- 您现在的位置：买卖IC网 > PDF目录224506 > MT46V32M81AZ4-6T:G 32M X 4 DDR DRAM, 0.75 ns, PDSO66 PDF资料下载
参数资料
| 型号： | MT46V32M81AZ4-6T:G |
| 元件分类： | DRAM |
| 英文描述： | 32M X 4 DDR DRAM, 0.75 ns, PDSO66 |
| 封装： | 0.400 INCH, PLASTIC, TSOP-66 |
| 文件页数： | 35/82页 |
| 文件大小： | 2866K |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页当前第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页
128Mb: x4, x8, x16
DDR SDRAM
09005aef8074a655
Micron Technology, Inc., reserves the right to change products or specifications without notice.
128MBDDRx4x8x16_2.fm - Rev. J 7/04 EN
40
2000 Micron Technology, Inc. All rights reserved.
PRECHARGE
The PRECHARGE command as shown in Figure 31,
is used to deactivate the open row in a particular bank
or the open row in all banks. The bank(s) will be avail-
able for a subsequent row access some specified time
(tRP) after the PRECHARGE command is issued. Input
A10 determines whether one or all banks are to be pre-
charged, and in the case where only one bank is to be
precharged, inputs BA0, BA1 select the bank. When all
banks are to be precharged, inputs BA0, BA1 are
treated as “Don’t Care.” Once a bank has been pre-
charged, it is in the idle state and must be activated
prior to any READ or WRITE commands being issued
to that bank.
Figure 31: PRECHARGE Command
Power-down (CKE Not Active)
Unlike SDR SDRAMs, DDR SDRAMs require CKE to
be active at all times an access is in progress, from the
issuing of a READ or WRITE command until comple-
tion of the access. Thus a clock suspend is not sup-
ported. For READs, an access completion is defined
when the Read Postamble is satisfied; for WRITEs, an
access completion is defined when the Write Recovery
time (tWR) is satisfied.
Power-down as shown in Figure 32 on page 41, is
entered when CKE is registered LOW and all Table 8
(page 41)criteria are met. If power-down occurs when
all banks are idle, this mode is referred to as precharge
power-down; if power-down occurs when there is a
row active in any bank, this mode is referred to as
active power-down. Entering power-down deactivates
the input and output buffers, excluding CK, CK#, and
CKE. For maximum power savings, the DLL is frozen
during precharge power-down mode. Exiting power-
down requires the device to be at the same voltage and
frequency as when it entered power-down. However,
power-down duration is limited by the refresh require-
ments of the device (tREFC).
While in power-down, CKE LOW and a stable clock
signal must be maintained at the inputs of the DDR
SDRAM, while all other input signals are “Don’t Care.”
The power-down state is synchronously exited when
CKE is registered HIGH (in conjunction with a NOP or
DESELECT command). A valid executable command
may be applied one clock cycle later.
CS#
WE#
CAS#
RAS#
CKE
A10
BA0,1
HIGH
ALL BANKS
ONE BANK
BA
A0–A9, A11
CK
CK#
BA = Bank Address (if A10 is LOW;
otherwise “Don’t Care”)
DON’T CARE
相关PDF资料 |
PDF描述 |
|---|---|
| MT47H128M8HV-187ELIT:E | 128M X 8 DDR DRAM, 0.35 ns, PBGA60 |
| MT47H128M8HQ-187ELAT:E | 128M X 8 DDR DRAM, 0.35 ns, PBGA60 |
| MT48LC2M32B1TG-7 | 2M X 32 SYNCHRONOUS DRAM, 5.5 ns, PDSO86 |
| MT48LC32M4A2P-7ELIT:G | 32M X 4 SYNCHRONOUS DRAM, 5.4 ns, PDSO54 |
| MT55L256L18FT-12TR | 256K X 18 ZBT SRAM, 9 ns, PQFP100 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MT46V32M82ZZ5-75 ES | 制造商:Micron Technology Inc 功能描述:32MX8 SDRAM DDR PLASTIC PBF FBGA 2.5V - Trays |
| MT46V32M82ZZ5-75EZ | 制造商:Micron Technology Inc 功能描述:32MX8 DDR SDRAM PLASTIC 2.5V - Trays |
发布紧急采购，3分钟左右您将得到回复。