- 您现在的位置：买卖IC网 > PDF目录11732 > ORSO42G5-2BMN484I (Lattice Semiconductor Corporation)IC TRANCEIVERS FPSC 680FPGAM PDF资料下载
参数资料
| 型号： | ORSO42G5-2BMN484I |
| 厂商： | Lattice Semiconductor Corporation |
| 文件页数： | 118/153页 |
| 文件大小： | 0K |
| 描述： | IC TRANCEIVERS FPSC 680FPGAM |
| 产品变化通告： | Product Discontinuation 01/Aug/2011 |
| 标准包装： | 60 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页当前第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页
Lattice Semiconductor
ORCA ORSO42G5 and ORSO82G5 Data Sheet
67
Reference Clock Requirements
There are two pairs of reference clock inputs in the ORSO42G5 and ORSO82G5 devices. Each reference clock is
distributed to all channels in a block. Each channel has a differential buffer to isolate the clock from the other chan-
nels. The input clock is preferably a differential signal; however, the device can operate with a single-ended input.
The input reference clock directly impacts the transmit data eye, so the clock should have low jitter. In particular, jit-
ter components in the DC to 5 MHz range should be minimized. The required electrical characteristics for the refer-
ence clock are given in Table 46.
Synthesized and Recovered Clocks
The SERDES Embedded Core block contains its own dedicated PLLs for transmit and receive clock generation.
The user provides a reference clock of the appropriate frequency, as described in the previous section. The trans-
mitter PLL uses the REFCLK_[A,B] inputs to synthesize the internal high-speed serial bit clocks. The receiver PLLs
extract the clock from the serial input data and retime the data with the recovered clock.
The receive PLL for each channel has two modes of operation - lock to reference and lock to data with retiming.
When no data or invalid data is present on the HDINP_xx and HDINN_xx pins, the receive VCO will not lock to data
and its frequency can drift outside of the nominal ±100 ppm range. Under this condition, the receive PLL will lock to
REFCLK_[A,B] for a xed time interval and then will attempt to lock to receive data. The process of attempting to
lock to data, then locking to clock will repeat until valid input data exists. There is also a control register bit per
channel to force the receive PLL to always lock to the reference clock.
The high-speed transmit and receive serial data links can run at 0.6 to 2.7 Gbps, depending on the frequency of the
reference clock and the state of the control bits from the internal transmit control register. The interface to the seri-
alizer/deserializer block runs at 1/8th the bit rate of the data lane. Additionally, the MUX/DEMUX logic converts the
data rate and bit-width so the FPGA core can run at 1/4th this frequency which gives a range of 18.8 to 84.4 MHz
for the data in and out of the FPGA in SONET mode. In cell mode, there is a clock domain transfer to a 2x clock
domain, which gives a range of 37.5 to 168.8 MHz for the data in and out of the FPGA.
Internal Clock Signals at the FPGA/Core Interface
There are several clock signals dened at the FPGA/Embedded Core interface in addition to the external reference
clock for each SERDES block. All of the ORSO42G5 and ORSO82G5 clock signals are shown in Figure 47 and are
described following the gure.
相关PDF资料 |
PDF描述 |
|---|---|
| ORSO42G5-1BMN484C | IC TRANCEIVERS FPSC 680FPGAM |
| VE-B03-IX-F1 | CONVERTER MOD DC/DC 24V 75W |
| MS27467T25A61PA | CONN PLUG 61POS STRAIGHT W/PINS |
| MS27467E25A61PA | CONN PLUG 61POS STRAIGHT W/PINS |
| MS27467E25B61PC | CONN PLUG 61POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ORSO42G5-3BM484C | 功能描述:FPGA - 现场可编程门阵列 10368 LUT 204 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 栅极数量: 逻辑块数量:943 内嵌式块RAM - EBR:1956 kbit 输入/输出端数量:128 最大工作频率:800 MHz 工作电源电压:1.1 V 最大工作温度:+ 70 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-256 |
| ORSO42G5-3BMN484C | 功能描述:FPGA - 现场可编程门阵列 10368 LUT 204 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 栅极数量: 逻辑块数量:943 内嵌式块RAM - EBR:1956 kbit 输入/输出端数量:128 最大工作频率:800 MHz 工作电源电压:1.1 V 最大工作温度:+ 70 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-256 |
| ORSO42G5-EV | 功能描述:可编程逻辑 IC 开发工具 Eval Brd ORSO42G5 RoHS:否 制造商:Altera Corporation 产品:Development Kits 类型:FPGA 工具用于评估:5CEFA7F3 接口类型: 工作电源电压: |
| ORSO82G5 | 制造商:LATTICE 制造商全称:Lattice Semiconductor 功能描述:0.6 to 2.7 Gbps SONET Backplane Interface FPSCs |
| ORSO82G5-1BM680C | 功能描述:FPGA - 现场可编程门阵列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 栅极数量: 逻辑块数量:943 内嵌式块RAM - EBR:1956 kbit 输入/输出端数量:128 最大工作频率:800 MHz 工作电源电压:1.1 V 最大工作温度:+ 70 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-256 |
发布紧急采购，3分钟左右您将得到回复。