- 您现在的位置：买卖IC网 > PDF目录69322 > RJ80530GZ933512 (INTEL CORP) 32-BIT, 933 MHz, MICROPROCESSOR, PBGA479 PDF资料下载
参数资料
| 型号： | RJ80530GZ933512 |
| 厂商： | INTEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 933 MHz, MICROPROCESSOR, PBGA479 |
| 封装： | MICRO, FCBGA-479 |
| 文件页数： | 92/92页 |
| 文件大小： | 1750K |
| 代理商： | RJ80530GZ933512 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页当前第92页
Mobile Intel
Pentium III Processor-M Datasheet
92
Datasheet
298340-003
Table 51. PLL Filter Resistor Recommendations
Resistor
Part Number
Value
Tolerance
Power
R1
Various
1
10%
1/16W
To satisfy damping requirements, total series resistance in the filter (from VCCT to the top plate of the
capacitor) must be at least 0.35
. This resistor can be in the form of a discrete component, or routing,
or both. For example, if the picked inductor has minimum DCR of 0.25
, then a routing resistance of
at least 0.10
is required. Be careful not to exceed the maximum resistance rule (2). For example, if
using discrete R1, the maximum DCR of the L should be less than 2.0 - 1.1 = 0.9
, which precludes
using L2 and possibly L1.
Other routing requirements include:
The capacitor should be close to the PLL1 and PLL2 pins, with less than 0.1 per route (These
routes do not count towards the minimum damping resistance requirement).
The PLL2 route should be parallel and next to the PLL1 route (minimize loop area).
The inductor should be close to the capacitor; any routing resistance should be inserted between
VCCT and the inductor.
Any discrete resistor should be inserted between VCCT and the inductor.
A4.
Comments
A magnetically shielded inductor protects the circuit from picking up external flux noise. This
should provide better timing margins than with an unshielded inductor.
A discrete or routed resistor is required because the LC filter by nature has an under-damped
response, which can cause resonance at the LC pole. Noise amplification at this band, although
not in the PLL-sensitive spectrum, could cause a fatal headroom reduction for analog circuitry.
The resistor serves to dampen the response. Systems with tight space constraints should consider
a discrete resistor to provide the required damping resistance. Too large of a damping resistance
can cause a large IR drop, which means less analog headroom and lower frequency.
Ceramic capacitors have very high self-resonance frequencies, but they are not available in large
capacitance values. A high self-resonant frequency coupled with low ESL/ESR is crucial for
sufficient rejection in the PLL and high frequency band. The recommended tantalum capacitors
have acceptably low ESR and ESL.
The capacitor must be close to the PLL1 and PLL2 pins; otherwise the value of the low ESR
tantalum capacitor is wasted. Note the distance constraint should be translated from the 0.1-
requirement.
相关PDF资料 |
PDF描述 |
|---|---|
| RJ80536VC001512M | 1000 MHz, MICROPROCESSOR, PBGA479 |
| RJ80536NC0211M | 1500 MHz, MICROPROCESSOR, PBGA479 |
| RK80530KZ006512 | 32-BIT, 1133 MHz, MICROPROCESSOR, CPGA370 |
| RK80530KZ017512 | 32-BIT, 1400 MHz, MICROPROCESSOR, CPGA370 |
| RK80532EC056512 | 2400 MHz, MICROPROCESSOR, CPGA604 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| RJ80530KZ001512 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intel 功能描述: |
| RJ80530KZ001512S L6QU | 制造商:Intel 功能描述:32BIT MPU 80530KZ001512 1.00G |
| RJ80530KZ800512 | 制造商:Rochester Electronics LLC 功能描述:PIII PROCESSOR LV, 800MHZ, 512K, PBGA - Bulk |
| RJ80530KZ800512S L66D | 制造商:Intel 功能描述:MPU Pentium? III Processor-S 32-Bit 0.13um 800MHz 479-Pin uFCBGA |
| RJ80530KZ800512S L6HC | 制造商:Intel 功能描述:MPU Pentium? III Processor-S 0.13um 800MHz 479-Pin uFCBGA |
发布紧急采购，3分钟左右您将得到回复。