- 您现在的位置：买卖IC网 > PDF目录199412 > TMS320C542PGE-40 (TEXAS INSTRUMENTS INC) 16-BIT, 100 MHz, OTHER DSP, PQFP144 PDF资料下载
参数资料
| 型号： | TMS320C542PGE-40 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 数字信号处理 |
| 英文描述： | 16-BIT, 100 MHz, OTHER DSP, PQFP144 |
| 封装： | PLASTIC, QFP-144 |
| 文件页数： | 36/111页 |
| 文件大小： | 1467K |
| 代理商： | TMS320C542PGE-40 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页
TMS320C54x, TMS320LC54x, TMS320VC54x
FIXED-POINT DIGITAL SIGNAL PROCESSORS
SPRS039C – FEBRUARY 1996 – REVISED DECEMBER 1999
30
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251–1443
serial ports (continued)
When auto-buffering capability is disabled (standard mode), serial port transfers are performed under software
control through interrupts. In this mode, the ABU is transparent and the word-based interrupts (WXINT and
WRINT ) provided by the serial port are sent to the CPU as transmit interrupt (XINT ) and receive interrupt
(RINT ). When auto buffering is enabled, word transfers are done directly between the serial port and the ’54x
internal memory using ABU-embedded address generators.
The ABU has its own set of circular-addressing registers with corresponding address-generation units. Memory
for the buffers resides in 2K words of the ’54x internal memory. The length and starting addresses of the buffers
are user-programmable. A buffer-empty / buffer-full interrupt can be posted to the CPU. Buffering is easily halted
by an auto-disabling capability. Auto-buffering capability can be enabled separately for transmit and receive
sections. When auto buffering is disabled, operation is similar to that of the general-purpose serial port.
The BSP allows transfer of 8-, 10-, 12-, or 16-bit data packets. In burst mode, data packets are directed by a
frame synchronization pulse for every packet. In continuous mode, the frame synchronization pulse occurs
when the data transmission is initiated and no further pulses occur. The frame and clock strobes are frequency-
and polarity-programmable. The BSP is fully static and operates at arbitrarily low clock frequencies. The
maximum operating frequency for ’54x devices up to 50 MIPs is CLKOUT. For higher-speed ’54x devices, the
maximum operating frequency is 50 MBps at 20 ns.
buffer misalignment (BMINT) interrupt (’549 only)
The BMINT interrupt is generated when a frame sync occurs and the ABU transmit or receive buffer pointer is
not at the top of the buffer address. This is useful for detecting several potential error conditions on the serial
interface, including extraneous and missed clocks and frame sync pulses. A BMINT interrupt, therefore,
indicates that one or more words may have been lost on the serial interface.
BMINT is useful for detecting buffer misalignment only when the buffer pointer(s) are initially loaded with the
top of buffer address, and a frame of data contains the same number of words as the buffer length. These are
the only conditions under which a frame sync occurring at a buffer address, other than the top of buffer, constitute
an error condition. In cases where these conditions are met, a frame sync always occurs when the buffer pointer
is at the top of buffer address, if the interface is functioning properly.
If BMINT is enabled under conditions other than those stated above, interrupts may be generated under
circumstances other than actual buffer misalignment. In these cases, BMINT should generally be masked in
the IMR register so that the processor will ignore this interrupt.
BMINT is available when operating auto-buffering mode with continuous transfers, the FIG bit cleared to 0, and
external serial clocks or frames.
The BSP0 and BSP1 BMINT bits in the IMR and IFR registers are bits 12 and 13, respectively, (bit 15 is the MSB),
and their interrupt vector locations are 070h and 074h, respectively.
相关PDF资料 |
PDF描述 |
|---|---|
| TMS320C6415TBZLZ8 | 64-BIT, 75.18 MHz, OTHER DSP, PBGA532 |
| TMS320C6713PYP150 | 32-BIT, 149.25 MHz, OTHER DSP, PQFP208 |
| TMS470R1VF346BPZQ | 32-BIT, FLASH, 48 MHz, RISC MICROCONTROLLER, PQFP100 |
| TMX320C6203CGNZ | 32-BIT, 300 MHz, OTHER DSP, PBGA352 |
| TMX320LF2403APGS | DSP CONTROLLERS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TMS320C54CST | 制造商:TI 制造商全称:Texas Instruments 功能描述:Client Side Telephony DSP |
| TMS320C54CSTGGU | 功能描述:数字信号处理器和控制器 - DSP, DSC DSP for Client-Side Telephony RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT |
| TMS320C54CSTPGE | 功能描述:数字信号处理器和控制器 - DSP, DSC DSP for Client-Side Telephony RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT |
| TMS320C54CSTZGU | 功能描述:数字信号处理器和控制器 - DSP, DSC DSP for Client-Side Telephony RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT |
| TMS320C54V90 | 制造商:TI 制造商全称:Texas Instruments 功能描述:EMBEDDED V.90 MODEM DSP |
发布紧急采购，3分钟左右您将得到回复。