA783 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MSC711XADS | 功能描述:开发板和工具包 - 其他处理器 DEV SYS FOR FSL 711X DEV RoHS:否 制造商:Freescale Semiconductor 产品:Development Systems 工具用于评估:P3041 核心:e500mc 接口类型:I2C, SPI, USB 工作电源电压: |
| MSC711XEVM | 功能描述:开发板和工具包 - 其他处理器 EVAL KIT W/FULL LIC CW RoHS:否 制造商:Freescale Semiconductor 产品:Development Systems 工具用于评估:P3041 核心:e500mc 接口类型:I2C, SPI, USB 工作电源电压: |
| MSC711XEVMT | 功能描述:KIT EVAL W/FULL LIC CW RoHS:是 类别:编程器，开发系统 >> 过时/停产零件编号 系列:* 标准包装:1 系列:- 传感器类型:CMOS 成像，彩色（RGB） 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| MSC7121VRF | 制造商:Freescale Semiconductor 功能描述:GPON UMC 140 MHZ - Trays |
| MSC7128 | 制造商:OKI 制造商全称:OKI electronic componets 功能描述:5 x 7-Dot Character x 16-Digit Display Controller/Driver |
发布紧急采购，3分钟左右您将得到回复。