参数资料
型号: I5104XY
厂商: WINBOND ELECTRONICS CORP
元件分类: 音频合成
英文描述: 262.2 SEC, SPEECH SYNTHESIZER WITH RCDG, UUC25
封装: DIE-25
文件页数: 74/87页
文件大小: 616K
代理商: I5104XY
77
8393B-MCU Wireless-02/13
ATmega256/128/64RFR2
CCA Mode
Description
0, 3
Carrier sense with energy above threshold
.
CCA shall report a busy medium using a logical combination of
-
Detection of a signal with the modulation and spreading characteristics of
this standard and
-
Energy above the ED threshold.
Where the logical operator may be configured as either OR (mode 0) or
AND (mode 3).
9.5.5.2 Configuration and CCA Request
The CCA modes are configurable via register PHY_CC_CCA.
Usimg the Basic Operating Mode, a CCA request can be initiated manually by setting
CCA_REQUEST = 1 of register PHY_CC_CCA, if the radio transceiver is in any RX
state. The current channel status (CCA_STATUS) and the CCA completion status
(CCA_DONE) are accessible in register TRX_STATUS.
The CCA evaluation is done over eight symbol periods and the result is accessible
tTR28 = 140 s (128 s measurement duration and processing delay) after the request.
The
end
of
a
manually
initiated
CCA
measurement
is
indicated
by
a
TRX24_CCA_ED_DONE interrupt.
The sub-register CCA_ED_THRES of register CCA_THRES defines the received power
threshold of the “energy above threshold” algorithm. The threshold is calculated by
RSSI_BASE_VAL + 2 CCA_ED_THRES [dBm]. Any received power above this level
is interpreted as a busy channel.
Note that it is not recommended to manually initiate a CCA measurement when using
the Extended Operating Mode.
9.5.5.3 Data Interpretation
The current channel status (CCA_STATUS) and the CCA completion status
(CCA_DONE) are accessible in register TRX_STATUS. Note, register bits CCA_DONE
and CCA_STATUS are cleared in response to a CCA_REQUEST.
The completion of a measurement cycle is indicated by CCA_DONE = 1. If the radio
transceiver detected no signal (idle channel) during the measurement cycle, the
CCA_STATUS bit is set to 1.
When using the “energy above threshold” algorithm, any received power above
CCA_ED_THRES level is interpreted as a busy channel. The “carrier sense” algorithm
reports a busy channel when detecting an IEEE 802.15.4 signal above the
RSSI_BASE_VAL
(see
parameter
RSSI_BASE_VAL
in
Characteristics" on page 563). The radio transceiver is also able to detect signals below
this value, but the detection probability decreases with the signal power.
9.5.5.4 Interrupt Handling
The TRX24_CCA_ED_DONE interrupt is issued at the end of a manually initiated CCA
measurement.
Note:
A CCA request should only be initiated in the receive states of Basic Operating Mode.
Otherwise the radio transceiver generates a TRX24_CCA_ED_DONE interrupt and
sets the register bit CCA_DONE = 1 even if no CCA measurement was performed.
相关PDF资料
PDF描述
IA3-1206WA00D5 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR
IA3-0706SS58D0 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR
IA3-2010SG30D0 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR
IAC-0706SG04D0 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR
IAC-0706SS22D0 0 MHz - 18000 MHz RF/MICROWAVE FIXED ATTENUATOR
相关代理商/技术参数
参数描述
I5108E 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108EI 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108S 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108SI 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108X 制造商:WINBOND 制造商全称:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY