- 您现在的位置：买卖IC网 > PDF目录175506 > I5104XY (WINBOND ELECTRONICS CORP) 262.2 SEC, SPEECH SYNTHESIZER WITH RCDG, UUC25 PDF资料下载
参数资料
| 型号： | I5104XY |
| 厂商： | WINBOND ELECTRONICS CORP |
| 元件分类： | 音频合成 |
| 英文描述： | 262.2 SEC, SPEECH SYNTHESIZER WITH RCDG, UUC25 |
| 封装： | DIE-25 |
| 文件页数： | 72/87页 |
| 文件大小： | 616K |
| 代理商： | I5104XY |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页当前第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页
75
8393B-MCU Wireless-02/13
ATmega256/128/64RFR2
For High Data Rate Modes the automated ED measurement duration is reduced to
32 s as described in "High Data Rate Modes" on page 93. The measurement period in
these modes is still 128 s for manually initiated ED measurements as long as the
receiver is in RX_ON state.
9.5.4.2 Measurement Description
There are two ways to initiate an ED measurement:
Manually, by writing an arbitrary value to register PHY_ED_LEVEL, or
Automatically, after detection of a valid SHR of an incoming frame.
For manually initiated ED measurements the radio transceiver needs to be in one of the
states RX_ON or BUSY_RX. The end of the ED measurement is indicated by a
TRX24_CCA_ED_DONE interrupt.
The automatic ED measurement is started if a SHR is detected. The end of the
automatic measurement is not signaled by an interrupt.
The measurement result is stored after tTR26 = 140 s (128 s measurement duration
and processing delay) in register PHY_ED_LEVEL.
Thus by using Basic Operating Mode a valid ED value from the currently received frame
is accessible 108 s after the TRX24_RX_START interrupt and remains valid until the
next incoming frame generates a new TRX24_RX_START interrupt or until another ED
measurement is initiated.
When using the Extended Operating Mode it is recommended to mask the
TRX24_RX_START interrupt. Hence the interrupt cannot be used as timing reference.
A successful frame reception is signalized by the TRX24_RX_END interrupt. The
minimum time span between a TRX24_RX_END interrupt and a following SFD
detection is tTR27 = 96 s due to the length of the SHR. The ED value needs to be read
within 224 s including the ED measurement time after the TRX24_RX_END interrupt.
Otherwise it could be overwritten by the result of the next measurement cycle. This is
important for time critical applications or if the TRX24_RX_START interrupt is not used
to indicate the reception of a frame.
The values of the register PHY_ED_LEVEL are:
Table 9-23. Register Bit PHY_ED_LEVEL Interpretation
PHY_ED_LEVEL
Description
0xFF
Reset value
0x00 … 0x53
ED measurement result of the last ED measurement
Note:
1. It is not recommended to manually initiate an ED measurement when using the
Extended Operating Mode.
9.5.4.3 Data Interpretation
The PHY_ED_LEVEL is an 8-bit register. The ED value of the radio transceiver has a
valid range from 0x00 to 0x53 with a resolution of 1 dB. All other values do not occur. A
value of 0xFF indicates the reset value. A value of PHY_ED_LEVEL = 0 indicates that
the measured energy is less than -90 dBm (see parameter RSSI_BASE_VAL in section
"Receiver Characteristics" on page 565). Due to environmental conditions (temperature,
voltage, semiconductor parameters etc.) the calculated ED value has a maximum
tolerance of ±5 dB, this is to be considered as constant offset over the measurement
range.
An ED value of 0 indicates an RF input power of PRF ≤ -90 dBm. For an ED value in the
range of 0 to 83, the RF input power can be calculated as follows:
相关PDF资料 |
PDF描述 |
|---|---|
| IA3-1206WA00D5 | 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| IA3-0706SS58D0 | 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| IA3-2010SG30D0 | 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| IAC-0706SG04D0 | 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR |
| IAC-0706SS22D0 | 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| I5108E | 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
| I5108EI | 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
| I5108S | 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
| I5108SI | 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
| I5108X | 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY |
发布紧急采购，3分钟左右您将得到回复。