参数资料
型号: HSP50210JC-52Z
厂商: Intersil
文件页数: 39/51页
文件大小: 0K
描述: IC DEMODULATOR COSTAS 84-PLCC
标准包装: 15
功能: 解调器
频率: 52MHz
RF 型: AM,FM
封装/外壳: 84-LCC(J 形引线)
包装: 管件
HSP50210
TABLE 32. SYMBOL TRACKING LOOP FILTER GAIN (ACQ) CONTROL REGISTER (Continued)
DESTINATION ADDRESS = 17
BIT
POSITION
13-9
8-5
4-0
FUNCTION
Symbol Tracking
Lead Gain Exponent
(Acquisition)
Symbol Tracking Lag
Gain Mantissa
(Acquisition)
Symbol Tracking Lag
DESCRIPTION
These bits set the lead gain exponent as given by:
Symbol Tracking Lead Gain Exponent = 2 -(32-E),
where E corresponds to the 5-bit binary value programmed here. Thus, a gain range from
2 -1 to 2 -32 relative to the MSB position of the NCO control word may be achieved for E = 11111 to 00000
Binary. Bit position 13 is the MSB.
Format same as lead gain mantissa. Bit position 8 is the MSB.
Format same as lead gain exponent. Bit position 4 is the MSB.
Gain Exponent
(Acquisition)
TABLE 33. SYMBOL TRACKING LOOP FILTER GAIN (TRK) CONTROL REGISTER
DESTINATION ADDRESS = 18
BIT
POSITION
31-24
23-18
17-14
13-9
8-5
4-0
FUNCTION
Not Used
Reserved
Symbol Tracking Lead Gain Mantissa
(Track)
Symbol Tracking Lead Gain Exponent
(Track)
Symbol Tracking Lag Gain Mantissa
(Track)
Symbol Tracking Lag Gain Exponent
DESCRIPTION
No programming required.
Reserved. Set to 0 for proper operation.
Format same as lead gain mantissa (see Table 32). Bit position 17 is the MSB.
Format same as lead gain exponent (see Table 32). Bit position 13 is the MSB.
Format same as lead gain mantissa (see Table 32). Bit position 8 is the MSB.
Format same as lead gain exponent (see Table 32). Bit position 4 is the MSB.
(Track)
TABLE 34. SYMBOL TRACKING LOOP FILTER LAG ACCUMULATOR INITIALIZATION CONTROL REGISTER
DESTINATION ADDRESS = 19
BIT
POSITION
N/A
FUNCTION
Symbol Tracking Loop
Filter Lag Accumulator
Initialization
39
DESCRIPTION
Writing to this address initializes the lag accumulator with the contents of the four Microprocessor
Interface Holding Registers at the start of the next loop filter computation cycle. The contents of the
holding registers should not be changed until after the start of a new compute cycle since the current
contents of the holding registers are loaded at the compute cycle start. At a slow rate, it could take 1 low
rate symbol time to change. The Microprocessor Interface should be used to read an internal status
register which signals when the lag accumulator load is complete (see Table 13 in the “Microprocessor
Interface” on page 27). The contents of the holding registers are loaded into the 32 MSBs of the lag
accumulator and the 8 LSBs are zeroed.
It is a good practice to load the LAG accumulators at the very end of a configuration load sequence.
FN3652.5
July 2, 2008
相关PDF资料
PDF描述
HMR2300-D20-485 MAGNETOMETER RS485 W/CASE
PT080-60-0 CORD PATCH PIN TIP PLUG 60" BLK
ISL5829/2INZ IC DAC 12BIT CMOS DUAL 48LQFP
HMR2300-D00-485 MAGNETOMETER RS485
PT080-48-2 CORD PATCH PIN TIP PLUG 48" RED
相关代理商/技术参数
参数描述
HSP50210JI-52 功能描述:上下转换器 COSTAS DEMODULATOR,84 PLCC,52MHZ,IND RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
HSP50210JI-52Z 功能描述:上下转换器 COSTAS DEMODULATOR 84 PLCC 52MHZ IND RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
HSP50214 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Programmable Downconverter
HSP50214A 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Programmable Downconverter
HSP50214AVC 制造商:Rochester Electronics LLC 功能描述:- Bulk