参数资料
| 型号： | DS3106LN+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 13/92页 |
| 文件大小： | 0K |
| 描述： | IC TIMING LINE CARD 64-LQFP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 160 |
| 类型： | 定时卡 IC，多路复用器 |
| PLL： | 是 |
| 主要目的： | 以太网，SONET/SDH，Stratum，电信 |
| 输入： | CMOS，TTL |
| 输出： | CMOS，LVDS，LVPECL，TTL |
| 电路数： | 1 |
| 比率 - 输入:输出： | 2:2 |
| 差分 - 输入:输出： | 无/是 |
| 频率 - 最大： | 312.5MHz |
| 电源电压： | 1.62 V ~ 1.98 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-LQFP |
| 供应商设备封装： | 64-LQFP（10x10） |
| 包装： | 托盘 |
| 产品目录页面： | 1429 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
DS3106
20
Digital PLLs have two key benefits: (1) stable, repeatable performance that is insensitive to process variations,
temperature, and voltage; and (2) flexible behavior that is easily programmed through the configuration registers.
DPLLs use digital frequency synthesis (DFS) to generate various clocks. In DFS a high-speed master clock
(204.8MHz) is multiplied up from the 12.800MHz local oscillator clock applied to the REFCLK pin. This master
clock is then digitally divided down to the desired output frequency. The DFS output clock has jitter of about 1ns pk-
pk.
The analog PLLs filter the jitter from the DPLLs, reducing the 1ns pk-pk jitter to less than 0.5ns pk-pk and 60ps
RMS, typical, measured broadband (10Hz to 1GHz).
The DPLLs in the device are configurable for many PLL parameters including bandwidth, damping factor, input
frequency, pull-in/hold-in range, and more. No knowledge of loop equations or gain parameters is required to
configure and operate the device. No external components are required for the DPLL or the APLLs except the
high-quality local oscillator connected to the REFCLK pin.
The T0 DPLL has a full free-run/locked/holdover state machine and full programmability.
7.7.1 T0 DPLL State Machine
The T0 DPLL has three main timing modes: locked, holdover, and free-run. The control state machine for the T0
DPLL has states for each timing mode as well as three temporary states: prelocked, prelocked 2, and loss-of-lock.
The state transition diagram is shown in Figure 7-2. Descriptions of each state are given in the paragraphs below.
During normal operation the state machine controls state transitions. When necessary, however, the state can be
forced using the T0STATE field of the MCR1 register.
Whenever the T0 DPLL changes state, the STATE bit in MSR2 is set, which can cause an interrupt request if
enabled. The current T0 DPLL state can be read from the T0STATE field of the OPSTATE register.
7.7.1.1 Free-Run State
Free-run mode is the reset default state. In free-run all output clocks are derived from the 12.800 MHz local
oscillator attached to the REFCLK pin. The frequency of each output clock is a specific multiple of the local
oscillator. The frequency accuracy of each output clock is equal to the frequency accuracy of the master clock,
which can be calibrated using the MCLKFREQ field in registers MCLK1 and MCLK2 (see Section 7.3). The state
machine transitions from free-run to the prelocked state when at least one input clock is valid.
7.7.1.2 Prelocked State
If phase lock (see Section 7.7.5) is achieved for 2 seconds during this period, the state machine transitions to
locked mode. If the selected reference becomes inactive for 2 seconds then the state machine transitions back to
the free-run state.
相关PDF资料 |
PDF描述 |
|---|---|
| DS3231MZ+ | IC RTC I2C 8SOIC |
| DS3231SN#T&R | IC RTC W/TCXO 16-SOIC |
| DS3232MZ+ | IC RTC W/SRAM I2C 8SOIC |
| DS3232SN#T&R | IC RTC W/TCXO 20-SOIC |
| DS3234S# | IC RTC W/TCXO 20-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS3106LN+ | 功能描述:计时器和支持产品 Line Card Timing IC RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| DS3107FP000 | 制造商:Thomas & Betts 功能描述:30A,CON,2P3W,MG,107,125V |
| DS3107FRAB0 | 制造商:Thomas & Betts 功能描述:30A,REC,2P3W,MG,107,AB0,125,SC |
| DS3107MP000 | 制造商:Thomas & Betts 功能描述:30A,PLG,2P3W,MG,107,125V |
| DS3107MP00K | 制造商:Thomas & Betts 功能描述:30A,PLG,2P3W,MG,107,125V,CC |
发布紧急采购，3分钟左右您将得到回复。