参数资料
型号: ADZS-BF561-EZLITE
厂商: Analog Devices Inc
文件页数: 6/64页
文件大小: 0K
描述: BOARD EVAL ADSP-BF561
产品培训模块: Interfacing AV Converters to Blackfin Processors
Blackfin® Processor Core Architecture Overview
Blackfin® Device Drivers
Blackfin® Optimizations for Performance and Power Consumption
Blackfin® System Services
特色产品: Blackfin? BF50x Series Processors
标准包装: 1
系列: Blackfin®
类型: DSP
适用于相关产品: ADSP-BF561
所含物品: 评估板、软件和说明文档
配用: ADZS-USBLAN-EZEXT-ND - BOARD DAUGHTER EXTENDED USB-LAN
ADZS-BFFPGA-EZEXT-ND - BOARD EVAL FPGA BLACKFIN EXTENDR
ADZS-BF-EZEXT-1-ND - BOARD DAUGHTER ADSP-BF533/561KIT
相关产品: ADSP-BF561SKBCZ-6V-ND - IC DSP 32BIT 600MHZ 256CSPBGA
ADSP-BF561SKBCZ-5V-ND - IC DSP 32BIT 500MHZ 256CSPBGA
ADSP-BF561SKBCZ-5A-ND - IC DSP CTLR 32BIT BKFN 256CSPBGA
ADSP-BF561SKBCZ-6A-ND - IC DSP CTRLR 32B 600MHZ 256CPBGA
ADSP-BF561SBBCZ-5A-ND - IC DSP CTRLR 32B 500MHZ 256CPBGA
ADSP-BF561SBBZ500-ND - IC PROCESSOR 500MHZ 297-PBGA
ADSP-BF561SBBZ600-ND - IC DSP 32BIT 600MHZ 297-BGA
ADSP-BF561SKBZ600-ND - IC DSP 32BIT 600MHZ 297PBGA
ADSP-BF561SKBZ500-ND - IC DSP 32BIT 500MHZ 297PBGA
ADSP-BF561SKB600-ND - IC DSP CTRLR 32BIT 600MHZ 297BGA
更多...
ADSP-BF561 
flexible configuration and upgradability of system memory
while allowing the core to view all SDRAM as a single, contigu-
ous, physical address space.
The asynchronous memory controller can also be programmed
to control up to four banks of devices with very flexible timing
parameters for a wide variety of devices. Each bank occupies a
64M byte segment regardless of the size of the devices used so
that these banks will only be contiguous if fully populated with
64M bytes of memory.
I/O Memory Space
Blackfin processors do not define a separate I/O space. All
resources are mapped through the flat 32-bit address space. On-
chip I/O devices have their control registers mapped into mem-
ory mapped registers (MMRs) at addresses near the top of the
4G byte address space. These are separated into two smaller
blocks, one which contains the control MMRs for all core func-
tions, and the other which contains the registers needed for
setup and control of the on-chip peripherals outside of the core.
The core MMRs are accessible only by the core and only in
supervisor mode and appear as reserved space by on-chip
peripherals. The system MMRs are accessible by the core in
supervisor mode and can be mapped as either visible or reserved
to other devices, depending on the system protection
model desired.
Booting
? Interrupts – Events that occur asynchronously to program
flow. They are caused by timers, peripherals, input pins,
and an explicit software instruction.
Each event has an associated register to hold the return address
and an associated “return from event” instruction. When an
event is triggered, the state of the processor is saved on the
supervisor stack.
The ADSP-BF561 event controller consists of two stages: the
Core Event Controller (CEC) and the System Interrupt Control-
ler (SIC). The Core Event Controller works with the System
Interrupt Controller to prioritize and control all system events.
Conceptually, interrupts from the peripherals enter into the
SIC, and are then routed directly into the general-purpose
interrupts of the CEC.
Core Event Controller (CEC)
The CEC supports nine general-purpose interrupts (IVG15–7),
in addition to the dedicated interrupt and exception events. Of
these general-purpose interrupts, the two lowest priority inter-
rupts (IVG15 –14) are recommended to be reserved for software
interrupt handlers, leaving seven prioritized interrupt inputs to
support the peripherals of the ADSP-BF561. Table 1 describes
the inputs to the CEC, identifies their names in the Event Vector
Table (EVT), and lists their priorities.
Table 1. Core Event Controller (CEC)
The ADSP-BF561 contains a small boot kernel, which config-
ures the appropriate peripheral for booting. If the ADSP-BF561
is configured to boot from boot ROM memory space, the pro-
cessor starts executing from the on-chip boot ROM.
