- 您现在的位置：买卖IC网 > PDF目录69009 > M30240M5-XXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 PDF资料下载
参数资料
| 型号： | M30240M5-XXXFP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| 封装： | 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件页数： | 79/139页 |
| 文件大小： | 1453K |
| 代理商： | M30240M5-XXXFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页当前第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页
44
Mitsubishi microcomputers
M30240 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Specifications REV. G
Specifications in this manual are tentative and subject to change
Universal Serial Bus
1.2.18.2.4 USB SOF Interrupt
The USB SOF (Start-Of-Frame) Interrupt is used to control the transfer of isochronous data. The USB FCU
generates a USB SOF Interrupt request when a start-of-frame packet is received.
Register SOFIC contains the USB SOF Interrupt’s request bit and its interrupt priority select bits, which are
used to enable the interrupt and set its software priority level.
1.2.18.3 USB Endpoint FIFOs
The USB FCU has an IN (transmit) FIFO and an OUT (receive) FIFO for each endpoint. Each endpoint (except
endpoint 0) can be configured to support either single packet mode (in which only a single data packet is al-
lowed to reside in the endpoint’s FIFO) or dual packet mode (in which up to two data packets are allowed to
reside in the endpoint’s FIFO). Dual packet mode provides support for back-to-back transmission or back-to-
back reception. The mode is automatically determined by the MAXP value. When MAXP > 1/2 of the end-
point’s FIFO size, single packet mode is set. When MAXP <= 1/2 of the endpoint’s FIFO size, dual packet
mode is set.
In the event of a bad transmission/reception, the USB FCU handles all the FIFO read/write pointer reversal
and data set management tasks required.
Throughout this specification, the terms “IN FIFO” and “OUT FIFO” usually refer to the FIFOs associated with
a specific endpoint.
1.2.18.3.1 IN (Transmit) FIFOs
The CPU/DMA writes data to the endpoint’s IN FIFO location specified by the FIFO write pointer, which auto-
matically increments by “1” after a write. The CPU/DMA should only write data to the IN FIFO when the
IN_PKT_RDY bit of the associated IN CSR is a “0”.
Endpoint 0 IN FIFO Operation:
The CPU writes a “1” to the IN_PKT_RDY bit of Endpoint 0 CSR after it finishes writing a packet of data to the
IN FIFO. The USB FCU clears the IN_PKT_RDY bit after the packet has been successfully transmitted to the
host (i.e., ACK is received from the host) or the SETUP_END flag of the Endpoint O CSR is set to a “1”.
Endpoint 1-4 IN FIFO Operation when AUTO_SET (bit 7 of Endpoint x IN CSR) = “0” (disabled):
MAXP > 1/2 of the IN FIFO size: The CPU writes a “1” to the IN_PKT_RDY bit of the associated IN CSR after
the CPU/DMAC finishes writing a packet of data to the IN FIFO. The USB FCU clears the IN_PKT_RDY bit
after the packet has been successfully transmitted to the host (which is assumed for isochronous transfers
and is concluded when an ACK is received from the host for non-isochronous transfers).
MAXP <= 1/2 of the IN FIFO size: The CPU writes a “1” to the IN_PKT_RDY bit of the associated IN CSR after
the CPU/DMAC finishes writing a packet of data to the IN FIFO. The USB FCU clears the IN_PKT_RDY bit
as soon as the IN FIFO is ready to accept another data packet. (The FIFO can hold up to two data packets at
the same time in this configuration for back-to-back transmission.)
Endpoint 1-4 IN FIFO Operation when AUTO_SET (bit 7 of Endpoint x IN CSR) = “1” (enabled):
MAXP > 1/2 of the IN FIFO size: When the number of bytes of data equal to the MAXP (maximum packet size)
has been written to the IN FIFO by the CPU/DMAC, the USB FCU sets the IN_PKT_RDY bit of the associated
IN CSR to a “1” automatically. The USB FCU clears the IN_PKT_RDY bit after the packet has been success-
fully transmitted to the host (which is assumed for isochronous transfers and is concluded when an ACK is
received from the host for non-isochronous transfers).
MAXP <= 1/2 of the IN FIFO size: When the number of bytes of data equal to the MAXP (maximum packet
size) has been written to the IN FIFO by the CPU/DMAC, the USB FCU sets the IN_PKT_RDY bit to a “1”
automatically. The USB FCU clears the IN_PKT_RDY bit as soon as the IN FIFO is ready to accept another
data packet. (The FIFO can hold up to two data packets at the same time in this configuration for back-to-back
transmission.)
A software or a hardware flush causes the USB FCU to act as if a packet has been successfully transmitted
out to the host. When there is one packet in the IN FIFO, a flush causes the IN FIFO to be empty. When there
are two packets in the IN FIFO, a flush causes the older packet to be flushed out from the IN FIFO. A flush
also updates the IN FIFO status bits IN_PKT_RDY and TX_NOT_EPT of the associated IN CSR.
相关PDF资料 |
PDF描述 |
|---|---|
| M30240M6-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M5-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M6-XXXXFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M30240M6 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M6-XXXFP | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7-XXXFP | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M8 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
发布紧急采购，3分钟左右您将得到回复。