参数资料
型号: OR3T307S240-DB
厂商: LATTICE SEMICONDUCTOR CORP
元件分类: FPGA
英文描述: FPGA, 196 CLBS, 48000 GATES, PQFP240
封装: PLASTIC, SQFP-240
文件页数: 153/203页
文件大小: 1368K
代理商: OR3T307S240-DB
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页当前第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页第163页第164页第165页第166页第167页第168页第169页第170页第171页第172页第173页第174页第175页第176页第177页第178页第179页第180页第181页第182页第183页第184页第185页第186页第187页第188页第189页第190页第191页第192页第193页第194页第195页第196页第197页第198页第199页第200页第201页第202页第203页
Lattice Semiconductor
53
Data Sheet
November 2006
ORCA Series 3C and 3T FPGAs
Special Function Blocks (continued)
The readback frame contains the conguration data
and the state of the internal logic. During readback, the
value of all registered PFU and PIC outputs can be
captured. The following options are allowed when
doing a capture of the PFU outputs.
1. Do not capture data (the data written to the RAMs,
usually 0, will be read back).
2. Capture data upon entering readback.
3. Capture data based upon a congurable signal
internal to the FPGA. If this signal is tied to
logic 0, capture RAMs are written continuously.
4. Capture data on either options 2 or 3 above.
The readback frame has an identical format to that of
the conguration data frame, which is discussed later
in the Conguration Data Format section. If LUT mem-
ory is not used as RAM and there is no data capture,
the readback data (not just the format) will be identical
to the conguration data for the same frame. This
eases a bitwise comparison between the conguration
and readback data. The conguration header, including
the length count eld, is not part of the readback frame.
The readback frame contains bits in locations not used
in the conguration. These locations need to be
masked out when comparing the conguration and
readback frames. The development system optionally
provides a readback bit stream to compare to readback
data from the FPGA. Also note that if any of the LUTs
are used as RAM and new data is written to them,
these bits will not have the same values as the original
conguration data frame either.
Global 3-State Control (TS_ALL)
To increase the testability of the
ORCA Series FPGAs,
the global 3-state function (TS_ALL) disables the
device. The TS_ALL signal is driven from either an
external pin or an internal signal. Before and during
conguration, the TS_ALL signal is driven by the input
pad RD_CFG. After conguration, the TS_ALL signal
can be disabled, driven from the RD_CFG input pad, or
driven by a general routing signal in the upper right cor-
ner. Before conguration, TS_ALL is active-low; after
conguration, the sense of TS_ALL can be inverted.
The following occur when TS_ALL is activated:
1. All of the user I/O output buffers are 3-stated, the
user I/O input buffers are pulled up (with the pull-
down disabled), and the input buffers are congured
with TTL input thresholds (OR3Cxx only).
2. The TDO/RD_DATA output buffer is 3-stated.
3. The RD_CFG, RESET, and PRGM input buffers remain
active with a pull-up.
4. The DONE output buffer is 3-stated, and the input
buffer is pulled up.
Internal Oscillator
The internal oscillator resides in the lower left corner of
the FPGA array. It has output clock frequencies of
1.25 MHz and 10 MHz. The internal oscillator is the
source of the internal CCLK used for conguration. It
may also be used after conguration as a general-
purpose clock signal.
Global Set/Reset (GSRN)
The GSRN logic resides in the lower right corner of the
FPGA. GSRN is an invertible, default, active-low signal
that is used to reset all of the user-accessible latches/
FFs on the device. GSRN is automatically asserted at
powerup and during conguration of the device.
The timing of the release of GSRN at the end of cong-
uration can be programmed in the start-up logic
described below. Following conguration, GSRN may
be connected to the RESET pin via dedicated routing, or
it may be connected to any signal via normal routing.
Within each PFU and PIO, individual FFs and latches
can be programmed to either be set or reset when
GSRN is asserted. A new option in Series 3 allows
individual PFUs and PIOs to turn off the GSRN signal
to its latches/FFs after conguration.
The RESET input pad has a special relationship to
GSRN. During conguration, the RESET input pad
always initiates a conguration abort, as described in
the FPGA States of Operation section. After congura-
tion, the global set/reset signal (GSRN) can either be
disabled (the default), directly connected to the RESET
input pad, or sourced by a lower-right corner signal. If
the RESET input pad is not used as a global reset after
conguration, this pad can be used as a normal input
pad.
Select
devices
have
been
discontinued.
See
Ordering
Information
section
for
product
status.
相关PDF资料
PDF描述
OR3T556PS240-DB FPGA, 324 CLBS, 80000 GATES, PQFP240
OR3T806PS240-DB FPGA, 484 CLBS, 116000 GATES, PQFP240
OR3T807PS240-DB FPGA, 484 CLBS, 116000 GATES, PQFP240
OR3T55-4BA256I FPGA, 324 CLBS, 40000 GATES, 80 MHz, PBGA256
OR3T55-4BA256 FPGA, 324 CLBS, 40000 GATES, 80 MHz, PBGA256
相关代理商/技术参数
参数描述
OR3T30-7S240I 制造商:未知厂家 制造商全称:未知厂家 功能描述:Field Programmable Gate Array (FPGA)
OR3T55 制造商:AGERE 制造商全称:AGERE 功能描述:3C and 3T Field-Programmable Gate Arrays
OR3T55-4BA256I 制造商:未知厂家 制造商全称:未知厂家 功能描述:Field Programmable Gate Array (FPGA)
OR3T55-4PS208I 制造商:未知厂家 制造商全称:未知厂家 功能描述:Field Programmable Gate Array (FPGA)
OR3T55-4PS240I 制造商:未知厂家 制造商全称:未知厂家 功能描述:Field Programmable Gate Array (FPGA)