参数资料
型号: ICS1893AFLFT
厂商: IDT, Integrated Device Technology Inc
文件页数: 125/136页
文件大小: 0K
描述: PHYCEIVER LOW PWR 3.3V 48-SSOP
标准包装: 1,000
系列: PHYceiver™
类型: PHY 收发器
规程: MII
电源电压: 3.14 V ~ 3.47 V
安装类型: 表面贴装
封装/外壳: 48-BSSOP(0.295",7.50mm 宽)
供应商设备封装: 48-SSOP
包装: 带卷 (TR)
其它名称: 1893AFLFT
Chapter 8
Management Register Set
ICS1893AF, Rev. D 10/26/04
October, 2004
89
ICS1893AF Data Sheet - Release
Copyright 2004, Integrated Circuit Systems, Inc.
All rights reserved.
8.12.3
Auto-Negotiation Progress Monitor (bits 17.13:11)
The Auto-Negotiation Progress Monitor consists of the Auto-Negotiation Complete bit (bit 17.4) and the
three Auto-Negotiation Monitor bits (bits 17.13:11). The Auto-Negotiation Progress Monitor continually
examines the state of the Auto-Negotiation Process State Machine and reports the status of
Auto-Negotiation using the three Auto-Negotiation Monitor bits. Therefore, the value of these three bits
provides the status of the Auto-Negotiation Process.
These three bits are initialized to logic zero in one of the following ways:
If Auto-Negotiation is enabled, these bits continually latch the highest state that the Auto-Negotiation State
Machine achieves. That is, they are updated only if the binary value of the next state is greater than the
binary value of the present state as outlined in Table 8-19.
Note:
An MDIO read of these bits provides a history of the greatest progress achieved by the
auto-negotiation process. In addition, the MDIO read latches the present state of the
Auto-Negotiation State Machine for a subsequent read.
8.12.4
100Base-TX Receive Signal Lost (bit 17.10)
The 100Base-TX Receive Signal Lost bit indicates to an STA whether the ICS1893AF has lost its
100Base-TX Receive Signal. If this bit is set to a logic:
Zero, it indicates the Receive Signal has remained valid since either the last read or reset of this register.
One, it indicates the Receive Signal was lost since either the last read or reset of this register.
This bit is a latching high bit. (For more information on latching high and latching low bits, see Section
Note:
This bit has no definition in 10Base-T mode.
Table 8-19.
Auto-Negotiation State Machine (Progress Monitor)
Auto-Negotiation State Machine
Auto-Negotiation Progress Monitor
Auto-
Negotiation
Complete Bit
(Bit 17.4)
Auto-
Negotiation
Monitor Bit 2
(Bit 17.13)
Auto-
Negotiation
Monitor Bit 1
(Bit 17.12)
Auto-
Negotiation
Monitor Bit 0
(Bit 17.11)
Idle
0000
Parallel Detected
0001
Parallel Detection Failure
0010
Ability Matched
0011
Acknowledge Match Failure
0100
Acknowledge Matched
0101
Consistency Match Failure
0110
Consistency Matched
0111
Auto-Negotiation Completed
Successfully
1000
相关PDF资料
PDF描述
IDT723641L20PF8 IC FIFO SYNC 1024X36 120-TQFP
IDT723631L20PQF IC FIFO SYNC 512X36 132-PQFP
ICS1893BFLFT PHYCEIVER LOW PWR 3.3V 48-SSOP
IDT723631L20PF IC FIFO SYNC 512X36 120-TQFP
VE-26F-IW-F2 CONVERTER MOD DC/DC 72V 100W
相关代理商/技术参数
参数描述
ICS1893AFT 功能描述:PHYCEIVER LOW PWR 3.3V 48-SSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:PHYceiver™ 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
ICS1893AG 制造商:ICS 制造商全称:ICS 功能描述:3.3 V 10Base-T/100Base-TX Integrated PHYceiver-TM
ICS1893AGI 制造商:ICS 制造商全称:ICS 功能描述:3.3 V 10Base-T/100Base-TX Integrated PHYceiver-TM
ICS1893AGILF 制造商:ICS 制造商全称:ICS 功能描述:3.3 V 10Base-T/100Base-TX Integrated PHYceiver-TM
ICS1893AGLF 制造商:ICS 制造商全称:ICS 功能描述:3.3 V 10Base-T/100Base-TX Integrated PHYceiver-TM