参数资料
型号: GT-48001A
厂商: Galileo Technology Services, LLC
英文描述: Switched Ethernet Controller For 10BaseX(10BaseX交换式快速以太网控制器)
中文描述: 交换式以太网控制器10BaseX(10BaseX交换式快速以太网控制器)
文件页数: 6/101页
文件大小: 1235K
代理商: GT-48001A
GT-48001A Switched Ethernet Controller
12
Revision 1.6
Scan*
I
Scan: This pin together with TriState* indicate the GT-48001A mode of opera-
tion as follows:
Factory test modes are reserved and are not to be used in-system. Failure to
observe this restriction could result in damage to the device.
TriState*
I
Tri-State: This pin together with Scan* indicate the GT-48001A mode of oper-
ation as described above.
DisWD*
I
Disable Watchdog Timer: Active LOW. DisWD* controls the enabling
(HIGH) or disabling (LOW) of the Tx Watchdog Timer on all ports.
DisBufThr*
I
Buffer Threshold: Active LOW. This pin externally enables or disables the
buffer threshold. When HIGH, the buffers allocated to the ports and the PCI
are limited to the number written in the Rx Buffer Threshold Register. When
LOW, the buffers are dynamically allocated to the ports and the PCI bus (i.e.
there is no limitation on the buffers’ allocation.)
Limit4
I
Backoff Algorithm: This pin selects the number of retransmit attempts after a
collision will occur before the back-off alogorithm is restarted. When LOW, 16
retransmit attempts after a collision must occur before the back-off alogorithm
is restarted (802.3 standard). When HIGH, 4 retransmit attempts after a colli-
sion must occur before the back-off alogorithm is restarted (more aggressive.)
EnElScrub*
Enable Empty List Scrubing: For testing purposes only. Must be pulled
HIGH.
SkipInit*
I
Skip Initialization Stage: Active LOW. This pin controls the initialization
stage of the GT-48001A. When asserted, the GT-48001A skips the initializa-
tion stage (clearing the address table which is stored in the DRAM), upon the
deassertion of Rst*. This pin is typically used for testing and the default state is
to pull this pin HIGH.
S y mbol
Ty p e
D esc ri pti o n
Sc an*
Tr i S ta te *
Mode
1
Normal operation
0
1
Factory test mode (reserved)
1
0
The GT-48001A drives all out-
puts and I/O pins to high imped-
ance.
0
Factory test mode (reserved)
相关PDF资料
PDF描述
GT-48002A Switched Fast Ethernet Controller for 100BaseX(100BaseX交换式快速以太网控制器)
GT-48004A Four Port Switched Fast Ethernet Controller(四端口、交换式快速以太网控制器)
GT-48006A Low Cost Two Port 10/100Mbps Ethernet Bridge/Switch Controller(低成本、双端口10/100Mbps以太网桥式/交换式控制器)
GT-48207 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高级交换式 10+10/100 BaseX以太网控制器)
GT-48208 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高级交换式 10+10/100 BaseX以太网控制器)
相关代理商/技术参数
参数描述
GT482 制造商:CORNELL DUBILIER ELECTRONICS 功能描述:Cap Ceramic 82pF 3000V SL 5% (12 X 6mm) Radial 9.5mm 85°C
GT48212-A6-PBB1C000 制造商:Marvell 功能描述:
GT48212-A6-PBB-C000 制造商:Marvell 功能描述:12 PORT E + 2 PORT FE SWITCH (MANAGED) - Trays
GT48300-A1-BBE1C083 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE1C083
GT48300-A1-BBE-C000 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE-C000