- 您现在的位置：买卖IC网 > PDF目录16381 > SI2401FS10-EVB (Silicon Laboratories Inc)BOARD EVAL SI2401 UART INTERFACE PDF资料下载
参数资料
| 型号： | SI2401FS10-EVB |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 5/76页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL SI2401 UART INTERFACE |
| 标准包装： | 1 |
| 系列： | ISOmodem® |
| 主要目的： | 电信，调制解调器 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | SI2401 |
| 主要属性： | 双路 RJ-11 连接至电话线路，音频连接器 |
| 次要属性： | RS-232，TTL 串行和 USB 接口 |
| 已供物品： | 板，调制解调器，电源 |
| 相关产品： | 336-1095-ND - IC ISOMODEM SYSTEM-SIDE 16SOIC |
| 其它名称： | 336-1167 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页
Si2401
Rev. 1.0
13
4.1. Serial Interface
The Si2401 has a universal asynchronous receiver/
transmitter (UART) serial interface compatible with
standard microcontroller serial interfaces. After powerup
or reset, the speed of the serial (Data Terminal
Equipment—DTE)
interface
is
set
by
default
to
2400 bps with the 8-bit, no parity, and one-stop bit (8N1)
format described below.
The serial interface DTE rate can be modified by writing
SE0[2:0] (SD) with the value corresponding to the
desired DTE rate. (See Table 8.) This is accomplished
with the command, ATSE0=xx, where xx is the
hexadecimal value of the SE0 register.
Immediately after the ATSE0=xx string is sent, the host
UART must be reprogrammed to the new DTE rate in
order to communicate with the Si2401.
The carriage return character following the ATSE0=xx
string must be sent at the new DTE rate to observe the
“O” response code. See Table 12 on page 24 for the
response code summary.
4.2. Configurations and Data Rates
The Si2401 can be configured to any of the Bell and
CCITT operation modes listed in Table 9. When
configured
for
V.22bis,
the
modem
connects
at
1200 bps if the far end modem is configured for V.22.
This device also supports SIA and other protocols for
the security industry. Table 7 provides the modulation
method, carrier frequencies, data rate, baud rate, and
notes on standard compliance for each modem
configuration of the Si2401. Table 9 shows example
register settings (S07) for some of the modem
configurations.
As shown in Figure 3, 8-bit and 9-bit data modes refer to
the DTE format over the UART. Line data formats are
configured through registers S07 (MF1) and S15 (MLC).
If the number of bits specified by the format differs from
the number of bits specified by the DCE data
communications equipment or line (DTE) format, the
MSBs are either dropped or bit-stuffed, as appropriate.
For example, if the DTE format is 9 data bits (9N1), and
the line data format is 8 data bits (8N1), the MSB from
the DTE is dropped as the 9-bit word is passed from the
DTE side to the DCE (line) side. In this case, the
dropped ninth bit can then be used as an escape
mechanism. However, if the DTE format is 8N1, and the
line data format is 9N1, an MSB equal to 0 is added to
the 8-bit word as it is passed from the DTE side to the
DCE side.
The Si2401 UART does not continuously check for stop
bits on the incoming digital data. Therefore, if the TXD
pin is not high, the RXD pin may echo meaningless
characters to the host UART. This requires the host
UART to flush its receiver FIFO upon initialization.
Figure 3. Link and Line Data Formats
Table 8. DTE Rates
DTE Rate (bps)
SE0[2:0] (SD)
300
000
1200
001
2400
010
9600
011
19200
100
38400
101
115200
110
307200
111
Table 9. Modem Configuration Examples
(S07[7] (HDEN) = 0, S07[6] (BD) = 0)
Modem Protocol
Register S07 Values
V.22bis
0x06
V.22
0x02
V.21
0x03
Bell 212A
0x00
Bell 103
0x01
V.23 (1200 tx, 75 rx)
0x16
V.23 (75 tx, 1200 rx)
0x26
V.23 (600 tx, 75 rx)
0x10
V.23 (75 tx, 600 rx)
0x20
DTE Interface
Data Rate: SE0[2:0] (SD)
Data Format: SE0[3] (ND)
DCE (Line) Interface
Data Rate: S07 (MF1)
Data Format: S15 (MLC)
Si3010
Si2401
RJ11
TXD
RXD
相关PDF资料 |
PDF描述 |
|---|---|
| UPA0J272MPD1TD | CAP ALUM 2700UF 6.3V 20% RADIAL |
| UPA0J222MPD1TD | CAP ALUM 2200UF 6.3V 20% RADIAL |
| GBC19DRAS | CONN EDGECARD 38POS R/A .100 SLD |
| CM322522-2R2JL | INDUCTOR CHIP 2.2UH 3225 SMD |
| RR70G821MDN1 | CAP ALUM 820UF 4V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI2401-FSR | 功能描述:电信线路管理 IC 2400b/s System Side 3rd Gen DAA Tech RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| SI2401URT-EVB | 功能描述:网络开发工具 U 634-SI2401FS10-EVB RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| SI2403 | 制造商:SILABS 制造商全称:SILABS 功能描述:V.22BIS ISOMODEM CHIPSET WITH ERROR CORRECTION |
| SI2403-FT | 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 2.4KBPS 24TSSOP - Rail/Tube |
| SI2404 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:V.90, V.34, V.32BIS, V.22BIS ISOMODEM?? WITH GLOBAL DAA |
发布紧急采购，3分钟左右您将得到回复。