参数资料
型号: NOIH2SM1000S-HHC
厂商: ON Semiconductor
文件页数: 61/67页
文件大小: 0K
描述: IC SPACE IMAGE SENSOR 84-JLCC
标准包装: 1
系列: HAS2
象素大小: 18µm x 18µm
有源象素阵列: 1024H x 1024V
电源电压: 3.3V
类型: CMOS 成像
封装/外壳: *
供应商设备封装: *
包装: *
其它名称: CYIH1SM1000AA-HHCS
CYIH1SM1000AA-HHCS-ND
NOIH2SM1000A
GLOSSARY
conversion gain
CDS
CFA
DNL
DSNU
fill-factor
INL
IR
Lux
pixel noise
photometric units
PLS
PRNU
QE
read noise
reset
reset noise
responsivity
ROI
sense node
sensitivity
spectral response
SNR
temporal noise
A constant that converts the number of electrons collected by a pixel into the voltage swing of the pixel.
Conversion gain = q/C where q is the charge of an electron (1.602E 19 Coulomb) and C is the capacitance
of the photodiode or sense node.
Correlated double sampling. This is a method for sampling a pixel where the pixel voltage after reset is
sampled and subtracted from the voltage after exposure to light.
Color filter array. The materials deposited on top of pixels that selectively transmit color.
Differential nonlinearity (for ADCs)
Dark signal non-uniformity. This parameter characterizes the degree of non-uniformity in dark leakage
currents, which can be a major source of fixed pattern noise.
A parameter that characterizes the optically active percentage of a pixel. In theory, it is the ratio of the
actual QE of a pixel divided by the QE of a photodiode of equal area. In practice, it is never measured.
Integral nonlinearity (for ADCs)
Infrared. IR light has wavelengths in the approximate range 750 nm to 1 mm.
Photometric unit of luminance (at 550 nm, 1lux = 1 lumen/m 2 = 1/683 W/m 2 )
Variation of pixel signals within a region of interest (ROI). The ROI typically is a rectangular portion of the
pixel array and may be limited to a single color plane.
Units for light measurement that take into account human physiology.
Parasitic light sensitivity. Parasitic discharge of sampled information in pixels that have storage nodes.
Photo-response non-uniformity. This parameter characterizes the spread in response of pixels, which is a
source of FPN under illumination.
Quantum efficiency. This parameter characterizes the effectiveness of a pixel in capturing photons and
converting them into electrons. It is photon wavelength and pixel color dependent.
Noise associated with all circuitry that measures and converts the voltage on a sense node or photodiode
into an output signal.
The process by which a pixel photodiode or sense node is cleared of electrons. ”Soft” reset occurs when
the reset transistor is operated below the threshold. ”Hard” reset occurs when the reset transistor is oper-
ated above threshold.
Noise due to variation in the reset level of a pixel. In 3T pixel designs, this noise has a component (in units
of volts) proportionality constant depending on how the pixel is reset (such as hard and soft). In 4T pixel
designs, reset noise can be removed with CDS.
The standard measure of photodiode performance (regardless of whether it is in an imager or not). Units
are typically A/W and are dependent on the incident light wavelength. Note that responsivity and sensitivity
are used interchangeably in image sensor characterization literature so it is best to check the units.
Region of interest. The area within a pixel array chosen to characterize noise, signal, crosstalk, and so on.
The ROI can be the entire array or a small subsection; it can be confined to a single color plane.
In 4T pixel designs, a capacitor used to convert charge into voltage. In 3T pixel designs it is the photodi-
ode itself.
A measure of pixel performance that characterizes the rise of the photodiode or sense node signal in Volts
upon illumination with light. Units are typically V/(W/m 2 )/sec and are dependent on the incident light
wavelength. Sensitivity measurements are often taken with 550 nm incident light. At this wavelength, 1
683 lux is equal to 1 W/m 2 ; the units of sensitivity are quoted in V/lux/sec. Note that responsivity and sens-
itivity are used interchangeably in image sensor characterization literature so it is best to check the units.
The photon wavelength dependence of sensitivity or responsivity.
Signal-to-noise ratio. This number characterizes the ratio of the fundamental signal to the noise spectrum
up to half the Nyquist frequency.
Noise that varies from frame to frame. In a video stream, temporal noise is visible as twinkling pixels.
http://onsemi.com
61
相关PDF资料
PDF描述
NOII5SM1300A-QDC SENSOR IMAGE MONO CMOS 84-LCC
NOIL1SC4000A-GDC IC IMAGE SENSOR 4MP 127-PGA
NOIL1SE3000A-GDC IC IMAGE SENSOR 3MP 369-PGA
NOIL1SM0300A-WWC IC IMAGE SENSOR LUPA300 48LLC
NOIL2SC1300A-GDC IC IMAGE SENSOR LUPA1300 168PGA
相关代理商/技术参数
参数描述
NOII4SM1300A-QDC 功能描述:SENSOR IMAGE MONO CMOS 84-LCC RoHS:否 类别:传感器,转换器 >> 图像,相机 系列:- 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOII4SM1300A-QWC 功能描述:SENSOR IMAGE MONO CMOS 84-LCC RoHS:否 类别:传感器,转换器 >> 图像,相机 系列:- 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOII4SM6600A-QDC 功能描述:图像传感器和彩色传感器 IBIS4-6600 MONO LLC68 RoHS:否 制造商:Avago Technologies 类型:Color Sensors 工作电源电压:2.5 V 封装 / 箱体: 图象大小: 颜色读出:Color 最大工作温度:+ 70 C 最小工作温度:- 25 C 封装:Reel
NOII5FM1300A-QDC 功能描述:SENSOR IMAGE 1.3MP CMOS 84-LCC RoHS:否 类别:传感器,转换器 >> 图像,相机 系列:- 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0
NOII5SC1300A-QDC 功能描述:SENSOR IMAGE COLOR CMOS 84-LCC RoHS:否 类别:传感器,转换器 >> 图像,相机 系列:- 标准包装:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素阵列:768H x 488V 每秒帧数:52 电源电压:3.3V 类型:CMOS 成像 封装/外壳:48-QFP 供应商设备封装:48-QFP 包装:托盘 请注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名称:4H20954H2095-NDKAC-00401-CBC-LB-A0