- 您现在的位置：买卖IC网 > PDF目录136930 > TLC320AC01CPMR (TEXAS INSTRUMENTS INC) SPECIALTY ANALOG CIRCUIT, PQFP64 PDF资料下载
参数资料
| 型号： | TLC320AC01CPMR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 模拟信号调理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| 封装： | PLASTIC, QFP-64 |
| 文件页数： | 19/93页 |
| 文件大小： | 601K |
| 代理商： | TLC320AC01CPMR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页
2–13
2.14.5
Midpoint Voltages (ADC VMID and DAC VMID)
Since the device operates at a single-supply voltage, two midpoint voltages are generated for internal signal
processing. ADC VMID is used for the ADC channel reference, and DAC VMID is used for the DAC channel
reference. Two references minimize channel-to-channel noise and crosstalk. ADC VMID and DAC VMID
must be buffered when used as a reference for external signal processing.
2.15 Device Functions
2.15.1
Phase Adjustment
In some applications, such as modems, the device sampling period may require an adjustment to
synchronize with the incoming bit stream to improve the signal-to-noise ratio. The TLC320AC01 can adjust
the sampling period through the use of the A
′ register and the control bits.
2.15.1.1 Phase-Adjustment Control
A phase adjustment is a programmed variation in the sampling period. A sampling period is adjusted
according to the data value in the A
′ register, and the phase adjustment is that number of master clocks
(MCLK). An adjustment is made during device operation with data bits D01 and D00 in the primary
communication, with data bits DS15 and DS14 in the secondary word or in combination with the hardware
terminals FC1 and FC0 (see Table 2 – 3). This adjustment request is latched on the rising edge of the next
internal frame-sync interval and is only valid for the next sampling period. To repeat the phase adjustment,
another phase request must be initiated.
2.15.1.2 Use of the A
′ Register for Phase Adjustment
The A
′ register value makes slight timing adjustments to the sampling period. The sampling period
increases or decreases according to the sign of the programmed A
′ register value and the state of data bits
D01 and D00 in the primary data word.
The general equation for the conversion frequency is given in equation 16:
+
MCLK
(2
Aregister value
Bregister value)
" (A register value)
fs = conversion frequency
(16)
Therefore, if A
′ = 0, the device conversion (sampling) frequency and period is constant.
If a nonzero A
′ value is programmed, the sampling frequency and period responds as shown in Table 2–2.
Table 2–2. Sampling Variation With A
′
SIGN OF THE A
′ REGISTER VALUE
D01
D00
PLUS VALUE
(+)
NEGATIVE VALUE
(–)
0
1
(increase command)
Frequency decreases,
period increases
Frequency increases,
period decreases
1
0
(decrease command)
Frequency increases,
period decreases
Frequency decreases,
period increases
An adjustment to the sampling period, which must be requested through D01 and D00 of the primary data
word to DIN, is valid for the following sampling period only. When the adjustment is required for the
subsequent sampling period, it must be requested again through D01 and D00 of the primary data word.
For each request, only the sampling period occurring immediately after the primary data word request is
affected.
相关PDF资料 |
PDF描述 |
|---|---|
| TC6501P095VCTTR | SPECIALTY ANALOG CIRCUIT, PDSO5 |
| TS5A63157YZPR | 1-CHANNEL, SGL POLE DOUBLE THROW SWITCH, BGA6 |
| TLC2933AIPW | PHASE LOCKED LOOP, 32 MHz, PDSO14 |
| TPS2560DRC | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
| TS4040DIZ-2.5 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PBCY3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLC320AC02 | 制造商:TI 制造商全称:Texas Instruments 功能描述:Single-Supply Analog Interface Circuit |
| TLC320AC02C | 制造商:TI 制造商全称:Texas Instruments 功能描述:Single-Supply Analog Interface Circuit |
| TLC320AC02CFN | 功能描述:接口—CODEC SNGL CH Codec Bandwidth Indpendent RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
| TLC320AC02CFNR | 功能描述:接口—CODEC SNGL CH Codec Bandwidth Indpendent RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
| TLC320AC02CPM | 功能描述:接口—CODEC SNGL CH Codec Bandwidth Indpendent RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。