- 您现在的位置：买卖IC网 > PDF目录385639 > MT46V64M8 (Micron Technology, Inc.) 16 Meg x 8 x 4 banks DDR SDRAM(16M x 8 x 4组,双数据速率同步动态RAM) PDF资料下载
参数资料
| 型号： | MT46V64M8 |
| 厂商： | Micron Technology, Inc. |
| 英文描述： | 16 Meg x 8 x 4 banks DDR SDRAM(16M x 8 x 4组,双数据速率同步动态RAM) |
| 中文描述： | 16梅格× 8 × 4银行DDR SDRAM内存（1,600 × 8 × 4组，双数据速率同步动态RAM）的 |
| 文件页数： | 42/70页 |
| 文件大小： | 2524K |
| 代理商： | MT46V64M8 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页当前第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页
42
512Mb: x4, x8, x16 DDR SDRAM
512Mx4x8x16DDR_A.p65
–
Rev. A; Pub 10/00
Micron Technology, Inc., reserves the right to change products or specifications without notice.
2000, Micron Technology, Inc.
512Mb: x4, x8, x16
DDR SDRAM
ADVANCE
NOTE (continued):
3.Current state definitions:
Idle: The bank has been precharged, and
t
RP has been met.
Row Active: A row in the bank has been activated, and
t
RCD has been met. No data bursts/accesses
and no register accesses are in progress.
Read: A READ burst has been initiated, with auto precharge disabled, and has not yet
terminated or been terminated.
Write: A WRITE burst has been initiated, with auto precharge disabled, and has not yet
terminated or been terminated.
Read with Auto
Precharge Enabled: See following text
–
3a
Write with Auto
Precharge Enabled: See following text
–
3a
3a. The read with auto precharge enabled or write with auto precharge enabled states can each be
broken into two parts: the access period and the precharge period. For read with auto precharge,
the precharge period is defined as if the same burst was executed with auto precharge disabled and
then followed with the earliest possible PRECHARGE command that still accesses all of the data in
the burst. For write with auto precharge, the precharge period begins when
t
WR ends, with
t
WR
measured as if auto precharge was disabled. The access period starts with registration of the
command and ends where the precharge period (or
t
RP) begins.
During the precharge period of the read with auto precharge enabled or write with auto precharge
enabled states, ACTIVE, PRECHARGE, READ and WRITE commands to the other bank may be
applied; during the access period, only ACTIVE and PRECHARGE commands to the other bank may
be applied. In either case, all other related limitations apply (e.g., contention between read data
and write data must be avoided).
This means concurrent auto precharge is not supported.
4. AUTO REFRESH and LOAD MODE REGISTER commands may only be issued when all banks are idle.
5. A BURST TERMINATE command cannot be issued to another bank; it applies to the bank represented by
the current state only.
6. All states and sequences not shown are illegal or reserved.
7. READs or WRITEs listed in the Command/Action column include READs or WRITEs with auto precharge
enabled and READs or WRITEs with auto precharge disabled.
8. Requires appropriate DM masking.
9. A WRITE command may be applied after the completion of the READ burst; otherwise, a BURST TERMI-
NATE must be used to end the READ burst prior to asserting a WRITE command.
相关PDF资料 |
PDF描述 |
|---|---|
| MT48LC16M8A1TG | SYNCHRONOUS DRAM |
| MT48LC32M4A1 | ECONOLINE: RSZ/P - 1kVDC |
| MT48LC32M4A2 | SYNCHRONOUS DRAM |
| MT48LC32M4A1TG | SYNCHRONOUS DRAM |
| MT48LC8M16A1TG | SYNCHRONOUS DRAM |
相关代理商/技术参数 |
参数描述 |
|---|
发布紧急采购，3分钟左右您将得到回复。