- 您现在的位置：买卖IC网 > PDF目录18822 > HSP50210JC-52Z (Intersil)IC DEMODULATOR COSTAS 84-PLCC PDF资料下载
参数资料
| 型号： | HSP50210JC-52Z |
| 厂商： | Intersil |
| 文件页数： | 38/51页 |
| 文件大小： | 0K |
| 描述： | IC DEMODULATOR COSTAS 84-PLCC |
| 标准包装： | 15 |
| 功能： | 解调器 |
| 频率： | 52MHz |
| RF 型： | AM，FM |
| 封装/外壳： | 84-LCC（J 形引线） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页当前第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页
HSP50210
TABLE 29. SYMBOL TRACKING LOOP CONFIGURATION CONTROL REGISTER (Continued)
DESTINATION ADDRESS = 14
BIT
POSITION
8
7-3
2
1
0
FUNCTION
Single/Double Rail
Sampling Error
Sampling Error
Accumulation
Lead Sampling Error
Enable
Lag Sampling Error
Enable
Invert Sampling Error
DESCRIPTION
This bit sets whether sampling error is derived from symbol transitions on just the I rail (single rail) or both
the I and Q rails (dual rail). In single rail operation sampling error from the Q rail is nulled and only the I rail
is used. In dual rail operation the sampling error from both the I an Q rails is summed and then scaled by
one half.
0 = Dual Rail Operation.
1 = Single Rail Operation.
Note: Set to 1 for BPSK operation and 0 for QPSK operation.
These bits set the number of sampling error measurements to accumulate before running the Symbol Loop
Filter. The loop filter requires 8 CLKs to compute an output. The sampling error detector generates error
terms at the symbol rate. Thus, the error accumulator must be used if the symbol rate exceeds 1/8 CLK to
ensure that no error terms are missed (see “Sampling Error Detector” on page 17). The 5-bit value
programmed here is set to one less than the desired number of error terms to accumulate. For example,
setting these bits to 00011 (BINARY) would cause 4 error terms to be accumulated. A total range from 1 to
32 is provided.
0 = Sampling error enabled to lead path of loop filter.
1 = Sampling error to lead path of loop filter zeroed.
0 = Sampling error enabled to lag path of loop filter.
1 = Sampling error to lag path of loop filter zeroed (First Order Loop).
0 = Sampling error normal.
1 = Sampling error inverted.
TABLE 30. SYMBOL TRACKING LOOP FILTER UPPER LIMIT CONTROL REGISTER
DESTINATION ADDRESS = 15
BIT
POSITION
31-0
FUNCTION
Symbol Tracking
Loop Filter Upper
Limit
DESCRIPTION
The 32-bit two’s complement value programmed here sets the upper tracking limit of the Symbol Tracking Loop
Filter by setting the upper limit of the loop filter’s lag accumulator. If the limit is exceeded, the upper 32 bits of the
40-bit accumulator are set to the limit, and the 8 LSBs are set to zero.
TABLE 31. SYMBOL TRACKING LOOP FILTER LOWER LIMIT CONTROL REGISTER
DESTINATION ADDRESS = 16
BIT
POSITION
31-0
FUNCTION
Symbol Tracking
Loop Filter Lower
Limit
DESCRIPTION
The 32-bit two’s complement value programmed here sets the Lower tracking limit of the Symbol Tracking Loop
Filter by setting the lower limit of the loop filter’s lag accumulator. If the running sum falls below the limit, the upper
32 bits of the 40-bit accumulator are set to the limit, and the 8 LSBs are set to zero.
TABLE 32. SYMBOL TRACKING LOOP FILTER GAIN (ACQ) CONTROL REGISTER
DESTINATION ADDRESS = 17
BIT
POSITION
31-24
23-18
17-14
FUNCTION
Not Used
Reserved
Symbol Tracking
Lead Gain Mantissa
(Acquisition)
38
DESCRIPTION
No programming required.
Reserved. Set to 0 for proper operation.
These bits are the 4 fractional bits of the lead gain mantissa shown as follows:
Symbol Tracking Lead Gain Mantissa = 01. 2 -1 2 -2 2 -3 2 -4.
This format provides a mantissa range from 1.0 to 1.9375 for mantissa settings from 0000 to 1111 Binary.
Bit position 17 is the MSB.
FN3652.5
July 2, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| HMR2300-D20-485 | MAGNETOMETER RS485 W/CASE |
| PT080-60-0 | CORD PATCH PIN TIP PLUG 60" BLK |
| ISL5829/2INZ | IC DAC 12BIT CMOS DUAL 48LQFP |
| HMR2300-D00-485 | MAGNETOMETER RS485 |
| PT080-48-2 | CORD PATCH PIN TIP PLUG 48" RED |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HSP50210JI-52 | 功能描述:上下转换器 COSTAS DEMODULATOR,84 PLCC,52MHZ,IND RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
| HSP50210JI-52Z | 功能描述:上下转换器 COSTAS DEMODULATOR 84 PLCC 52MHZ IND RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
| HSP50214 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Programmable Downconverter |
| HSP50214A | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Programmable Downconverter |
| HSP50214AVC | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
发布紧急采购，3分钟左右您将得到回复。