- 您现在的位置：买卖IC网 > PDF目录67672 > GT-48001A (Galileo Technology Services, LLC) Switched Ethernet Controller For 10BaseX(10BaseX交换式快速以太网控制器) PDF资料下载
参数资料
| 型号： | GT-48001A |
| 厂商： | Galileo Technology Services, LLC |
| 英文描述： | Switched Ethernet Controller For 10BaseX(10BaseX交换式快速以太网控制器) |
| 中文描述： | 交换式以太网控制器10BaseX（10BaseX交换式快速以太网控制器） |
| 文件页数： | 65/101页 |
| 文件大小： | 1235K |
| 代理商： | GT-48001A |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页当前第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页
GT-48001A Switched Ethernet Controller
66
Revision 1.6
16.3.2 Transmit data in progress
This signal indicates the port is transmitting data.
16.3.3 Receive data in progress
This signal indicates port receive activity.
16.3.4 Collision active
This signal indicates the port collision event detected by the port.
16.3.5 Full/Half duplex
This signal indicates the port duplex: active - full duplex, inactive - half duplex.
16.3.6 Receive Buffer Full
In order for this LED to be active, Rx Buffer Threshold must be enabled (see Table 4). This signal indicates the port re-
ceive buffer status: active - the buffer exceeds it's programmed threshold, inactive otherwise.
16.3.7 Forwarding of unknown packets enabled
This signal indicates the port mode of forwarding unknown packets: active - forwarding unknown packets enabled, in-
active otherwise.
16.3.8 The port is configured as Sniffer
This signal indicates if the port mode is configured as a monitor port: active - port is a source sniffer, inactive otherwise.
16.3.9 Link Fail State
This signal indicates the port link status: active - link is down, inactive - link is up.
16.3.10 Partition State
This signal indicates the port partition status: active - port entered partition state, inactive otherwise.
16.4
LED Signals Timing Type
16.4.1 Static LED Signals
These signals are stable for relatively long time periods. The LED indication directly reflects their current value.
16.4.2 Dynamic Internal Signals:
These signals are typically active for short time periods. In order to be visible through the LED Indication Interfaces, the
GT-48001A includes a "monostable" function per each of these dynamic signals so they can be viewed on the LED in-
dication output for a period of about 200 ms.
16.4.3
Table of Internal Activities/Status Driven via the LED Interface
The following table defines a bit by bit description of the internal signals driven through the LED Indications Serial Inter-
face. The bit number (bit#) refers to the activation of LEDStb. LEDStb is active for bit# 1. RESERVED bits contents is
not defined (i.e. can be either HIGH or LOW).
相关PDF资料 |
PDF描述 |
|---|---|
| GT-48002A | Switched Fast Ethernet Controller for 100BaseX(100BaseX交换式快速以太网控制器) |
| GT-48004A | Four Port Switched Fast Ethernet Controller(四端口、交换式快速以太网控制器) |
| GT-48006A | Low Cost Two Port 10/100Mbps Ethernet Bridge/Switch Controller(低成本、双端口10/100Mbps以太网桥式/交换式控制器) |
| GT-48207 | Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高级交换式 10+10/100 BaseX以太网控制器) |
| GT-48208 | Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高级交换式 10+10/100 BaseX以太网控制器) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| GT482 | 制造商:CORNELL DUBILIER ELECTRONICS 功能描述:Cap Ceramic 82pF 3000V SL 5% (12 X 6mm) Radial 9.5mm 85°C |
| GT48212-A6-PBB1C000 | 制造商:Marvell 功能描述: |
| GT48212-A6-PBB-C000 | 制造商:Marvell 功能描述:12 PORT E + 2 PORT FE SWITCH (MANAGED) - Trays |
| GT48300-A1-BBE1C083 | 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE1C083 |
| GT48300-A1-BBE-C000 | 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE-C000 |
发布紧急采购，3分钟左右您将得到回复。