- 您现在的位置：买卖IC网 > PDF目录20313 > ADP1048ARQZ-R7 (Analog Devices Inc)IC DGTL PFC CTRLR 24QSOP PDF资料下载
参数资料
| 型号： | ADP1048ARQZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 30/84页 |
| 文件大小： | 0K |
| 描述： | IC DGTL PFC CTRLR 24QSOP |
| 标准包装： | 1 |
| 模式： | 平均电流 |
| 频率 - 开关： | 30kHz ~ 400kHz |
| 电源电压： | 3 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 24-QSOP |
| 包装： | 标准包装 |
| 其它名称： | ADP1048ARQZ-R7DKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页
ADP1047/ADP1048
ADVANCED FEATURES
The advanced features of the ADP1047 / ADP1048 include
Data Sheet
PWM FREQUENCY SYNCHRONIZATION
?
?
?
?
?
?
?
?
Frequency dithering for EMI noise minimization
PWM frequency synchronization with external source
Smart output voltage: real-time efficiency optimization by
changing the output voltage based on ac line and output power
Smart switching frequency: real-time efficiency
optimization by changing the switching frequency
Current loop filter for light load: real-time THD
optimization at light load conditions
Phase shedding ( ADP1048 only): real-time efficiency
optimization by shutting down one phase
Current loop feedforward: power factor and THD
optimization at light load conditions
Bridgeless boost operation ( ADP1048 only)
The part can synchronize the internal PWM clock with an
external clock frequency; the external source must be within the
minimum and maximum synchronization range programmed
in the part. To enable PWM frequency synchronization, set
Register 0xFE4F, Bit 1, to 1.
The capture range for the SYNC period is 87.5% to 112.5% of
the programmed switching period. The switching frequency
synchronized to the SYNC pin is limited by the frequency set
in Register 0xFE1B. The maximum range for the synchronized
frequency is from 89% to 114% of the programmed switching
frequency. The delay between the external SYNC signal and the
start of the internal switching cycle can be programmed using
Register 0xFE4C.
All advanced features other than bridgeless boost operation are
The part synchronizes to the external clock frequency as follows:
enabled by setting the appropriate bit in Register 0xFE4F.
FREQUENCY DITHERING (SPREAD SPECTRUM)
The PWM signal can be altered digitally to optimize for EMI
reduction (see Figure 28). For a wider but lower EMI spectrum,
the switching frequency varies with the rectified line voltage.
The switching cycle changes linearly with time from 87.5% to
112.5% of the nominal value, resulting in a frequency variation
of 114% to 89% of the nominal value.
1.
2.
3.
The part attempts to determine the external clock period,
averaging it over seven cycles (frequency capture mode).
After the period of the SYNC signal is determined, the
internal PWM clock is adjusted until the phase is also
aligned. At that point, internal and external clocks are
synchronized (phase capture mode).
Each internal switching cycle is terminated after the SYNC
rising edge is detected (pulse-by-pulse synchronization).
To enable frequency dithering, set Register 0xFE4F, Bit 0, to 1.
To configure the dithering period, program Register 0xFE1D.
V REC
TIME
SWITCHING
CYCLE
112.5% t SW
t SW
87.5% t SW
If the external SYNC signal is lost at any time or if the period
exceeds the minimum/maximum limit, the internal clock goes
back to the maximum period set in Register 0xFE1B.
During the soft start phase, the SYNC pin is ignored and the
clock frequency is not synchronized.
Interleaved operation of a multiphase PFC circuit is realized by
using the SYNC pin of several ADP1047 / ADP1048 controllers.
The frequency synchronization feature is optional. When
enabled, the switching frequency can be programmed to 1,
1/2, 1/3, or 1/4 of the SYNC frequency using Register 0xFE1E.
SMART OUTPUT VOLTAGE (LOAD LINE)
To achieve higher efficiency, the output voltage can be
programmed according to the load power and input voltage
condition (see Figure 29). To enable the smart output voltage
feature, set Register 0xFE4F, Bit 2, to 1.
OUTPUT
SWITCHING
TIME
VOH
VOH2
VOLTAGE
SUPER HIGH LINE
114% f SW
f SW
89% f SW
FREQUENCY
VOH1
VOL2
VOL1
HIGH LINE
LOW LINE
POWER
TIME
P1
P2
100%
1/f DITHER
2/f DITHER
Figure 29. Smart Output Voltage Control (Load Line)
Figure 28. Switching Frequency Dithering Control
Rev. 0 | Page 30 of 84
相关PDF资料 |
PDF描述 |
|---|---|
| RCB06DHRD | CONN CARD EXTEND 12POS .050" |
| V72A5C300B | CONVERTER MOD DC/DC 5V 300W |
| 395-120-520-801 | CARD EDGE 120PS DL .100X.200 BLK |
| T97R686K025LSA | CAP TANT 68UF 25V 10% 2824 |
| 345-120-540-202 | CARDEDGE 120POS DUAL .100 GREEN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1048DC1-EVALZ | 功能描述:DAUGHTERCARD ADP1048 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
| ADP1048WARQZ-R7 | 功能描述:PFC IC Average Current 30kHz ~ 400kHz 24-QSOP 制造商:analog devices inc. 系列:- 包装:带卷（TR） 零件状态:有效 模式:平均电流 频率 - 开关:30kHz ~ 400kHz 电流 - 启动:- 电压 - 电源:3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:24-SSOP（0.209"，5.30mm 宽） 供应商器件封装:24-QSOP 标准包装:1,000 |
| ADP1050ACPZ-R7 | 功能描述:Power Supply Controller Power Supply Controller/Monitor 20-LFCSP-WQ (4x4) 制造商:analog devices inc. 系列:- 包装:剪切带（CT） 零件状态:有效 应用:电源控制器/监控器 电压 - 输入:0 V ~ 1.6 V 电压 - 电源:3 V ~ 3.6 V 电流 - 电源:28.5mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:20-WFQFN 裸露焊盘，CSP 供应商器件封装:20-LFCSP-WQ（4x4） 标准包装:1 |
| ADP1050ACPZ-RL | 功能描述:Power Supply Controller Power Supply Controller/Monitor 20-LFCSP-WQ (4x4) 制造商:analog devices inc. 系列:- 包装:带卷（TR） 零件状态:在售 应用:电源控制器/监控器 电压 - 输入:0 V ~ 1.6 V 电压 - 电源:3 V ~ 3.6 V 电流 - 电源:28.5mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:20-WFQFN 裸露焊盘，CSP 供应商器件封装:20-LFCSP-WQ（4x4） 标准包装:5,000 |
| ADP1050DC1-EVALZ | 功能描述:ADP1050 - Power Management, Digital Power Controller Evaluation Board 制造商:analog devices inc. 系列:- 零件状态:有效 主要用途:电源管理，数字电源控制器 嵌入式:- 使用的 IC/零件:ADP1050 主要属性:- 辅助属性:- 所含物品:板 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。