参数资料
型号: PADS1298CZXGT
厂商: TEXAS INSTRUMENTS INC
元件分类: 模拟信号调理
英文描述: SPECIALTY ANALOG CIRCUIT, PBGA64
封装: 8 X 8 MM, LEAD FREE, PLASTIC, NFBGA-64
文件页数: 10/73页
文件大小: 957K
代理商: PADS1298CZXGT
PRODUCTPREVIEW
Temperature( C)=
°
TemperatureReading( V)
145,300 V
m
-
m
490 V/ C
m
°
+25 C
°
2x
1x
8x
AVDD
AVSS
TemperatureSensorMonitor
ToMUXTempP
ToMUXTempN
SBAS459C – JANUARY 2010 – REVISED MARCH 2010
www.ti.com
Device Noise Measurements
Setting CHnSET[2:0] = 001 sets the common-mode voltage of (AVDD + AVSS)/2 to both inputs of the channel.
This setting can be used to test the inherent noise of the device in the user system.
Test Signals (TestP and TestN)
Setting CHnSET[2:0] = 101 provides internally-generated test signals for use in sub-system verification at
power-up. This functionality allows the entire signal chain to be tested out. Although the test signals are similar to
the CAL signals described in the IEC60601-2-51 specification, this feature is not intended for use in compliance
testing.
Control of the test signals is accomplished through register settings (see the CONFIG2: Configuration Register 2
subsection in the Register Map section for details). TEST_AMP controls the signal amplitude and TEST_FREQ
controls switching at the required frequency.
The test signals are multiplexed and transmitted out of the device at the TESTP_PACE_OUT1 and
TESTN_PACE_OUT2 pins. A bit register, INT_TEST = 0, deactivates the internal test signals so that the test
signal can be driven externally. This feature allows the calibration of multiple devices with the same signal. The
test signal feature cannot be used in conjunction with the external hardware pace feature (see the External
Hardware Approach subsection of the ECG-Specific Functions section for details).
Auxiliary Differential Input (TESTP_PACE_OUT1, TESTN_PACE_OUT2)
When hardware pace detect is not used, the TESTP_PACE_OUT1 and TESPN_PACE_OUT2 signals can be
used as a multiplexed differential input channel. These inputs can be multiplexed to any of the eight channels.
The performance of the differential input signal fed through these pins is identical to the normal channel
performance.
Temperature Sensor (TempP, TempN)
The ADS1294/6/8 contain an on-chip temperature sensor. This sensor uses two internal diodes with one diode
having a current density 16x that of the other, as shown in Figure 11. The difference in current densities of the
diodes yields a difference in voltage that is proportional to absolute temperature.
As a result of the low thermal resistance of the package to the printed circuit board (PCB), the internal device
temperature tracks the PCB temperature closely. Note that self-heating of the ADS1294/6/8 causes a higher
reading than the temperature of the surrounding PCB.
The scale factor of Equation 1 converts the temperature reading to °C. Before using this equation, the
temperature reading code must first be scaled to mV.
(1)
Figure 11. Measurement of the Temperature Sensor in the Input
18
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): ADS1294 ADS1296 ADS1298
相关PDF资料
PDF描述
PBY160808T-110Y-S 1 FUNCTIONS, 4 A, FERRITE CHIP
PBY160808T-250Y-S 1 FUNCTIONS, 3 A, FERRITE CHIP
PBY201209T-110Y-S 1 FUNCTIONS, 6 A, FERRITE CHIP
PBY201209T-600Y-S 1 FUNCTIONS, 3 A, FERRITE CHIP
PBY201209T-800Y-S 1 FUNCTIONS, 3 A, FERRITE CHIP
相关代理商/技术参数
参数描述
PADS1298IPAG 制造商:TI 制造商全称:Texas Instruments 功能描述:Low-Power, 8-Channel, 24-Bit Analog Front-End for Biopotential Measurements
PADS5296RGCR 制造商:Texas Instruments 功能描述:
PADS5546IRGZT 制造商:TI 制造商全称:Texas Instruments 功能描述:14-BIT, 190 MSPS ADC WITH DDR LVDS/CMOS OUTPUTS
PADS8361IRHB 制造商:Texas Instruments 功能描述:
PADS8422IBPFBT 制造商:Rochester Electronics LLC 功能描述:- Bulk