Event Handling
The event controller on the ADSP-BF561 handles all asynchro-
nous and synchronous events to the processor. The
ADSP-BF561 provides event handling that supports both nest-
ing and prioritization. Nesting allows multiple event service
routines to be active simultaneously. Prioritization ensures that
servicing of a higher priority event takes precedence over servic-
ing of a lower priority event. The controller provides support for
five different types of events:
? Emulation – An emulation event causes the processor to
enter emulation mode, allowing command and control of
the processor via the JTAG interface.
? Reset – This event resets the processor.
? Nonmaskable Interrupt (NMI) – The NMI event can be
generated by the software watchdog timer or by the NMI
Priority
(0 is Highest)
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Event Class
Emulation/Test Control
Reset
Nonmaskable Interrupt
Exceptions
Global Enable
Hardware Error
Core Timer
General Interrupt 7
General Interrupt 8
General Interrupt 9
General Interrupt 10
General Interrupt 11
General Interrupt 12
General Interrupt 13
General Interrupt 14
General Interrupt 15
EVT Entry
EMU
RST
NMI
EVX
IVHW
IVTMR
IVG7
IVG8
IVG9
IVG10
IVG11
IVG12
IVG13
IVG14
IVG15
input signal to the processor. The NMI event is frequently
used as a power-down indicator to initiate an orderly shut-
down of the system.
? Exceptions – Events that occur synchronously to program
flow, i.e., the exception will be taken before the instruction
is allowed to complete. Conditions such as data alignment
violations or undefined instructions cause exceptions.
System Interrupt Controller (SIC)
The System Interrupt Controller provides the mapping and
routing of events from the many peripheral interrupt sources to
the prioritized general-purpose interrupt inputs of the CEC.
Although the ADSP-BF561 provides a default mapping, the user
can alter the mappings and priorities of interrupt events by
Rev. E |
Page 6 of 64 |
September 2009
相关PDF资料
PDF描述
ADZS-BF592-EZLITE KIT EVAL EZ LITE ADZS-BF592
ADZS-BF609-EZBRD KIT EVAL EZ-BOARD ADSP-BF60X
ADZS-HPUSB-ICE TOOL EMULATOR USB HP CROSSCORE
ADZS-ICE-100B EMULATOR BLACKFIN
AK-Y1301 CABLE SCSI-3 EXTENSION 68CONDUCT
相关代理商/技术参数
参数描述
ADZS-BF561-MMSKIT 功能描述:KIT STARTER MULTIMEDIA BF561 RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Blackfin® 标准包装:1 系列:PICDEM™ 类型:MCU 适用于相关产品:PIC10F206,PIC16F690,PIC16F819 所含物品:板,线缆,元件,CD,PICkit 编程器 产品目录页面:659 (CN2011-ZH PDF)
ADZS-BF561-MMSKIT 制造商:Analog Devices 功能描述:MEDIA KIT ((NW))
ADZS-BF592-EZLITE 功能描述:KIT EVAL EZ LITE ADZS-BF592 RoHS:是 类别:编程器,开发系统 >> 通用嵌入式开发板和套件(MCU、DSP、FPGA、CPLD等) 系列:Blackfin® 产品培训模块:Blackfin® Processor Core Architecture Overview Blackfin® Device Drivers Blackfin® Optimizations for Performance and Power Consumption Blackfin® System Services 特色产品:Blackfin? BF50x Series Processors 标准包装:1 系列:Blackfin® 类型:DSP 适用于相关产品:ADSP-BF548 所含物品:板,软件,4x4 键盘,光学拨轮,QVGA 触摸屏 LCD 和 40G 硬盘 配用:ADZS-BFBLUET-EZEXT-ND - EZ-EXTENDER DAUGHTERBOARDADZS-BFLLCD-EZEXT-ND - BOARD EXT LANDSCAP LCD INTERFACE 相关产品:ADSP-BF542BBCZ-4A-ND - IC DSP 16BIT 400MHZ 400CSBGAADSP-BF544MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF542KBCZ-6A-ND - IC DSP 16BIT 600MHZ 400CSBGAADSP-BF547MBBCZ-5M-ND - IC DSP 16BIT 533MHZ MDDR 400CBGAADSP-BF548BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF547BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF544BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGAADSP-BF542BBCZ-5A-ND - IC DSP 16BIT 533MHZ 400CSBGA
ADZS-BF592-EZLITE 制造商:Analog Devices 功能描述:ADZS-BF592-EZLITE
ADZS-BF608-EZLITE 制造商:Analog Devices 功能描述:DIGITAL SIGNAL PROCESSOR - DEVELOPMENT TOOL