- 您现在的位置：买卖IC网 > PDF目录69322 > RM48L950PGET (TEXAS INSTRUMENTS INC) 32-BIT, FLASH, 200 MHz, RISC MICROCONTROLLER, PQFP144 PDF资料下载
参数资料
| 型号： | RM48L950PGET |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, FLASH, 200 MHz, RISC MICROCONTROLLER, PQFP144 |
| 封装： | GREEN, PLASTIC, LQFP-144 |
| 文件页数： | 101/154页 |
| 文件大小： | 2807K |
| 代理商： | RM48L950PGET |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页当前第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页
PRODUCTPREVIEW
SPNS174
– SEPTEMBER 2011
3.10 Low-EMI Output Buffers
The low-EMI output buffer has been designed explicitly to address the issue of decoupling sources of
emissions from the pins which they drive. This is accomplished by adaptively controlling the impedance of
the output buffer, and is particularly effective with capacitive loads.
This is not the default mode of operation of the low-EMI output buffers and must be enabled by setting the
system module GPCR1 register for the desired module or signal, as shown in Table 3-6. The adaptive
impedance control circuit monitors the DC bias point of the output signal. The buffer internally generates
two reference levels, VREFLOW and VREFHIGH, which are set to approximately 10% and 90% of
VCCIO, respectively.
Once the output buffer has driven the output to a low level, if the output voltage is below VREFLOW, then
the output buffer
’s impedance will increase to hi-Z. A high degree of decoupling between the internal
ground bus and the output pin will occur with capacitive loads, or any load in which no current is flowing,
e.g. the buffer is driving low on a resistive path to ground. Current loads on the buffer which attempt to pull
the output voltage above VREFLOW will be opposed by the buffer
’s output impedance so as to maintain
the output voltage at or below VREFLOW.
Conversely, once the output buffer has driven the output to a high level, if the output voltage is above
VREFHIGH then the output buffer
’s impedance will again increase to hi-Z. A high degree of decoupling
between internal power bus ad output pin will occur with capacitive loads or any loads in which no current
is flowing, e.g. buffer is driving high on a resistive path to VCCIO. Current loads on the buffer which
attempt to pull the output voltage below VREFHIGH will be opposed by the buffer
’s output impedance so
as to maintain the output voltage at or above VREFHIGH.
The bandwidth of the control circuitry is relatively low, so that the output buffer in adaptive impedance
control mode cannot respond to high-frequency noise coupling into the buffer
’s power buses. In this
manner, internal bus noise approaching 20% peak-to-peak of VCCIO can be rejected.
Unlike standard output buffers which clamp to the rails, an output buffer in impedance control mode will
allow a positive current load to pull the output voltage up to VCCIO + 0.6V without opposition. Also, a
negative current load will pull the output voltage down to VSSIO
– 0.6V without opposition. This is not an
issue since the actual clamp current capability is always greater than the IOH / IOL specifications.
The low-EMI output buffers are automatically configured to be in the standard buffer mode when the
device enters a low-power mode.
