- 您现在的位置：买卖IC网 > PDF目录69009 > M30240M5-XXXFP 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 PDF资料下载
参数资料
| 型号： | M30240M5-XXXFP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| 封装： | 0.80 MM PITCH, PLASTIC, QFP-80 |
| 文件页数： | 80/139页 |
| 文件大小： | 1453K |
| 代理商： | M30240M5-XXXFP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页当前第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页
45
Mitsubishi microcomputers
M30240 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Specifications REV. G
Specifications in this manual are tentative and subject to change
Universal Serial Bus
The status of endpoint 1-4 IN FIFOs for both of the above cases can be obtained from the IN CSR of the cor-
responding IN FIFO as shown in Table 1.14 .
1.2.18.3.2 Out (Receive) FIFOs
The USB FCU writes data to the endpoint’s OUT FIFO location specified by the FIFO write pointer, which au-
tomatically increments by one after a write. When the USB FCU has successfully received a data packet, it
sets the OUT_PKT_RDY bit of the corresponding OUT CSR to a “1”. The CPU/DMAC should only read data
from the OUT FIFO when the OUT_PKT_RDY bit of the OUT CSR is a “1”.
Endpoint 0 OUT FIFO Operation:
The USB FCU sets the OUT_PKT_RDY bit to a “1” after it has successfully received a packet of data from the
host. The CPU sets bit SERVICED_OUT_PKT_RDY to a “1” to clear the OUT_PKT_RDY bit after the packet
of data has been unloaded from the OUT FIFO by the CPU.
Endpoint 1-4 OUT FIFO Operation when AUTO_CLR (bit 7 of Endpoint x OUT CSR) = “0” (disabled):
MAXP > 1/2 of the OUT FIFO size: The USB FCU sets the OUT_PKT_RDY bit of the associated IN CSR to
a “1” after it has successfully received a packet of data from the host. The CPU writes a “0” to the
OUT_PKT_RDY bit after the packet of data has been unloaded from the OUT FIFO by the CPU/DMAC.
MAXP <= 1/2 of the OUT FIFO size: The USB FCU sets the OUT_PKT_RDY bit of the associated IN CSR to
a “1” after it has successfully received a packet of data from the host. The CPU writes a “0” to the
OUT_PKT_RDY bit after the packet of data has been unloaded from the OUT FIFO by the CPU/DMAC. If an-
other packet is in the OUT FIFO, the OUT_PKT_RDY bit will be set to a “1” again almost immediately (such
that it may appear that the OUT_PKT_RDY bit remains a “1”). In this configuration, the FIFO can store up to
two data packets at the same time for back-to-back reception.
Endpoint 1-4 OUT FIFO Operation when AUTO_CLR (bit 7 of Endpoint x OUT CSR) = “1” (enabled):
MAXP > 1/2 of the OUT FIFO size: The USB FCU sets the OUT_PKT_RDY bit of the associated IN CSR to
a “1” after it has successfully received a packet of data from the host. The USB FCU clears the
OUT_PKT_RDY bit to a “0” automatically when the number of bytes of data equal to the MAXP (maximum
packet size) has been unloaded from the OUT FIFO by the CPU/DMAC.
MAXP <= 1/2 of the OUT FIFO size: The USB FCU sets the OUT_PKT_RDY bit of the associated IN CSR to
a “1” after it has successfully received a packet of data from the host. The USB FCU clears the
OUT_PKT_RDY bit to a “0” automatically when the number of bytes of data equal to the MAXP (maximum
packet size) has been unloaded from the OUT FIFO by the CPU/DMAC. If another packet is in the OUT FIFO,
the OUT_PKT_RDY bit will be set to a “1” again almost immediately (such that it may appear that the
OUT_PKT_RDY bit remains a “1”). In this configuration, the FIFO can store up to two data packets at the same
time for back-to-back reception.
A software flush causes the USB FCU to act as if a packet has been unloaded from the OUT FIFO. If there is
one packet in the OUT FIFO, a flush will cause the OUT FIFO to be empty. If there are two packets in the OUT
FIFO, a flush will cause the older packet to be flushed out from the OUT FIFO.
Table 1.14:
TA FIFO Status
IN_PKT_RDY
TX_NOT_EPT
IN FIFO Status
00
No data packet in IN FIFO
01
One data packet in IN FIFO if MAXP <= 1/2 of the FIFO size./
Invalid when MAXP>1/2 of the FIFO size
10
Invalid
11
Two data packets in IN FIFO when MAXP <=1/2 of the FIFO size
One data packet in IN FIFO when MAXP > 1/2 of the FIFO size
相关PDF资料 |
PDF描述 |
|---|---|
| M30240M6-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M5-XXXXFP | 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80 |
| M30240M6-XXXXFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
| M30240ECFP | 16-BIT, OTPROM, MICROCONTROLLER, PQFP80 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M30240M6 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M6-XXXFP | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M7-XXXFP | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30240M8 | 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
发布紧急采购，3分钟左右您将得到回复。