- 您现在的位置：买卖IC网 > PDF目录300164 > ZL50114GAG (XILINX INC) SPECIALTY TELECOM CIRCUIT, PBGA552 PDF资料下载
参数资料
| 型号： | ZL50114GAG |
| 厂商： | XILINX INC |
| 元件分类： | 通信及网络 |
| 英文描述： | SPECIALTY TELECOM CIRCUIT, PBGA552 |
| 封装： | 35 X 35 MM, 1.27 MM PITCH, PLASTIC, MS-034, BGA-552 |
| 文件页数： | 75/113页 |
| 文件大小： | 2004K |
| 代理商： | ZL50114GAG |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页当前第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页
ZL50110/11/12/14
Data Sheet
64
Zarlink Semiconductor Inc.
Note: To change the packet size of a context, first close the context and then re-open the context with a new packet
size.
5.5
Protocol Engine
In general, the next processing block for TDM packets is the Protocol Engine. This handles the data-plane
requirements of the main higher level protocols (layers 4 and 5) expected to be used in typical applications of the
ZL50110/11/12/14 family: UDP, RTP, L2TP, CESoPSN and SAToP. The Protocol Engine can add a header to the
datagram containing up to 24 bytes. This header is largely static information, and is programmed directly by the
CPU. It may contain a number of dynamic fields, including a length field, checksum, sequence number and a
timestamp. The location, and in some cases the length of these fields is also programmable, allowing the various
protocols to be placed at variable locations within the header.
5.6
Packet Transmission
Packets ready for transmission are queued to the switch fabric interface by the Queue Manager. Four classes of
service are provided, allowing some packet streams to be prioritized over others. On transmission, the Packet
Transmit block appends a programmable header, which has been set up in advance by the control processor.
Typically this contains the data-link and network layer headers (layers 2 and 3), such as Ethernet, IP (versions 4
and 6) and MPLS.
5.7
Packet Reception
Incoming data traffic on the packet interface is received by the MACs. The well-formed packets are forwarded to a
packet classifier to determine the destination. When a packet is successfully classified the destination can be the
TDM interface, the LAN interface or the host interface. TDM traffic is then further classified to determine the context
it is intended for.
Each TDM interface context has an individual queue, and the TDM re-formatting process re-creates the TDM
streams from the incoming packet streams. This queue is used as a jitter buffer, to absorb variation in packet delay
across the network. The size of the jitter buffer can be programmed in units of TDM frames (i.e., steps of 125
μs).
There is also a queue to the host interface, allowing a traffic flow to the host CPU for processing. Again the host’s
DMA controller can be used to retrieve packet data and write it out into the CPU’s own memory.
5.8
TDM Formatter
At the receiving end of the packet network, the original TDM data must be re-constructed from the packets
received. This is known as re-formatting, and follows the reverse process from the Payload Assembler. The TDM
Formatter plays out the packets in the correct sequence, directing each octet to the selected timeslot on the output
TDM interface.
When lost or late packets are detected, the TDM Formatter plays out underrun data for the same number of TDM
frames as were included in the missing packet. Underrun data can either be the last value played out on that
timeslot, or a pre-programmed value (e.g., 0xFF). If the packet subsequently turns up it is discarded. In this way, the
end-to-end latency through the system is maintained at a constant value.
Contexts in the Packet to TDM direction are placed in the UPDATE state when they are opened, pending first
packet arrival. If a packet never arrives the context will remain in the UDPATE state. ZL5011x Design Manual
section “13.1 Understanding forceDelete” describes the procedure to close receive contexts in the UPDATE state.
相关PDF资料 |
PDF描述 |
|---|---|
| ZL50232GD | DATACOM, ISDN ECHO CANCELLER, PBGA208 |
| ZL50233/GDG | DATACOM, ISDN ECHO CANCELLER, PBGA208 |
| ZL50408GDC | DATACOM, LAN SWITCHING CIRCUIT, PBGA208 |
| ZL50408GDG2 | DATACOM, LAN SWITCHING CIRCUIT, PBGA208 |
| ZL50418GKG2 | DATACOM, LAN SWITCHING CIRCUIT, PBGA553 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ZL50114GAG2 | 制造商:Microsemi Corporation 功能描述:CESOP PROCESSOR 552BGA - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC CESOP PROCESSOR 128CH 552PBGA 制造商:Microsemi Corporation 功能描述:IC CESOP PROCESSOR 128CH 552PBGA |
| ZL50115 | 制造商:ZARLINK 制造商全称:Zarlink Semiconductor Inc 功能描述:32, 64 and 128 Channel CESoP Processors |
| ZL50115GAG | 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 1K X 1K 1.8V/3.3V 324BGA - Trays 制造商:Microsemi Corporation 功能描述:IC CESOP PROCESSOR 32CH 324PBGA |
| ZL50115GAG2 | 制造商:Microsemi Corporation 功能描述:PB FREE 1 TDM + 1 ETHERNET - Trays 制造商:Microsemi Corporation 功能描述:IC CESOP PROCESSOR 32CH 324PBGA |
| ZL50116 | 制造商:ZARLINK 制造商全称:Zarlink Semiconductor Inc 功能描述:32, 64 and 128 Channel CESoP Processors |
发布紧急采购，3分钟左右您将得到回复。