- 您现在的位置：买卖IC网 > PDF目录261241 > IBM25EMPPC750EBUF2000 32-BIT, 200 MHz, RISC PROCESSOR, CBGA360 PDF资料下载
参数资料
| 型号： | IBM25EMPPC750EBUF2000 |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 200 MHz, RISC PROCESSOR, CBGA360 |
| 封装： | 25 X 25 MM, 1.27 MM PITCH, CERAMIC, BGA-360 |
| 文件页数： | 29/43页 |
| 文件大小： | 431K |
| 代理商： | IBM25EMPPC750EBUF2000 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
Preliminary and subject to change without notice
PPC740 and PPC750 Hardware Specifications
35 of 43
7.6 Pull-up Resistor Requirements
The PPC740 and PPC750 require high -resistive (weak: 10 K
) pull-up resistors on sev-
eral control signals of the bus interface to maintain the control signals in the negated
state after they have been actively negated and released by the PPC740 and PPC750 or
other bus masters. These signals are -- TS, ABB, DBB, and ARTRY.
In addition, the PPC750 has one open-drain style output that requires a pull-up resis-
tor (weak or stronger: 4.7 K
-1-K) if it is used by the system. This signal is --
CKSTP_OUT.
During inactive periods on the bus, the address and transfer attributes on the bus are
not driven by any master and may oat in the high-impedance state for relatively long
periods of time. Since the PPC740 and PPC750 must continually monitor these signals
for snooping, this oat condition may cause excessive power draw by the input receiv-
ers on the processor or by other receivers in the system. It is recommended that these
signals be pulled up through weak (10 K
) pull-up resistors or restored in some man-
ner by the system, The snooped address and transfer attribute inputs are -- A[0-31],
AP[0-3], TT[0-4], TBST, and GBL.
The data bus input receivers are normally turned off when no read operation is in
progress and do not require pull-up resistors on the data bus. Other data bus receivers
in the system, however, may require pull-ups, or that those signals be otherwise driven
by the system during inactive periods. The data bus signals are -- DH[0-31], DL[0-31],
and DP[0-7].
If address or data parity is not used by the system, and the respective parity checking
is disabled through HID0, the input receivers for those pins are disabled, and those
pins do not require pull-up resistors and should be left unconnected by the system. If
all parity generation is disabled through HID0, than all parity checking should also be
disabled through HID0, and all parity pins may be left unconnected by the system.
No pull-up resistors are normally required for the L2 interface.
7.7 Thermal Management Information
This section provides thermal management information for the CBGA package for air
cooled applications. Proper thermal control design is primarily dependent upon the
system-level design; that is, the heat sink, air ow and the thermal interface material.
To reduce the die-junction temperature, heat sinks may be attached to the package by
several methods -- adhesive, spring clip to holes in the printed-circuit board or pack-
age, and mounting clip and screw assembly; see Figure 19 . This spring force should
not exceed 5.5 pounds.
相关PDF资料 |
PDF描述 |
|---|---|
| ICS2494AM-XXX | 135 MHz, VIDEO CLOCK GENERATOR, PDSO20 |
| ICS650R-14IT | 133.33 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| ICS650R-14T | 133.33 MHz, OTHER CLOCK GENERATOR, PDSO20 |
| ICS840001AKI-34LF | 213.33 MHz, OTHER CLOCK GENERATOR, QCC16 |
| I2041AG-8TR | 40.4 MHz, OTHER CLOCK GENERATOR, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IBM25EMPPC750LEBA300 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
| IBM25EMPPC750LEBA333 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
| IBM25EMPPC750LEBA366 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
| IBM25EMPPC750LEBA400 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
| IBM25EMPPC750LEBA466 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
发布紧急采购，3分钟左右您将得到回复。