参数资料
型号: SFCF8192H4BK4SA-I-QT-553-SMA
厂商: Swissbit NA Inc
文件页数: 38/99页
文件大小: 0K
描述: FLASH SLC UDMA/MDMA/PIO 8G
视频文件: Swissbit Manufacturing Overview
RoHS指令信息: Environment Protection Declaration
标准包装: 20
系列: C-300
存储容量: 8GB
存储器类型: CompactFlash?
其它名称: 1052-1012
j)
k)
l)
m)
n)
o)
p)
If the host has not placed the result of its CRC calculation on D[15:00] since first driving D[15:00] during
(9), the host shall place the result of its CRC calculation on D[15:00] (see 6.5.4.5 ).
The host shall negate – DMACK no sooner than t MLI after the device has asserted DSTROBE and negated
DMARQ and the host has asserted STOP and negated – HDMARDY, and no sooner than t DVS after the host
places the result of its CRC calculation on D[15:00].
The device shall latch the host’s CRC data from D[15:00] on the negating edge of – DMACK.
The device shall compare the CRC data received from the host with the results of its own CRC calculation. If
a miscompare error occurs during one or more Ultra DMA burst for any one command, at the end of the
command, the device shall report the first error that occurred (see 6.5.4.5 ).
The device shall release DSTROBE within t IORDYZ after the host negates – DMACK.
The host shall neither negate STOP nor assert – HDMARDY until at least t ACK after the host has negated –
DMACK.
The host shall not assert – IORD, -CS0, -CS1, DA2, DA1, or DA0 until at least t ACK after negating DMACK.
Figure 14: Ultra DMA Data-In Burst Host Termination Timing
Notes: The definitions for the STOP, HDMARDY, and DSTROBE signal lines are no longer in effect after
DMARQ and DMACK are negated.
6.5.4.4.6 Initiating an Ultra DMA Data-Out Burst
An Ultra DMA Data-out burst is initiated by following the steps lettered below. The timing diagram
is shown in Figure 15: Ultra DMA Data-Out Burst Initiation Timing. The timing parameters are
specified in Table 26: Ultra DMA Data Burst Timing Requirements and are described in Table 27: Ultra DMA Data
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
a) The host shall keep – DMACK in the negated state before an Ultra DMA burst is initiated.
b) The device shall assert DMARQ to initiate an Ultra DMA burst.
c)
Steps I, (d), and (e) may occur in any order or at the same time. The host shall assert STOP.
d) The host shall assert HSTROBE.
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.51
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-300_data_sheet_CF-HxBK_Rev151.doc
Page 38 of 99
相关PDF资料
PDF描述
TSL245R-LF IC LIGHT TO FREQUENCY CONV 3PIN
TSL235R-LF IC LIGHT TO FREQUENCY CONV 3PIN
SFCF4096H1BO2TO-I-D1-523-SMA FLASH SLC UDMA/MDMA/PIO 4G
MLBAWT-A1-0000-0000DZ LED XLAMP ML-B WHITE SMD
MLBAWT-A1-0000-0000DV LED XLAMP ML-B WHITE SMD
相关代理商/技术参数
参数描述
SFC-FUSE-CAB 功能描述:熔丝座配件 SFC-FUSE-CAB RoHS:否 制造商:Schurter 产品:Caps 类型:Slot Knob 用于:FEU, FEU (Med), FAU, FAC
SFC-HC 制造商:PANASONIC ELECTRIC WORKS ACSD 功能描述:Handy Controller For SF4C Series Only 制造商:PANASONIC ELECTRIC WORKS - ACSD 功能描述:HANDY CONTROLLER FOR SF4C
SFCIC5000102MX1 功能描述:电磁干扰直通滤波器 500V .001uF X7R 20% C Filter RoHS:否 制造商:Tusonix 电容:0.027 uF 电压额定值:50 V 电路类型: 最大直流电流: 最大直流电阻: 工作温度范围:- 55 C to + 125 C 系列:4403 螺纹大小:4-40 UNC-2A
SFCIC5000103MX1 功能描述:电磁干扰直通滤波器 500V .01uF X7R C FILTER W/NUTS RoHS:否 制造商:Tusonix 电容:0.027 uF 电压额定值:50 V 电路类型: 最大直流电流: 最大直流电阻: 工作温度范围:- 55 C to + 125 C 系列:4403 螺纹大小:4-40 UNC-2A
SFCIC5000220ZC1 功能描述:电磁干扰直通滤波器 500V 22pF C0G C FILTER W/NUTS RoHS:否 制造商:Tusonix 电容:0.027 uF 电压额定值:50 V 电路类型: 最大直流电流: 最大直流电阻: 工作温度范围:- 55 C to + 125 C 系列:4403 螺纹大小:4-40 UNC-2A