- 您现在的位置：买卖IC网 > PDF目录175496 > HY27SS16561M-FCP (HYNIX SEMICONDUCTOR INC) 16M X 16 FLASH 1.8V PROM, 10000 ns, PBGA63 PDF资料下载
参数资料
| 型号： | HY27SS16561M-FCP |
| 厂商： | HYNIX SEMICONDUCTOR INC |
| 元件分类： | PROM |
| 英文描述： | 16M X 16 FLASH 1.8V PROM, 10000 ns, PBGA63 |
| 封装： | 9 X 11 MM, 1.20 MM HEIGHT, 0.80 MM PITCH, FBGA-63 |
| 文件页数： | 43/44页 |
| 文件大小： | 644K |
| 代理商： | HY27SS16561M-FCP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页当前第43页第44页
Rev 0.4 / Jun. 2004
8
Preliminary
HY27SS(08/16)561M Series
HY27US(08/16)561M Series
256Mbit (32Mx8bit / 16Mx16bit) NAND Flash
SIGNAL DESCRIPTIONS
See Figure 1, Logic Diagram and Table 1, Signal Names, for a brief overview of the signals connected to this device.
Inputs/Outputs (I/O0-I/O7)
Input/Outputs 0 to 7 are used to input the selected address, output the data during a Read opertion or input a com-
mand or data during a Write operation. The inputs are latched on the rising edge of Write Enable. I/O0-I/O7 can be left
floating when the device is deselected or the outputs are disabled.
Inputs/Outputs (I/O8-I/O15)
Input/Outputs 8 to 15 are only available in x16 devices. They are used to output the data during a Read operation or
input data during a Write operation. Command and Address Inputs only require I/O0 to I/O7.
The inputs are latched on the rising edge of Write Enable. I/O8-I/O15 can be left floating when the device is deselected
or the outputs are disabled.
Address Latch Enable (ALE)
The Address Latch Enable activates the latching of the Address inputs in the Command Interface. When ALE is high,
the inputs are latched on the rising edge of Write Enable.
Command Latch Enable (CLE)
The Command Latch Enable activates the latching of the Command inputs in the Command Interface. When CLE is
high, the inputs are latched on the rising edge of Write Enable.
Chip Enable (CE)
The Chip Enable input activates the memory control logic, input buffers, decoders and sense amplifiers. When Chip En-
able is low, VIL, the device is selected. If Chip Enable goes high, VIH, while the device is busy, the device remains se-
lected and does not go into standby mode.
When the device is executing a Sequential Row Read operation, Chip Enable must be held low (from the second page
read onwards) during the time that the device is busy (tBLBH1). If Chip Enable goes high during tBLBH1 the operation is
aborted.
Read Enable (RE)
The Read Enable, RE, controls the sequential data output during Read operations. Data is valid tRLQV after the falling
edge of RE. The falling edge of RE also increments the internal column address counter by one.
Write Enable (WE)
The Write Enable input, WE, controls writing to the Command Interface, Input Address and Data latches. Both
addresses and data are latched on the rising edge of Write Enable.
During power-up and power-down a recovery time of 1us (min) is required before the Command Interface is ready to
accept a command. It is recommended to keep Write Enable high during the recovery time.
Write Protect (WP)
The Write Protect pin is an input that gives a hardware protection against unwanted program or erase operations.
When Write Protect is Low, VIL, the device does not accept any program or erase operations.
It is recommended to keep the Write Protect pin Low, VIL, during power-up and power-down.
相关PDF资料 |
PDF描述 |
|---|---|
| HY27UG084G2M-UPIP | 512M X 8 FLASH 3.3V PROM, 30 ns, PBGA52 |
| HY27UG084GDM-TPIS | 512M X 8 FLASH 3.3V PROM, 30 ns, PDSO48 |
| HY29F040AC-55E | 512K X 8 FLASH 5V PROM, 55 ns, PQCC32 |
| HY5116160CTC-70 | 1M X 16 FAST PAGE DRAM, 70 ns, PDSO44 |
| HY5116404BSLR-60 | 4M X 4 EDO DRAM, 60 ns, PDSO24 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HY27SS561M | 制造商:HYNIX 制造商全称:Hynix Semiconductor 功能描述:256Mbit (32Mx8bit / 16Mx16bit) NAND Flash |
| HY27SSXXX | 制造商:HYNIX 制造商全称:Hynix Semiconductor 功能描述:512Mbit (64Mx8bit / 32Mx16bit) NAND Flash |
| HY27UA081G1M | 制造商:HYNIX 制造商全称:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27UA161G1M | 制造商:HYNIX 制造商全称:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27UA1G1M | 制造商:HYNIX 制造商全称:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
发布紧急采购，3分钟左右您将得到回复。