Table 3-6. Low-EMI Output Buffer Hookup
Module or Signal Name
Control Register to Enable Low-EMI Mode
Module: MibSPI1
GPREG1.0
Module: SPI2
GPREG1.1
Module: MibSPI3
GPREG1.2
Reserved
GPREG1.3
Signal: TMS
GPREG1.8
Signal: TDI
GPREG1.9
Signal: TDO
GPREG1.10
Signal: RTCK
GPREG1.11
Signal: TEST
GPREG1.12
Signal: nERROR
GPREG1.13
Reserved
GPREG1.14
50
Device Operating Conditions
Copyright
2011, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| RM5261A-300H | 64-BIT, 300 MHz, MICROPROCESSOR, PQFP208 |
| RM54AC163SEA | AC SERIES, SYN POSITIVE EDGE TRIGGERED 4-BIT UP BINARY COUNTER, CDIP16 |
| RM54ACT175VFA | ACT SERIES, POSITIVE EDGE TRIGGERED D FLIP-FLOP, COMPLEMENTARY OUTPUT, CDFP16 |
| RM7965A-900UI | 64-BIT, 900 MHz, MICROPROCESSOR, PBGA256 |
| RN80532KC0371M | 1900 MHz, MICROPROCESSOR, CPGA603 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| RM48L950ZWTT | 制造商:Texas Instruments 功能描述:MCU 16-bit/32-bit RM48Lx50 ARM Cortex R4F RISC 3072KB Flash 1.2V/3.3V 337-Pin NFBGA 制造商:Texas Instruments 功能描述:16/32-Bit RISC Flash MCU |
| RM48L952DPGET | 功能描述:ARM? Cortex?-R4F Hercules? RM4 ARM? Cortex?-R4 Microcontroller IC 16/32-Bit 220MHz 3MB (3M x 8) FLASH 144-LQFP (20x20) 制造商:texas instruments 系列:Hercules? RM4 ARM? Cortex?-R4 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-R4F 核心尺寸:16/32-位 速度:220MHz 连接性:CAN，EBI/EMI，以太网，I2C，LIN，MibSPI，SCI，SPI，ART/USART，USB 外设:DMA，POR，PWM，WDT I/O 数:64 程序存储容量:3MB（3M x 8） 程序存储器类型:闪存 EEPROM 容量:64K x 8 RAM 容量:256K x 8 电压 - 电源（Vcc/Vdd）:1.14 V ~ 1.32 V 数据转换器:A/D 24x12b 振荡器类型:外部 工作温度:-40°C ~ 105°C（TA） 封装/外壳:144-LQFP 供应商器件封装:144-LQFP（20x20） 标准包装:60 |
| RM48L952DZWTT | 功能描述:ARM? Cortex?-R4F Hercules? RM4 ARM? Cortex?-R4 Microcontroller IC 16/32-Bit 220MHz 3MB (3M x 8) FLASH 337-NFBGA (16x16) 制造商:texas instruments 系列:Hercules? RM4 ARM? Cortex?-R4 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-R4F 核心尺寸:16/32-位 速度:220MHz 连接性:CAN，EBI/EMI，以太网，I2C，LIN，MibSPI，SCI，SPI，ART/USART，USB 外设:DMA，POR，PWM，WDT I/O 数:120 程序存储容量:3MB（3M x 8） 程序存储器类型:闪存 EEPROM 容量:64K x 8 RAM 容量:256K x 8 电压 - 电源（Vcc/Vdd）:1.14 V ~ 1.32 V 数据转换器:A/D 24x12b 振荡器类型:外部 工作温度:-40°C ~ 105°C（TA） 封装/外壳:337-LFBGA 供应商器件封装:337-NFBGA（16x16） 标准包装:90 |
| RM48L952PGET | 制造商:Texas Instruments 功能描述:MCU 16-bit/32-bit RM48Lx52 ARM Cortex R4F RISC 3072KB Flash 1.2V/3.3V 144-Pin LQFP Tray 制造商:Texas Instruments 功能描述:MCU 16/32BIT 64KB FLASH 144LQFP 制造商:Texas Instruments 功能描述:16-bit Microcontrollers - MCU 16/32-Bit RISC Flash MCU |
| RM48L952ZWTT | 制造商:Texas Instruments 功能描述:MCU 16-bit/32-bit RM48L952 ARM Cortex R4F RISC 3MB Flash 1.2V/3.3V 337-Pin NFBGA 制造商:Texas Instruments 功能描述:GLADIATOR F021 - Trays 制造商:Texas Instruments 功能描述:IC MCU ARM 3MB FLASH 337BGA 制造商:Texas Instruments 功能描述:MCU 32BIT CORTEX-R4F 220MHZ BGA-337 制造商:Texas Instruments 功能描述:MCU, 32BIT, CORTEX-R4F, 220MHZ, BGA-337 制造商:Texas Instruments 功能描述:Gladiator F021 |
发布紧急采购，3分钟左右您将得到回复。